Publications associées à High Performance Low cost Transition Connectors for 5G mmWave Applications

Publications associées (37)

A mmWave Low Complexity and Low-Cost Super Wideband Dual-Polarized Aperture Coupled Antenna for 5G Applications

Advanced antenna system (AAS) is a viable option for 5G millimeter-wave (mmWave) applications. AAS single element is favored to be dual-polarized, wideband, high gain, and compact in order to be utilized for 5G antenna arrays. In this paper, a low complexi ...

Ieee-Inst Electrical Electronics Engineers Inc2024

Impact of beam-coupling impedance on the Schottky spectrum of bunched beam

Tatiana Pieloni, Nicolas Frank Mounet, Christophe Emmanuel R. Lannoy

The Schottky monitors of the Large Hadron Collider (LHC) can be used for non-invasive beam diagnostics to estimate various bunch characteristics, such as tune, chromaticity, bunch profile or synchrotron frequency distribution. However, collective effects, ...

Iop Publishing Ltd2024

A Two-Wired High Input Impedance and High CMRR Active Electrode Insensitive to Component Mismatch

Alexandre Schmid, Mehdi Saberi

This article proposes a new two-wired amplifying active electrode (AE), presenting a high input impedance and a high common-mode rejection ratio (CMRR). In the proposed structure, the input impedance and the CMRR of the system are considerably increased by ...

Ieee-Inst Electrical Electronics Engineers Inc2024

Enabling Wide Bandwidth in Substrate-Integrated Waveguide Slot Antennas by Using Low-Index Metamaterials

Romain Christophe Rémy Fleury, Amir Jafargholi

This paper presents a solution to overcome the inherently limited bandwidth of substrate-integrated waveguide (SIW) slot antennas. It is analytically shown that by decreasing the permittivity of a dielectric loaded slot antenna, the resulting bandwidth inc ...

American Physical Society (APS)2024

On the use of Cramér-Rao Lower Bound for least-variance circuit parameters identification of Li-ion cells

Mario Paolone, Vladimir Sovljanski

Electrochemical Impedance Spectroscopy (EIS) and Equivalent Circuit Models (ECMs) are widely used to characterize the impedance and estimate parameters of electrochemical systems such as batteries. We use a generic ECM with ten parameters grouped to model ...

2024

Design Methodology for Wideband Bowtie Patch Antenna for 5G mmWave Applications

Anja Skrivervik

Millimeter wave (mmWave) frequencies has become a research area of interest in recent years because of providing broad available bandwidth and thus higher data rates. Wideband mmWave antenna is one of the important development areas in wireless communicati ...

IEEE2023

A 1-GS/s 6-8-b Cryo-CMOS SAR ADC for Quantum Computing

Edoardo Charbon

This article presents a two-times interleaved, loop-unrolled SAR analog-to-digital converter (ADC) operational from 300 down to 4.2 K. The 6-8-bit resolution and the sampling speed up to 1 GS/s are targeted at digitizing the multi-channel frequency-multipl ...

IEEE-INST ELECTRICAL ELECTRONICS ENGINEERS INC2023

Optimal sensor placement for personal inhalation exposure detection in static and dynamic office environments

Dusan Licina, Seoyeon Yun

Modern health and productivity concerns related to air pollutant exposure in buildings have sparked the need for occupant-centric monitoring and ventilation control. The existing personal exposure monitoring is often restricted to stationary air quality se ...

PERGAMON-ELSEVIER SCIENCE LTD2023

Portable impedance-sensing device for microorganism characterization in the field

Sandro Carrara

A variety of biosensors have been proposed to quickly detect and measure the properties of individual microorganisms among heterogeneous populations, but challenges related to cost, portability, stability, sensitivity, and power consumption limit their app ...

Nature Portfolio2023

Self-Synchronized Grid Impedance Estimation Unit using Interpolated DFT Technique

Drazen Dujic, Andrea Cervone, Jules Christian Georges Macé

Estimating the impedance of a grid-connected device or of a grid at the point of common coupling is important for evaluating the interaction between them. Impedance measurement involves a perturbation injection device, that perturbs the system, and a measu ...

2023

Toward Metantennas: Metamaterial-Based Antennas for Wireless Communications

Yuanyan Su

Antennas have historically been the most common electromagnetic (EM) technology for wireless communication systems. Antenna as hardware is entirely dependent on the EM properties of the materials used, mostly related to the permittivity and permeability. I ...

Ieee-Inst Electrical Electronics Engineers Inc2023

NbN films with high kinetic inductance for high-quality compact superconducting resonators

Edoardo Charbon, Pasquale Scarlino, Fabrizio Minganti, Simone Frasca, Marco Scigliuzzo, Fabian Oppliger, Vincent Jean Yves Jouanny

Niobium nitride (NbN) is a particularly promising material for quantum technology applications, as it shows the degree of reproducibility necessary for large-scale superconducting circuits. We demonstrate that resonators based on NbN thin films present a o ...

American Physical Society (APS)2023

Ultra-Low Power Short-Range 60-GHz FMCW Radar Front-End

Sammy Cerida Rengifo

The millimeter wave (mmWave) frequency band is becoming very interesting over the past years because it provides the opportunity to operate using large bandwidths which are not available at lower frequencies. This enables new communication standards suppor ...

EPFL2023

On the Maximum Power Density of Implanted Antennas within Simplified Body Phantoms

Anja Skrivervik, Mingxiang Gao

With the application requirements of wireless technology in implantable bioelectronics, knowledge of the fundamental limits for implanted antennas becomes critical. In this work, we investigated the variation of maximum power density within simplified body ...

IEEE2022

Factors influencing the mean-time-to-failure of single-layer uniaxially prestretched silicone-based DEAs

Herbert Shea, Fabio Beco Albuquerque

We report an experimental investigation on the influence of electric field, electrode surface area, encapsulation layers and elastomer material on the mean-time-to-failure (MTTF) of single-layer uniaxially prestretched silicone-based dielectric elastomer a ...

SPIE-INT SOC OPTICAL ENGINEERING2022

Epileptic Seizure Detection With Patient-Specific Feature and Channel Selection for Low-power Applications

Alexandre Schmid, Keyvan Farhang Razi

An accurate epileptic seizure detector using intracranial electroencephalography (iEEG) recordings, suitable for low-power wearable/implantable applications, is presented. Eleven time-domain features with low hardware complexity are employed in the feature ...

IEEE-INST ELECTRICAL ELECTRONICS ENGINEERS INC2022

Torque Computation With the Isogeometric Mortar Method for the Simulation of Electric Machines

Rafael Vazquez Hernandez, Bernard Kapidani

In this work, isogeometric mortaring is used for the simulation of a six-pole permanent magnet synchronous machine. Isogeometric mortaring is especially well suited for the efficient computation of rotating electric machines, as it allows for an exact geom ...

Institute of Electrical and Electronics Engineers2022

From C/C plus plus Code to High-Performance Dataflow Circuits

Paolo Ienne, Andrea Guerrieri, Lana Josipovic

High-level synthesis (HLS) tools typically generate statically scheduled datapaths. Static scheduling implies that the resulting circuits have a hard time exploiting parallelism in code with potential memory dependences, with control dependences, or where ...

IEEE-INST ELECTRICAL ELECTRONICS ENGINEERS INC2022

Portable Multi-Frequency Impedance-Sensing Device for Bacteria Classification in a Flowing Liquid

Sandro Carrara

This paper presents a novel impedance-sensing device and its related microfluidics system developed to characterize the macroscopical properties of bacteria and microparticles. The system is based on a phase-sensitive detector with square-waves excitation ...

IEEE2022

GaAs nanowires on Si nanopillars: towards large scale, phase-engineered arrays

Anna Fontcuberta i Morral, Wonjong Kim, Jean-Baptiste Leran, Didem Dede, Nicholas Paul Morgan, Akshay Balgarkashi, Lea Ghisalberti

Large-scale patterning for vapor-liquid-solid growth of III-V nanowires is a challenge given the required feature size for patterning (45 to 60 nm holes). In fact, arrays are traditionally manufactured using electron-beam lithography,for which processing t ...

2022