Publications related to Comparison of LPCVD and sputter-etched ZnO layers applied as front electrodes in tandem thin-film silicon solar cells

Related publications (42)

Tuning Electronic and Optical Properties of 2D/3D Interfaces of Hybrid Perovskites through Interfacial Charge Transfer: Prediction of Higher-Efficiency Interface Solar Cells Using Hybrid-DFT Methods

The 2D/3D or 2D/quasi-2D composite mixed-dimensional construction of hybrid perovskite interfaces is gaining increasing attention due to their enhanced stability toward degradation without compromising the corresponding solar cell efficiency. Much of this ...

AMER CHEMICAL SOC2025

Template-Assisted Growth of CsxFA1-xPbI3 with Pulsed Laser Deposition for Single Junction Perovskite Solar Cells

Christian Michael Wolff, Kerem Artuk

Cesium-formamidinium lead iodide (CsxFA1-xPbI3) perovskites are a promising methylammonium-free alternative for efficient single-junction solar cells. However, they have not been fully explored by vapor-phase deposition techniques. Herein, a template-assis ...

2025

Buried Hole-selective Interface Engineering for High-efficiency Tin-lead Perovskite Solar Cells with Enhanced Interfacial Chemical Stability

Guixiang Li

Mixed Sn-Pb perovskites are attracting significant attention due to their narrow bandgap and consequent potential for all-perovskite tandem solar cells. However, the conventional hole transport materials can lead to band misalignment or induce degradation ...

ELSEVIER2025

Efficient Polycrystalline Single-Cation Perovskite Light-Emitting Diodes by Simultaneous Intracrystal and Interfacial Defect Passivation

Mohammad Khaja Nazeeruddin, Emad Oveisi

Polycrystalline perovskite light-emitting diodes (PeLEDs) have shown great promise with high efficiency and easy processability. However, PeLEDs using single-cation polycrystalline perovskite emitters have demonstrated low efficiency due to defects within ...

2025

High‐Efficiency Sn‐Pb Perovskite Solar Cells via Nucleation and Crystallization Control

Mohammad Khaja Nazeeruddin

The rapid crystallization of mixed tin‐lead (Sn‐Pb) perovskites and their dependence on antisolvent processes limit the development of large‐area Sn‐Pb perovskite solar cells (PSCs). Vacuum‐flash‐assisted solution processing (VASP) has emerged as a promisi ...

Wiley2025

Enhancing Indoor Photovoltaic Eﬃciency to 37.6% Through Triple Passivation Reassembly and n-Type to p-Type Modulation in Wide Bandgap Perovskites

Michael Graetzel, Lukas Pfeifer

Despite well‐matching indoor illumination spectra, the performance of wide bandgap perovskite solar cells (WB‐PSCs) for indoor photovoltaics (i‐PV) is hindered by photo‐induced halide phase segregation and trap‐assisted non‐radiative recombination. Herein, ...

Wiley2025

Nanowire morphology control in Sb metal-derived antimony selenide photocathodes for solar water splitting

Wenzhe Niu

We report a facile method to enhance the photoelectrochemical (PEC) performance of Sb2Se3 photocathodes by controlling the growth of bilayer Sb2Se3 consisting of vertically oriented nanorods on a compact Sb2Se3 layer. Sb2Se3 thin films with controllable na ...

Royal Society of Chemistry2025

Origin of interface stress enhancement and compressive-to-tensile stress transition in immiscible nanomultilayers

William Curtin

Experiments on the intrinsic stress in immiscible Cu/W nanomultilayers (NMLs) show two unusual features: a compressive-to-tensile transition as a function of NML deposition conditions and extremely high interface stresses under both high- and low-pressure ...

2025

Plasma-irradiated hafnia ferroelectrics for high-performance flexible thin film transistors

Arindam Bala

Integrating unconventional HfO2-based ferroelectrics in thin film transistors (TFTs) has proven effective in enhancing performance by stabilizing negative capacitance (NC). This is achieved by incorporating the ferroelectric in series with a high-permittiv ...

2025

Beyond Flat: Undulated Perovskite Solar Cells on Microscale Si Pyramids by Solution Processing

Christophe Ballif, Aïcha Hessler-Wyser, Christian Michael Wolff, Kerem Artuk, Mostafa Rabie Shlaly Bahr Othman, Deniz Türkay

Microscale pyramids of silicon solar cells are often considered incompatible with solution-processed perovskite films. Thus, solution processing has mainly been used with submicron pyramids that are buried under thick perovskite films with flattened front ...

AMER CHEMICAL SOC2025

Monolayer-Thick GaN/AlN Quantum Well Anodes and Far-UVC Field Emission Device at 226 nm

Nicolas Grandjean, Jean-François Carlin, Pierre Jean-François Jules Demolon

Far-UVC light sources in the spectral range of200-230 nm effectively kill bacteria and deactivate viruses while being not harmful to health, enabling persistent disinfection of air and surfaces in the presence of humans. So far only excimer lamps have been ...

IEEE2025

Enhancing Efficiency of Industrially-Compatible Monolithic Perovskite/Silicon Tandem Solar Cells with Dually-Mixed Self-Assembled Monolayers

Mohammad Khaja Nazeeruddin, Peng Gao

The antisolvent-assisted spin-coating still lags behind the thermal evaporation method in fabricating perovskite films atop industrially textured silicon wafers in making monolithic perovskite/silicon solar cells (P/S-TSCs). The inhomogeneity of hole-selec ...

Wiley-V C H Verlag Gmbh2024

Axial-Equatorial Halide Ordering in Layered Hybrid Perovskites from Isotropic-Anisotropic 207Pb NMR

David Lyndon Emsley, Aditya Mishra, Michael Allan Hope, Manuel Cordova, Ümmügülsüm Günes

Bandgap-tuneable mixed-halide 3D perovskites are of interest for multi-junction solar cells, but suffer from photoinduced spatial halide segregation. Mixed-halide 2D perovskites are more resistant to halide segregation and are promising coatings for 3D per ...

Wiley-VCH Verlag GmbH2024

Elimination of buried interfacial voids for efficient perovskite solar cells

Bin Ding, Xianfu Zhang

Establishing optimal interfacial contact is crucial for enhancing the efficiency of perovskite solar cells (PSCs). However, formation of voids at buried interface of perovskite films often hinders this critical objective. Our investigation reveals that the ...

Elsevier2024

Enhanced performance of perovskite solar cell via up-conversion YLiF4:Yb, Er nanoparticles

Mounir Driss Mensi, Masaud Hassan S Almalki, Anwar Qasem M Alanazi

We report a simple and effective method for producing lanthanide ion-doped lithium-fluoride-based nanocrystals (YLiF4). We utilized those nanoparticles for up-conversion in fabricated perovskite solar cells. The obtained results shows that the up-conversio ...

Elsevier2024

A comprehensive physical model for the sensitivity of silicon heterojunction photovoltaic modules to water ingress

Christophe Ballif, Alessandro Francesco Aldo Virtuani, Luca Gnocchi, Olatz Arriaga Arruti

Silicon heterojunction (SHJ)-solar modules-when encapsulated with ethylene vinyl acetate (EVA)-are known to be extremely sensitive to water ingress. The reason for this is, however, not clear. Here, we explain the root causes of this degradation mechanism ...

Cell Press2024

Plasmonic Nanostructures for Photocatalysis: Material, Photonic and Electronic Effects

Fateme Kiani Shahvandi

Plasmonic photochemistry has a large potential to replace energy-intensive chemical processes with low-temperature, low-pressure light-driven chemical reactions. Plasmonic nanostructures have emerged as promising photocatalysts with exceptional and tunable ...

EPFL2024

Identification and Mitigation of Degradation Mechanisms Induced by Heat and Light in NiOx-based Perovskite Solar Cells

Marion Solange Madeleine Dussouillez

Perovskite solar cells (PSCs) offer an attractive solution to increase the efficiency of PV panels via perovskite/silicon tandems thanks to their potential cost-effectiveness and high efficiency. In inverted PSC architecture (p-i-n), commonly used hole con ...

EPFL2024

Structural divergence of molecular hole selective materials for viable p-i-n perovskite photovoltaics: a comprehensive review

Mohammad Khaja Nazeeruddin, Peng Gao

Perovskite solar cells (PSCs) have garnered significant attention within the photovoltaic research community due to their remarkable progress in just one decade. Among the device configurations, the p-i-n structured PSC offers several advantages, including ...

Royal Society of Chemistry2024

Encapsulation strategies for mechanical impact and damp heat reliability improvement of lightweight photovoltaic modules towards vehicle-integrated applications

Fabiana Lisco

Lightweight modules are essential for next-generation vehicle-integrated photovoltaic (VIPV) applications, such as solar-powered cars, allowing integration of solar cells beyond the roof, and on the hood, boot and body panels, and thereby extending the dri ...

Elsevier2024