Recherche

Afficher tous les résultats pour

Accueil

Personne

Marc Pastre

Cette personne a quitté l’EPFL

À propos
Confidentialité
Mentions légales

Graph Chatbot

Publications associées (37)

Page 2 sur 2

On-chip Mass Sensing at the Physical Limits of Nanoelectromechanical Systems

Maher Kayal, Marc Pastre, Christian Kauth

A tunable and self-regulating on-chip carbon nanotube based mass balance is presented for small-size and low-cost environmental and healthcare applications. Tube stretching and a phase-locked loop topology make the system widely universal and invariant to ...

Ieee2013

Inversion factor based design methodology using the EKV MOS model

Maher Kayal, Marc Pastre, Andrea Ajbl

This paper presents a hierarchical design methodology based on the inversion factor (IF) as a key design parameter and the equations of the EKV MOS Model. A structured design approach is used to allow high flexibility. The efficiency of the methodology is ...

2011

A Hall Sensor-Based Current Measurement Microsystem with Continuous Gain Calibration

Maher Kayal, Marc Pastre

A novel technique for the continuous calibration of the sensitivity of Hall sensors is presented. Using an integrated coil and a new modulation/demodulation scheme, the sensitivity is measured and its drift eliminated. The obtained thermal drift is 50 ppm/ ...

2005

A circuit-level substrate current model for smart-power ICs

Maher Kayal, Jean-Michel Sallese, François Krummenacher, Marc Pastre, Fabrizio Lo Conte

This paper presents a new modeling methodology accounting for generation and propagation of minority carriers that can be used directly in circuit-level simulators in order to estimate coupled parasitic currents. The model is based on a new compact model o ...

IEEE Service Center, 445 Hoes Lane, Po Box 1331, Piscataway, Nj 08855-1331 Usa2009

A 300Hz 19b DR capacitive accelerometer based on a versatile front end in a 5th-order ΔΣ loop

Maher Kayal, Marc Pastre

This paper presents a 5th-order ΔΣ capacitive accelerometer. The ΔΣ loop is implemented in mixed signal, the global 5th-order filter having a 2nd-order analog and a 3rd-order digital part. The system can be used with a wide range of sensors, because the mi ...

Ieee Service Center, 445 Hoes Lane, Po Box 1331, Piscataway, Nj 08855-1331 Usa2009

A fully integrated Hall sensor microsystem with current-mode output

Maher Kayal, Marc Pastre, Andrea Ajbl

This paper presents a fully integrated Hall sensor microsystem with a current-mode output. The system operates in open-loop and includes a Hall sensor with internal biasing, a fully differential front-end, a preamplifier chain and a voltage-to-current conv ...

2011

Methodology for the Digital Calibration of Analog Circuits and Systems Using Sub-binary Radix DACs

Maher Kayal, Marc Pastre

This paper presents a methodology for digitally calibrating analog circuits and systems. Based on the detection of an imperfection by a simple comparator, a successive approximations algorithm tunes a compensation current. The latter is generated by a sub- ...

Ieee Service Center, 445 Hoes Lane, Po Box 1331, Piscataway, Nj 08855-1331 Usa2009

A Fully Integrated Hall Sensor Microsystem for Contactless Current Measurement

Maher Kayal, Marc Pastre, Andrea Ajbl

Contactless current measurement based on Hall-effect sensors can be performed in either closed-or open-loop configuration. In this paper an open-loop sensor system with a current-mode output is described. The system measures the magnetic field induced arou ...

Institute of Electrical and Electronics Engineers2013

Digital calibration methodology applied to a sensor microsystem

Maher Kayal, Marc Pastre

This paper presents the application of a complete digital calibration methodology to the improvement of a Hall sensor-based current measurement microsystem. It is a step-by-step illustration of how generic calibration techniques and circuits can be used on ...

2006

Methodology for the Digital Calibration of Analog Circuits and Systems-with Case Studies

Maher Kayal, Marc Pastre

Springer2005

Simultaneous High-Speed High-Resolution Nanomechanical Mass Sensing

Maher Kayal, Marc Pastre, Christian Kauth

Mass sensing has so far rather developed along the resolution axis, reaching atomic-scale detection, than into the direction of high speed. This letter reports on a novel self-calibrating technique that makes high-speed inertial mass sensors capable of ins ...

Institute of Electrical and Electronics Engineers2014

High-efficiency dynamic supply CMOS audio power amplifier for low-power applications

Maher Kayal, Marc Pastre

This paper describes the analysis and design of a dynamic supply CMOS audio power amplifier for low-power applications. The dynamic supply technique is used to increase the efficiency of a class AB power amplifier. The polarization of its output stage is a ...

2009

Continuously gain-calibrated Hall sensor analog front-end for current measurement

Maher Kayal, Marc Pastre

2005

Analog Circuit Design

Maher Kayal, Marc Pastre, Danica Stefanovic

2005

Substrate current modeling for high-voltage smart power BCD technology

Maher Kayal, François Krummenacher, Marc Pastre, Fabrizio Lo Conte

This paper presents a compact- and a macro-model for estimating and simulating the perturbations induced in the substrate by high-voltage transistors switching inductive loads. On one hand, it allows the designer to predict the amount of switching noise ge ...

2008

PAD:A New Interactive Knowledge-Based Analog Design Approach

Maher Kayal, Marc Pastre, Danica Stefanovic

Kluwer Academic Publishers, Springer2005

Automatic calibration of Hall sensor microsystems

Maher Kayal, Marc Pastre

In many applications, a Hall element is used for contact-less measurement such as linear and angular positions, electrical current, power and energy, etc. The Hall element fabricated by means of CMOS technology features mediocre characteristics [R.S. Popov ...

2006