Publications related to Ultra-High-Voltage (7-kV) Bidirectional Flyback Converter Used to Drive Capacitive Actuators

Related publications (35)

Investigation of Dynamic RON in p-GaN Gate HEMTs under Steady-State Soft-Switching: Roles of OFF-State Trapping and Hole Injections

Elison de Nazareth Matioli, Hongkeng Zhu

Dynamic ON-resistance (RON) in GaN HEMTs is a critical issue for power electronics efficiency. This paper proposes a novel method to measure dynamic (RON) under long-term OFF-state drain-stress and steady-state soft-switching, comparing Schottky-type (GaN- ...

IEEE2025

Ripple Voltage and Loss Reduction of Single-Phase ISOP SST by Eliminating the Second Harmonic Current in LLC Converters

Drazen Dujic, Andrea Cervone, Tianyu Wei

In two-stage solid-state transformers with input-series output-parallel structure, the LLC converter operating at a fixed switching frequency is a common choice for the isolated DC/DC conversion stage because it can provide a high efficiency and a fixed vo ...

2024

Phase Shift Angle Segmentation Modulation for Soft-Switching Medium-Voltage DAB Converter With Series-Connected SiC MOSFETs

Chengmin Li

The medium-voltage (MV) dual active bridge (DAB) converter with series-connected SiC (S-SiC) MOSFETs is a promising solution for high-power-density isolated dc/dc converter. To improve the voltage sharing and reliability of S-SiC, relatively large snubber ...

Ieee-Inst Electrical Electronics Engineers Inc2024

Active Voltage Balancing with Seamless Integration into Dual Gate Driver for Series Connection of SiC MOSFETs

Drazen Dujic, Rui Wang

The versatility of half-bridge configuration of silicon carbide (SiC) metal-oxide-semiconductor field-effect transistor (MOSFET) power module contributes to its widespread adoption, highlighting the popularity and significance of its corresponding dual gat ...

2024

DC Power Distribution Networks with Direct Current Transformers

Renan Pillon Barcelos

The shift towards DC power distribution networks, enabled by power electronics technologies, is changing the nature of electrical power systems. Nowadays, DC power distribution networks can effectively support the high penetration of distributed energy res ...

EPFL2024

Static and Dynamic Voltage Balancing for an IGCT-Based Resonant DC Transformer

Drazen Dujic, Renan Pillon Barcelos, Nikolina Djekanovic

This paper focuses on the operational characteristics of a medium voltage resonant DC transformer based on a split capacitor IGCT 3L-NPC leg. The study delves into both the dynamic and static balancing aspects of the 3L-NPC when operating in a two-level, 5 ...

2024

Power Aware Placement of On-Chip Voltage Regulators

Rassul Bairamkulov

In traditional power delivery networks, the on-chip supply voltage is provided by board-level converters. Due to the significant distance between the converter and the load, variations in the load current are not effectively managed, producing a significan ...

Ieee-Inst Electrical Electronics Engineers Inc2024

An Ultralow-Power Triaxial MEMS Accelerometer With High-Voltage Biasing and Electrostatic Mismatch Compensation

Kyojin Choo

This article presents a triaxial micro electromechani-cal system (MEMS) capacitive accelerometer using a high-voltage biasing technique to achieve high resolution with ultralow power. The accelerometer system generates a differential pair of high voltages ...

Ieee-Inst Electrical Electronics Engineers Inc2024

Unified Harmonic Power-Flow and Stability Analysis of Power Grids with Converter-Interfaced Distributed Energy Resources

Johanna Kristin Maria Becker

Modern power distribution systems are experiencing a large-scale integration of Converter-Interfaced Distributed Energy Resources (CIDERs). Their presence complicates the analysis and mitigation of harmonics, whose creation and propagation may be amplified ...

EPFL2024

Stability Analysis of Input-Series/Output-Parallel Solid-State Transformers Equipped with Second-Order Harmonic Active Power Filters

Drazen Dujic, Andrea Cervone, Tianyu Wei

Solid-State Transformers with Input-Series/Output-Parallel configuration offer a convenient solution for AC/DC conversion due to their scalability and modularity. In this configuration, each module experiences a second-order harmonic ripple caused by local ...

2024

Stability Analysis of Second-Order Harmonic Active Filters for Input-Series/Output- Parallel Solid State Transformers

Drazen Dujic, Andrea Cervone, Tianyu Wei

Solid-State Transformers with Input-Series/Output- Parallel configuration offer a convenient solution for AC/DC power conversion, thanks to their modularity, scalability and flexibility. However, as known, they are affected by a second-order harmonic rippl ...

2024

A Two-Wired High Input Impedance and High CMRR Active Electrode Insensitive to Component Mismatch

Alexandre Schmid, Mehdi Saberi

This article proposes a new two-wired amplifying active electrode (AE), presenting a high input impedance and a high common-mode rejection ratio (CMRR). In the proposed structure, the input impedance and the CMRR of the system are considerably increased by ...

Ieee-Inst Electrical Electronics Engineers Inc2024

Active Power Decoupling for Single-Phase Input-Series-Output-Parallel Solid-State Transformers

Drazen Dujic, Andrea Cervone, Tianyu Wei

Solid-state transformers with input-series outputparallel structures are being considered for a variety of applications requiring MVAC to LVDC conversion. Due to the singlephase AC/DC conversion at the input side, all floating cells of the solid-state tran ...

2024

A Dual-Channel Gate Driver Design with Active Voltage Balancing Circuit for Series Connection of SiC MOSFETs

Drazen Dujic, Rui Wang

Dual-channel gate driver is commonly utilized in the industry for accommodating the widespread use of half-bridge power modules. As wide-bandgap devices become increasingly prevalent due to their superior switching characteristics compared with conventiona ...

2024

Performance Comparison of Cables With Partial Transposition

Pierluigi Bruzzone, Kamil Sedlák, Chiara Frittitta, Federica Demattè

The need of full transposition of the current carrying elements (strands) in large cables is frequently retained as top design criterion for conductors operating in pulsed mode. However, when the transposition error, i.e., the inductance difference among t ...

IEEE Institute of Electrical and Electronics Engineers2024

Modeling and optimization of PCB coils for inductive power transfer systems

Xiaotong Du

The auxiliary power supply for medium voltage converters requires high insulation capability between the source and the load. Inductive power transfer technology, with an air gap between the primary and secondary coil, offers such high insulation capabilit ...

EPFL2024

Polarization-enhanced GaN Schottky barrier diodes: Ultra-thin InGaN for high breakdown voltage and low Ron

Elison de Nazareth Matioli, Alessandro Floriduz, Zheng Hao

In this work, we present a concept that leverages the strong piezoelectric polarization field in InGaN, which counteracts the external electric field at reverse bias. We show that despite the smaller InGaN band-gap and lower critical electric field, its st ...

2024

SPAD Developed in 55 nm Bipolar-CMOS-DMOS Technology Achieving Near 90% Peak PDP

Edoardo Charbon, Claudio Bruschini, Francesco Gramuglia, Myung Jae Lee, Ekin Kizilkan, Pouyan Keshavarzian, Won Yong Ha

We present a single-photon avalanche diode (SPAD) developed in 55 nm bipolar-CMOS-DMOS (BCD) technology, which achieves high photon detection probability (PDP) while its breakdown voltage is lower than 20 V. To enhance the PDP performance, the SPAD junctio ...

Ieee-Inst Electrical Electronics Engineers Inc2024

Integrated Wireless Power, Data Communication, and Thermal Sensing System for Autonomous Multisite Brain Implants

Mohammad Javad Karimi

Implanted medical devices (IMDs) have been widely developed to support the monitoring and recording of biological data inside the body or brain. Wirelessly powered IMDs, a subset of implantable electronics, have been proposed to eliminate the limitations r ...

EPFL2024

A modular multiple frequency inductive link to wirelessly power multiple miniaturized implants

Sandro Carrara, Diego Ghezzi, Gian Luca Barbruni

A modular multiple frequency coils inductive link system to wirelessly provide power for at least a medical implant at an output of a receiving coil, whereby the receiving coil is configured to be implanted in an organism. The modular multiple frequency co ...

2024