Publications related to Persistence of variant selection in red gold alloys

Adolescent Stress-Induced Ventral Hippocampus Redox Dysregulation Underlies Behavioral Deficits and Excitatory/Inhibitory Imbalance Related to Schizophrenia

Maria del Carmen Sandi Perez, Dogukan Hazar Ülgen, Thamyris Silva

Background and hypothesis: Redox dysregulation has been proposed as a convergent point of childhood trauma and the emergence of psychiatric disorders, such as schizophrenia (SCZ). A critical region particularly vulnerable to environmental insults during ad ...

2024

Fine Arts in Transition: An Operative Research and Teaching Approach between Analogue and Digital

Nicola Braghieri, Filippo Fanciotti

The volume collects the material produced for the exhibition 'The Sky in the Room' and a selection of scientific texts on the question of analogue continuity in digital transition. The contributions will be focused on verifying the operative method in teac ...

EPFL Press2024

Experimental and analytical investigation of shear-reinforced concrete and dowel action

Marko Pejatovic

Codes of practice can be overly conservative, particularly for the shear resistance of reinforced concrete beams with shear reinforcement when large loads act close to supports. This thesis addresses the topic by proposing a refined design approach based o ...

EPFL2024

Quantitative study of the thickness-dependent stress in indium tin oxide thin films

Varun Gupta

A quantitative analysis of stress in indium tin oxide (ITO) films with varying thicknesses was conducted using high-precision stylus profilometry. The experimental results revealed a transition of the stress type from tensile to compressive as the ITO film ...

Elsevier Science Sa2023

Psychosomatic response to acute emotional stress in healthy students

Adriana Arza Valdes

The multidimensionality of the stress response has shown the complexity of this phenomenon and therefore the impossibility of finding a unique biomarker among the physiological variables related to stress. An experimental study was designed and performed t ...

FRONTIERS MEDIA SA2023

Single-Well Pore Pressure Preconditioning for Enhanced Geothermal System Stimulation

Marie Estelle Solange Violay, Barnaby Padraig Fryer, Mathias Alexandre David Lebihain

The stress state is an important parameter in terms of both earthquake nucleation and rupture. Here, a new stimulation technique is proposed for Enhanced Geothermal Systems (EGSs), which have previously been burdened with a number of high-profile incidence ...

2023

Control of intermetallics in the interface in directed energy deposition of titanium on stainless steel 316L

Di Cui

Application of a single metal or alloy is often restricted by its properties from optimal combination of performance and cost. Therefore, there is a vast need of joining dissimilar metals for various applications in biomedical, aerospace, automobile and ma ...

EPFL2023

Thermo-hydro-mechanical analysis of the complete lifetime of the bentonite barrier in the FEBEX in-situ test

Lyesse Laloui, Alessio Ferrari, Yafei Qiao, Jose Antonio Bosch Llufriu

The FEBEX test was a large-scale demonstration project for the deep geological disposal concept of nuclear waste involving bentonite seals that lasted 18 years. One of the objectives of the test was to evaluate the capabilities of numerical methods to prov ...

2023

Crack tip kinematics reveal the process zone structure in brittle fracture

John Martin Kolinski, Chenzhuo Li, Xinyue Wei

When brittle hydrogels fail, several mechanisms conspire to alter the state of stress near the tip of a crack, and it is challenging to identify which mechanism is dominant. In the fracture of brittle solids, a sufficient far-field stress results in the co ...

PERGAMON-ELSEVIER SCIENCE LTD2023

Micromechanics of oxide inclusions in ferrous alloys

Alejandra Inés Slagter

Oxide inclusions are inevitably present in steel as a direct consequence of the steelmaking process; as a result, a cubic centimetre of modern steel will generally contain about a million of these hard and brittle micrometre-sized ceramic particles. Inclus ...

EPFL2023

Simple shear extrusion versus equal channel angular pressing: A comparative study on the microstructure and mechanical properties of an Mg alloy

Cyril Cayron, Roland Logé, Aryan Rezaei Rad

Two severe plastic deformation (SPD) techniques of simple shear extrusion (SSE) and equal channel angular pressing (ECAP) were employed to process an extruded Mg -6Gd -3Y -1.5Ag (wt%) alloy at 553 K for 1, 2, 4 and 6 passes. The microstructural evolutions ...

KEAI PUBLISHING LTD2023

Impact of substrate clogging on vertical connectivity

Giovanni De Cesare, Romain Maxime Dubuis, Robin Schroff

Connectivity between the hyporheic zone and the flow is essential for the development of benthos and the reproductive success of spawning fish. The infiltration of fine sediment leads to clogging of the riverbed, reducing porosity and vertical water exchan ...

2023

Pore-pressure coefficients for unsaturated soils: generalized effective stress approach

Lyesse Laloui, Alessio Ferrari, Angelica Tuttolomondo

Geotechnical problems with total stress changes occurring rapidly relative to the soil consolidation time can be conveniently addressed using an effective stress-based approach. For saturated states, analytical formulations of pore-pressure coefficients ad ...

CANADIAN SCIENCE PUBLISHING2023

Three-dimensional stress state during dynamic shear rupture propagation along frictional interfaces in elastic plates

Jean-François Molinari, Roozbeh Rezakhani

The state of stress in plates, where one geometric dimensions is much smaller than the others, is often assumed to be of plane stress. This assumption is justified by the fact that the out-of-plane stress components are zero on the free-surfaces of a plate ...

ELSEVIER2022

Stress effects on the impedance and ferroelectricity of PVDF-BiFeO3-MWCNT films using xanthan gum as dispersant

Frank Nüesch, Francis Owusu

Composite films based on dispersions of bismuth ferrite (BiFeO3) in polyvinylidene fluoride (PVDF) matrixes were prepared in the presence of multiwalled-carbon-nanotubes (MWCNT), using xanthan gum (XG) as dispersant. Films were prepared by spin coating and ...

ELSEVIER SCIENCE SA2022

Strengthening mechanisms in dilute and random solid solution high-entropy BCC alloys

Alireza Ghafarollahi

Tuning the mechanical properties of metals, including strength, through adjusting the type and/or concentration of added solute elements, has been recognized as an effective way to design and produce materials with desired or optimized mechanical propertie ...

EPFL2022

Role of Stress History on the Swelling-Shrinkage Behavior of Compacted Scaly Clay

Alessio Ferrari

Compacted scaly clays are complex geomaterials widely used for the realization of dam cores and waste dump liners. This research aims to investigate the swelling/shrinkage behavior of these geomaterials subjected in an oedometric cell to complex hydromecha ...

ASCE-AMER SOC CIVIL ENGINEERS2022

The thermally activated deformation behaviour of single-crystalline microcast aluminium wires

Andreas Mortensen, Léa Deillon, Suzanne Godelieve Alphonsine Verheyden

A microcasting process is used to produce high aspect ratio ( > 30) monocrystalline pure aluminium wires with a diameter between 14 and 115 mu m. The role of thermal activation in the plastic deformation of these microwires is measured by means of (single) ...

PERGAMON-ELSEVIER SCIENCE LTD2022

On the behavior of uniaxial static stress loaded micro-scale fused silica beams at room temperature

Yves Bellouard, Christos Edouardos Athanasiou, Saood Ibni Nazir

The question of whether static stress in fused silica relaxes at room temperature is still under debate. Here, we report experimental data investigating the behavior of fused silica at room temperature when subjected to static tensile stress up to 2 GPa st ...

2022

Investigation of phase formation, microstructure and mechanical properties of LC3 based autoclaved aerated blocks

Karen Scrivener

This study investigates the microstructure, phase formation, and mechanical properties of LC3-50 based auto-claved aerated blocks. The microstructure and phase formation is studied using SEM-EDS and X-ray diffraction techniques. The fresh and hardened prop ...

ELSEVIER SCI LTD2022