Publications related to Circuit model and design of silicon-integrated CRLH-TLS analogically controlled by MEMS

Related publications (31)

On the use of Cramér-Rao Lower Bound for least-variance circuit parameters identification of Li-ion cells

Electrochemical Impedance Spectroscopy (EIS) and Equivalent Circuit Models (ECMs) are widely used to characterize the impedance and estimate parameters of electrochemical systems such as batteries. We use a generic ECM with ten parameters grouped to model ...

2024

Enabling Wide Bandwidth in Substrate-Integrated Waveguide Slot Antennas by Using Low-Index Metamaterials

Romain Christophe Rémy Fleury, Amir Jafargholi

This paper presents a solution to overcome the inherently limited bandwidth of substrate-integrated waveguide (SIW) slot antennas. It is analytically shown that by decreasing the permittivity of a dielectric loaded slot antenna, the resulting bandwidth inc ...

American Physical Society (APS)2024

Emulating Multimemristive Behavior of Silicon Nanowire-Based Biosensors by Using CMOS-Based Implementations

Kapil Bhardwaj, Sandro Carrara, Junrui Chen

The research presented in this article draws inspiration from previous efforts aimed at replicating the functions of various solid-state memristors using a variety of materials. The memristor circuit emulator serves as a cost-effective tool for circuit des ...

Ieee-Inst Electrical Electronics Engineers Inc2024

A Wide-Frequency-Tuning Micro-Loop-Gap Resonator for Miniature Rubidium Vapor-Cell Atomic Frequency Standards

Anja Skrivervik, Yuanyan Su

To miniaturize the double-resonance (DR) rubidium (Rb) vapor-cell atomic clocks, a new type of micro-loop-gap microwave resonator (mu-LGR) is proposed for TE011-like mode where the magnetic field inside the cavity is homogeneous and oriented along its long ...

Institute of Electrical and Electronics Engineers2023

Design and manufacture of edible microfluidic logic gates

Dario Floreano, Bokeon Kwak, Shuhang Zhang

Edible robotics is an emerging research field with potential use in environmental, food, and medical scenarios. In this context, the design of edible control circuits could increase the behavioral complexity of edible robots and reduce their dependence on ...

IEEE2023

Modeling and Design Optimization of Loosely Coupled PCB Spiral Coils in Inductive Power Transfer Systems

Drazen Dujic, Xiaotong Du

There are various possibilities to realize coil winding designs for an inductive power transfer system. In order to achieve high power transfer efficiency and power density and explore trade-offs between the two, design optimization around the coil link is ...

2023

High power mm-wave loss measurements of ITER ex-vessel waveguide components at the FALCON test facility at the Swiss Plasma Center

Timothy Goodman, René Chavan, Avelino Mas Sanchez, Anastasia Xydou, Cinta Lucia Marraco Borderas, Humberto Torreblanca Quiroz

Many future fusion devices will rely heavily, if not solely, on electron cyclotron (EC) heating subsystems to provide bulk heating, instability control (neoclassical tearing mode (NTM) stabilization), and thermal instability control. Efficient use of the i ...

E D P SCIENCES2023

500 MHz high resolution proximity sensors with fully integrated digital counter

Giovanni Boero, Nergiz Sahin Solmaz, Reza Farsi

We report on the design and characterization of two inductive proximity sensors based on LC oscillators operating at 500 MHz. The distance from the target is obtained by measuring the oscillation frequency variation. Both sensors contain an off-chip LC res ...

ELSEVIER SCI LTD2023

Subthreshold VO2 vertical switches for large-bandwidth millimeter-wave and sub-terahertz detection

Mihai Adrian Ionescu, Fatemeh Qaderi Rahaqi, Ali Gilani, Daesung Park

n-linear impedance characteristics of VO2 offer solutions to highly sensitive radio-frequency (RF), millimeterwave (mm-wave), and terahertz (THz) detectors. We demonstrate high-speed broadband sensibility of miniaturized VO2 switches by utilizing the nonli ...

IEEE2022

Study of the enhanced electricity output of a sliding droplet-based triboelectric nanogenerator for droplet sensor design

Wei Xu, Jürgen Brugger, Xia Liu

Triboelectric nanogenerators are establishing themselves as promising candidates for realizing high-efficient energy harvesting from largely available droplets. However, the conventional droplet-based liquid-solid triboelectric nanogenerator (DLS-TENG) has ...

Elsevier2022

On leave from

Jean-Philippe Brantut

Atomtronics is an emerging field that aims to manipulate ultracold atom moving in matter-wave circuits for fundamental studies in both quantum science and technological applications. In this Colloquium, recent progress in matter-wave circuitry and atomtron ...

AMER PHYSICAL SOC2022

A Cryo-CMOS Wideband Quadrature Receiver With Frequency Synthesizer for Scalable Multiplexed Readout of Silicon Spin Qubits

Edoardo Charbon, Andrea Ruffino, Yatao Peng

In this article, a cryo-CMOS receiver integrated with a frequency synthesizer for scalable multiplexed readout of qubits is presented, focusing on radio frequency (RF) reflectometry readout of silicon-based semiconductor spin qubits/quantum dots. The propo ...

IEEE-INST ELECTRICAL ELECTRONICS ENGINEERS INC2022

Low-Power and Wide-Tuning Range Frequency Generation for FMCW Radars in Advanced CMOS Technologies

Francesco Chicco

Nowadays, the internet of things (IoT) nodes have started to spread in various domains of our society, from the industrial to the domestic environment. The remote sensing is one among their fundamental functions. The implementation of a radio detection and ...

EPFL2021

A novel approach for SPICE modeling of light and radiation effects in ICs

Chiara Rossi

Modeling the interaction of ionizing radiation, either light or ions, in integrated circuits is essential for the development and optimization of optoelectronic devices and of radiation-tolerant circuits. Whereas for optical sensors photogenerated carriers ...

EPFL2021

Energy Analysis of a Cardiac Assist Device based on Dielectric Elastomer Actuator through an Equivalent Electrical Circuit

Yves Perriard, Yoan René Cyrille Civet, Jonathan André Jean-Marie Chavanne, Francesco Clavica

Lumped parameter model and mock circulation loop are two tools commonly used in biomedical research to simulate cardiac system in order to study different assist devices. In this paper, a lumped parameter model is proposed to simulate a circulation loop. T ...

IEEE2021

Microwave or millimeter wave passive components or devices

Romain Christophe Rémy Fleury, Maliheh Khatibi Moghaddam

A passive device comprising a hollow waveguide including first and second wall structures extending in a guiding direction, an interconnecting base extending between the wall structures and an enclosure extending between the wall structures, the enclosure ...

2021

Prototype mitre bends of the ex-vessel waveguide system for the ITER upper launcher: Thermal hydraulic simulations and experiments with off-center mm-wave beams

Timothy Goodman, René Chavan, Anastasia Xydou, Matteo Vagnoni, Humberto Torreblanca Quiroz

On ITER, long pulse gyrotrons are required as a power source for electron cyclotron heating (ECH) and current drive (CD). The microwaves are guided from the gyrotrons, which are placed far from the Tokamak, into the plasma by transmission lines (TLs) and a ...

Elsevier2021

Investigation on Output Capacitance Losses in Superjunction and GaN-on-Si Power Transistors

Elison de Nazareth Matioli, Armin Jafari, Mohammad Samizadeh Nikooytabalvandani, Palliyage Srilak Nirmana Perera, Halil Kerim Yildirim

Low ON-resistance of advanced superjunction (SJ) and GaN-on-Si transistors is of great importance in power converters, however, the anomalous loss in their output capacitance (C OSS ) severely limits their performance. In this work, we use an energy-orient ...

IEEE2021

Low Noise Clock Generation: Modeling, Analysis and Implementation

Duygu Kostak

The aim of this thesis is to implement, analyze and improve the selected low noise clock generation and distribution techniques for ADC implementations. The thesis is divided into two parts. The first part focuses on the sampling phase generation and distr ...

EPFL2021

Characterization of Microwave Substrates for High Accuracy and Long-Term Stability Using Full-Wave Microstrip Ring Resonator Method

Anja Skrivervik, Yuanyan Su, Miroslav Veljovic

An accurate material characterization method for microwave printed-circuit-board substrates is proposed by combining the microwave ring resonator method with iterative full-wave simulations. A detailed error analysis is performed quantitatively to compensa ...

IEEE2021