Mediaspace scheduled maintenance: Aug 25, 2026 07:00 - 12:00 AM. During this time, videos will be temporarily unavailable. Check status updates.

Concept

Electron-beam physical vapor deposition

Related publications (29)

Influence of Ventilation on Formation and Growth of 1-20 nm Particles via Ozone-Human Chemistry

Dusan Licina, Shen Yang, Marouane Merizak, Meixia Zhang

Ozone reaction with human surfaces is an important source of ultrafine particles indoors. However, 1-20 nm particles generated from ozone-human chemistry, which mark the first step of particle formation and growth, remain understudied. Ventilation and indo ...

Amer Chemical Soc2024

Scanning Tunneling Microscopy for Molecules: Effects of Electron Propagation into Vacuum

Klaus Kern, Abhishek Grewal

Using scanning tunneling microscopy (STM), we experimentally and theoretically investigate isolated platinum phthalocyanine (PtPc) molecules adsorbed on an atomically thin NaCl(100) film vapor deposited on Au(111). We obtain good agreement between theory a ...

Amer Chemical Soc2024

Optimizing Atomic Layer Deposition Processes with Nanowire-Assisted TEM Analysis

Ivo Utke, Johann Michler, Xavier Maeder

Atomic layer deposition (ALD) is one of the premier methods to synthesize ultra-thin materials on complex surfaces. The technique allows for precise control of the thickness down to single atomic layers, while at the same time providing uniform coverage ev ...

Wiley2024

Towards Scalable Electronics: Synthetic 2D Materials for Large-Area 2D Circuit Integration

Zhenyu Wang

In the past decades, a significant increase of the transistor density on a chip has led to exponential growth in computational power driven by Moore's law. To overcome the bottleneck of traditional von-Neumann architecture in computational efficiency, effo ...

EPFL2024

Electrochemical sensors modified with iron oxide nanoparticles/ nanocomposites for voltammetric detection of Pb (II) in water: A review

Sandro Carrara

Permissible limits of Pb 2+ in drinking water are being reduced from 10 mu gL -1 to 5 mu gL -1 , which calls for rapid, and highly reliable detection techniques. Electrochemical sensors have garnered attention in detection of heavy metal ions in environmen ...

Cell Press2024

On the importance of the humidity flux for the surface mass balance in the accumulation zone of the Greenland Ice Sheet

Sonja Wahl

It is highly uncertain how the humidity flux between the snow surface and the atmosphere contributes to the surface mass balance (SMB) of the interior Greenland Ice Sheet (GrIS). Due to sparse observations, evaluations of the simulated humidity flux are li ...

Copernicus Gesellschaft Mbh2024

Plasmoid drift and first wall heat deposition during ITER H-mode dual-SPIs in JOREK simulations

Mengdi Kong

The heat flux mitigation during the thermal quench (TQ) by the shattered pellet injection (SPI) is one of the major elements of disruption mitigation strategy for ITER. It's efficiency greatly depends on the SPI and the target plasma parameters, and is ult ...

IOP Publishing Ltd2024

Synthesis of metal oxide-overcoated carbon materials by liquid phase ALD and their applications in catalysis

Farzaneh Talebkeikhah

Coating nano particles and other substrates for efficiency enhancement, protection and obtaining new atomic structures is a widespread research topic in catalysis and material synthesis. Thus far, different approaches of coating, ranging from simplest to s ...

EPFL2023

Control of intermetallics in the interface in directed energy deposition of titanium on stainless steel 316L

Di Cui

Application of a single metal or alloy is often restricted by its properties from optimal combination of performance and cost. Therefore, there is a vast need of joining dissimilar metals for various applications in biomedical, aerospace, automobile and ma ...

EPFL2023

Plasma-Assisted Hybrid Vapour Deposition Technology for Thin Film Fabrication

Caroline Hain

Continuous development of thin film deposition technologies is essential for the fabrication of films that meet the specific requirements of their target applications and working conditions. Therefore, it is necessary to increase the number of accessible a ...

EPFL2023

III-V Nitride Semiconductors Deposited At Low Temperature For Photovoltaic Applications

Jonathan Emanuel Thomet

This thesis reports on the study and use of low temperature processes for the deposition of indium gallium nitride (InGaN) thin films in order to alleviate some of the present drawbacks of its monolitic deposition on silicon for photovoltaic applications. ...

EPFL2023

Continuous monitoring of morphological changes from sediment augmentation by field measurements and flume experiments

Giovanni De Cesare, Christian Mörtl

In this study, we present results from continuous field monitoring and a flume ex-periment of a sediment augmentation measure in a residual flow reach of the Swiss midlands. A straight morphological channel with fixed bed material was constructed to repres ...

2023

Full Solution Process of a Near-Infrared Light-Emitting Electrochemical Cell Based on Novel Emissive Ruthenium Complexes of 1,10-Phenanthroline-Derived Ligands and a Eutectic Alloy as the Top Electrode

Mohammad Khaja Nazeeruddin

Near-infrared luminescent materials have recently received considerable attention for a large number of applications, including in solid-state lighting, as bioimaging agents, as photovoltaic cells, and in the telecommunication industry. By adding diverse e ...

AMER CHEMICAL SOC2023

Vapor Deposition of Perovskite Solar Cells

Quentin Jean-Marie Armand Guesnay

Thanks to the continuous improvement of crystalline silicon (c-Si) solar cells, largely dominating the market, photovoltaic electricity is nowadays the cheapest source of energy on the market. Yet, solar energy is far from being completely harvested, as t ...

EPFL2023

CVD of MoS2 single layer flakes using Na2MoO4 - impact of oxygen and temperature-time-profile

Christian Wäckerlin

Two-dimensional (2D) materials are of great interest in many fields due to their astonishing properties at an atomic level thickness. Many fundamentally different methods to synthesize 2D materials, such as exfoliation or chemical vapor deposition (CVD), h ...

Royal Soc Chemistry2023

Semiconductor-based device architectures in multimaterial fibers

William Nicolas Duncan Esposito

Semiconductor materials have given rise to today's digital technology and consumer electronics. Widespread adoption is closely linked to the ability to process and integrate them in devices at scale. Where flexibility and large surfaces are required, such ...

EPFL2023

Development of stencil lithography for stretchable interconnects

Yi-Chiang Sun

The growing needs for human healthcare have driven the development of wearable devices for monitoring the health status of an individual. Polymers represent a promising platform for such devices due to their ability to form an intimate contact between soft ...

EPFL2022

Nanobridge Stencil Enabling High Resolution Arbitrarily Shaped Metallic Thin Films on Various Substrates

Jürgen Brugger, Giovanni Boero, Yi-Chiang Sun

Stencil lithography (SL), which uses a perforated membrane as a reusable shadow mask to locally add material patterns on substrates provides a simple but versatile approach for the fabrication of functional devices on a large variety of substrate materials ...

Wiley2022

Structural and photophysical investigation of single-source evaporation of CsFAPbI(3) and FAPbI(3) perovskite thin films

Mohammad Khaja Nazeeruddin, Hiroyuki Kanda, Albertus Adrian Sutanto, Maria Cristina Momblona Rincón, Nadja Isabelle Desiree Klipfel

Thermal vacuum deposition is a stimulating technique for upscaling perovskite solar cells. However, the operational complexity of multisource vapor deposition (MSVD) and achieving stoichiometric perovskite layers may impede its implementation. The single-s ...

Royal Society of Chemistry2022

Molybdenum disulphide nanoporous membranes as nanofluidic platforms - large-area engineering and study

Michal Daniel Macha

The work demonstrated in this thesis represent the path towards developing the large-scale fabrication of two-dimensional nanoporous membrane devices and use thereof as platforms to study nanoscale physics of water and ion flow through confined channels. M ...

EPFL2022