Publications associées à Time evolution of surface defect states in hydrogenated amorphous silicon studied by photothermal and photocurrent spectroscopy and optical simulation

Publications associées (37)

Solar photons beyond the band gap wavelengths: their effect on solution-processed solar cells

A deep understanding of how solution-processed solar cells (SSCs) perform under varying temperatures and irradiance is crucial for their optimal design, synthesis, and use. However, current partial spectral characterization, primarily below the band gap wa ...

Royal Society of Chemistry2025

High-Efficiency Carbon Perovskite Solar Cells via Cathode Interface Engineering by using CuPc Hole-Transporting Layers

Mohammad Khaja Nazeeruddin

Carbon perovskite solar cells (C-PSCs) represent a promising photovoltaic (PV) technology that addresses the long-term operating stability needed to compete with commercial Si solar cells. However, the poor interface contacts between the carbon electrode a ...

2025

Font Side Solutions for c-Si Solar Cells with High-Temperature Passivating Contacts

Ezgi Genç

In this work, we studied the potential of using thin films deposited by plasma-enhanced chemical vapor deposition (PECVD) for two main purposes: introducing an n-type passivating contact at the front of a TOPCon solar cell, or simplifying the fabrication o ...

EPFL2024

Mobility Gaps of Hydrogenated Amorphous Silicon Related to Hydrogen Concentration and Its Influence on Electrical Performance

Nicolas Würsch, Jonathan Emanuel Thomet, Sylvain Dunand

This paper presents a comprehensive study of hydrogenated amorphous silicon (a-Si)-based detectors, utilizing electrical characterization, Raman spectroscopy, photoemission, and inverse photoemission techniques. The unique properties of a-Si have sparked i ...

2024

Stability of a liquid layer draining around a horizontal cylinder: Interplay of capillary and gravity forces

François Gallaire, Shahab Eghbali, Simeon Vladimirov Djambov

We study the drainage of a viscous liquid film coating the outside of a solid horizontal cylinder, where gravity acts vertically. We focus on the limit of large Ohnesorge numbers Oh, where inertia is negligible compared to viscous effects. We first study t ...

Amer Physical Soc2024

Accelerating Dynamic Aperture Evaluation Using Deep Neural Networks

Tatiana Pieloni, Mike Seidel, Davide Di Croce

The Dynamic Aperture is an important concept for the study of non-linear beam dynamics in a circular accelerator. The DA is defined as the extent of the phase-space region in which the particle's motion remains bounded over a finite number of turns. Such a ...

Institute of Physics2024

Variational quantum time evolution without the quantum geometric tensor

Giuseppe Carleo, Jannes Willy E. Nys, Riccardo Rossi, Julien Sebastian Gacon

Realand imaginary -time quantum state evolutions are crucial in physics and chemistry for exploring quantum dynamics, preparing ground states, and computing thermodynamic observables. On near -term devices, variational quantum time evolution is a promising ...

Amer Physical Soc2024

Influence of ionization and cumulative effects on laser-induced crystallization in multilayer dielectrics

Yves Bellouard, Victor Carle Adrien Boureau, Ruben Ricca

Crystallization of amorphous layers has been demonstrated under various radically different laser-exposure conditions, including continuous wave (cw) and pulsed lasers. Here, we investigate the specific role of ionization in the crystallization of dielectr ...

2024

Bodily implant microelectrode and bodily implant microelectrode fabrication method

Sandro Carrara, Diego Ghezzi, Gian Luca Barbruni

The present invention concerns a bodily implantable or probe device and microelectrode fabrication method comprising providing at least one silicon substrate including an electronic device or unit; providing, on a first side of the silicon substrate, at le ...

2024

Towards Quantitative Terahertz Characterisation of Zinc Phosphide Thin Films for Photovoltaic Applications

Anna Fontcuberta i Morral, Jean-Baptiste Leran, Simon Robert Escobar Steinvall, Elias Zsolt Stutz, Rajrupa Paul, Mirjana Dimitrievska, Léa Buswell

The earth-abundant and non-toxic material Zinc phosphide (Zn3P2) is a promising candidate for solar cell applications. However, growth of defect-free, high-quality thin films on substrates that can integrate with current technology (e.g. silicon) remains c ...

IEEE Computer Society2024

Characterization of a flexible a-Si:H detector for in vivo dosimetry in therapeutic x-ray beams

Nicolas Würsch, Jonathan Emanuel Thomet, Luca Massimiliano Antognini, Sylvain Dunand

BackgroundThe increasing use of complex and high dose-rate treatments in radiation therapy necessitates advanced detectors to provide accurate dosimetry. Rather than relying on pre-treatment quality assurance (QA) measurements alone, many countries are now ...

Wiley2024

Microstructural and electrical characterization of high temperature passivating contacts for silicon solar cells

Sofia Libraro

Recombination at metal/semiconductor interfaces represents the main limitation in mainstream c-Si solar cells, primarily based on the passivated emitter and rear cell (PERC) concept. Full-area passivating contacts based on SiOx/poly-Si stacks are a candida ...

EPFL2024

Modeling friction and wear using an adaptive discrete-continuum coupling

Manon Eugénie Voisin--Leprince

When two objects slide against each other, wear and friction occur at their interface. The accumulation of wear forms what is commonly referred to as a ``third-body''. Understanding third-body evolution has significant applications in industry, where contr ...

EPFL2024

Scenario optimization for the tokamak ramp-down phase in RAPTOR. Part B: safe termination of DEMO plasmas

Olivier Sauter, Federico Alberto Alfredo Felici, Emiliano Fable, Anna Teplukhina, Simon Van Mulders, Cassandre Ekta Contré

An optimized plasma current ramp-down strategy is critical for safe and fast termination of plasma discharges in a tokamak demonstration fusion reactor (DEMO), both in planned and emergency scenarios, avoiding plasma disruptions and excessive heat loads to ...

Iop Publishing Ltd2024

III-N blue-emitting epi-structures with high densities of dislocations: Fundamental mechanisms for efficiency improvement and applications

Pierre Christophe Lottigier

Since the dawn of humanity, human beings seeked to light their surroundings for their well-being, security and development. The efficiency of ancient lighting devices, e.g. oil lamps or candles, was in the order of 0.03-0.04% and jumped to 0.4-0.6% with th ...

EPFL2024

Shortwave Infrared-Sensitive, Narrowband Organic Upconversion Devices with a Gain

Wei-Hsu Hu

Sensing and imaging of light in the shortwave infrared (SWIR) range is increasingly used in various fields, including bio-imaging, remote sensing, and semiconductor process control. SWIR-sensitive organic photodetectors (OPDs) are promising because organic ...

EPFL2024

Investigation and Mitigation of Moisture- and Potential-Induced Degradation Mechanisms of Silicon Heterojunction Solar Cells and Modules

Olatz Arriaga Arruti

Photovoltaic (PV) technology is one of the most promising renewable energy sources. The PV market is dominated by crystalline silicon (c-Si) based technologies, thus ensuring their long-term performance is of paramount importance for manufacturers, investo ...

EPFL2023

Alleviating nanostructural phase impurities enhances the optoelectronic properties, device performance and stability of cesium-formamidinium metal-halide perovskites

Anaël Morgane Jaffrès, Christophe Ballif, Quentin Thomas Jeangros, Aïcha Hessler-Wyser, Christian Michael Wolff, Mostafa Rabie Shlaly Bahr Othman, Daniel Anthony Jacobs, Austin George Kuba

The technique of alloying FA+ with Cs+ is often used to promote structural stabilization of the desirable alpha-FAPbI3 phase in halide perovskite devices. However, the precise mechanisms by which these alloying approaches improve the optoelectronic quality ...

Royal Soc Chemistry2024

Stress tolerance of lightweight glass-free PV modules for vehicle integration

Kléber Nicolet-dit-Félix, Christophe Ballif, Matthieu Despeisse, Aïcha Hessler-Wyser, Jacques Levrat, Antonin Faes, Gianluca Cattaneo, Umang Bhupatrai Desai, Fahradin Mujovi

Electric vehicles (EVs) currently dominate the sales in the automotive market. A big leap in this market can be made by developing a photovoltaic product that can be integrated to an EV, as it can boost the driving range of the EV while reducing the chargi ...

Edp Sciences S A2024

A comprehensive analysis of electron emission from a-Si:H/Al2O3 at low energies

Christophe Ballif, Nicolas Würsch, Jonathan Emanuel Thomet, Janina Christine Isabelle Löffler, Samira Alexandra Frey

Recently developed microchannel plates (MCPs) based on amorphous silicon offer potential advantages with respect to glass based ones. In this context, secondary electron emission (SEE) at very low energies below 100 eV has been studied for relevant materia ...

IOP Publishing Ltd2023