Publications associées à Composition and structure of Fe(III)-precipitates formed by Fe(II) oxidation in water at near-neutral pH: Interdependent effects of phosphate, silicate and Ca

Publications associées (34)

Optimizing Atomic Layer Deposition Processes with Nanowire-Assisted TEM Analysis

Atomic layer deposition (ALD) is one of the premier methods to synthesize ultra-thin materials on complex surfaces. The technique allows for precise control of the thickness down to single atomic layers, while at the same time providing uniform coverage ev ...

Wiley2024

Composition and Element Distribution Mapping of γ′ and γ" Phases of Inconel 718 by High-Resolution Scanning Transmission Electron Microscopy and X-ray Energy-Dispersive Spectrometry

Philippe Buffat

The main strengthening mechanism for Inconel 718 (IN718), a Ni-based superalloy, is precipitation hardening by gamma ' and gamma '' particles. It is thus essential, for good alloy performance, that precipitates with the desired chemical composition have ad ...

MDPI2024

Microstructure - Electrochemical Surface Reactivity Relationship of Electrochemically Grown Manganese Oxides Films

Roberto Cestaro

This Thesis provides a comprehensive and correlative investigation of the microstructure, chemical state, and electrochemical reactivity of manganese oxide (MnOx) films, aiming to gain a deeper understanding of the deposition and dissolution mechanism of M ...

EPFL2024

Effect of post-heat treatment conditions on shape memory property in 4D printed Fe-17Mn-5Si-10Cr-4Ni shape memory alloy

Christian Leinenbach, Irene Ferretto

The influence of post-heat treatment on the microstructure and properties of 4D printed Fe-17Mn-5Si-10Cr-4Ni (wt. %) shape memory alloy (SMA) produced via a laser powder bed fusion process is investigated in this study. It is shown that heat-treatment temp ...

2022

Evidence of a transient phase during the hydrolysis of calcium-deficient hydroxyapatite

Jacques Lemaître

In the present paper, calcium deficient hydroxyapatite (Ca-def OHAP) has been examined in a transmission electron microscope. During the observation, the initial Ca-def OHAP was seen to transform first into a transient intermediate phase, then to a final, ...

WALTER DE GRUYTER GMBH2022

Kinetic and mechanistic understanding of chlorite oxidation during chlorination: Optimization of ClO2 pre-oxidation for disinfection byproduct control

Urs von Gunten

Chlorine dioxide (ClO2) applications to drinking water are limited by the formation of chlorite (ClO2-) which is regulated in many countries. However, when ClO2 is used as a pre-oxidant, ClO2- can be oxidized by chlorine during subsequent disinfection. In ...

PERGAMON-ELSEVIER SCIENCE LTD2022

Evolution of deformation twinning mechanisms in magnesium from low to high strain rates

Roland Logé, Cyril Cayron, Johann Michler, Xavier Maeder, Nicolò Maria Della Ventura

We present a systematic investigation of {10 (1) over bar2} extension twinning mechanism in single crystal magnesium micropillars deformed over seven orders of magnitude of strain rate, from 10(-4) to 500 s(-1), revealing how the accommodation of newly for ...

ELSEVIER SCI LTD2022

Early Stages of Precipitation In Aluminum Alloys by First-Principles and Machine-Learning Atomistic Simulations

Daniele Giofré

Age hardening induced by the formation of (semi)-coherent precipitate phases is crucial for the processing and final properties of the widely used Al-6000 alloys despite the early stages of precipitation are still far from being fully understood. This cruc ...

EPFL2018

Machine learning for metallurgy IV: A neural network potential for Al-Cu-Mg and Al-Cu-Mg-Zn

William Curtin, Daniel John Gilles Marchand

Most metallurgical properties, e.g., dislocation propagation, precipitate formation, can only be fully understood atomistically but most phenomena and quantities of interest cannot be measured experimentally. Accurate simulation methods are essential but f ...

2022

Strain-induced dissolution of Y-Ti-O nano-oxides in a consolidated ferritic oxide dispersion strengthened (ODS) steel

Roland Logé, Mathijs Pieter van der Meer

The present study shows the influence of severe plastic deformation on highly stable Y-Ti-O nano-oxides present in ferritic ODS alloys used for nuclear applications. An innovative strain path implying alternated compressions was used to deform the material ...

2018

Effect of alkali, aluminium and equilibration time on calcium-silicate-hydrates

Yiru Yan, Yu Yan

Calcium silicate hydrate (C-S-H) is the main hydration product in Portland and blended cements, and greatly affects durability and mechanical properties of the hydrated cement. In the presence of Al-rich supplementary cementitious materials (SCMs), C-(A-)S ...

EPFL2022

Structure of precipitates and orientation relationships in Al, Ge, Mo-doped higher manganese silicide crystals

Philippe Buffat, Elena Suvorova Buffat, Marco Cantoni

The structure of Al, Ge, Mo-doped Higher Manganese Silicide (HMS) crystals with the general formulas Mn(Si0.99Ge0.01)(1.75), Mn(Si0.995Ge0.005)(1.75) and (Mn0.98Mo0.02)(Si0.98Ge0.02)(1.75)Al-0.01 was investigated by scanning and transmission electr ...

Taylor & Francis Ltd2017

Structural, tribo-mechanical, and thermal properties of NbAlN coatings with various Al contents deposited by DC reactive magnetron sputtering

Silviu Cosmin Sandu

DC reactive magnetron sputtered Nb2AlyNx coatings with various Al contents (y/(y + z)) ranging from 0 to 0.75 were deposited using different ratios of the currents applied to the Al and Nb targets in order to systematically control their chemical compositi ...

Elsevier Science Sa2017

Microalloying for the controllable delay of precipitate formation in metal alloys

William Curtin

A model is presented to predict the effectiveness of dilute solutes in delaying precipitate formation, with application to natural and artificial aging in metal alloys. Control of aging is achieved via the binding, at natural aging temperatures, and releas ...

Elsevier2016

Imaging and characterization of gamma ' and gamma '' nanoparticles in Inconel 718 by EDX elemental mapping and FIB-SEM tomography

Philippe Buffat

Microstructural characterization of Inconel 718 superalloy after three different heat treatment variants was performed by electron microscopy and electron tomography techniques, taking advantage of recent development in quantitative electron microscopy. Di ...

Elsevier Science Inc2015

Two-dimensional atomically bridged nanoporous silicate-based membranes for gas separation

Mostapha Dakhchoune

The synthesis of molecular-sieving two-dimensional zeolitic membranes by the assembly of crystalline building blocks without resorting to the secondary growth process is highly desirable. The precise pore size for molecular sieving, ultrathin thickness, an ...

EPFL2021

Effect of treatment on the microstructural characteristics of bio-improved sand

Lyesse Laloui, Dimitrios Terzis

Bio-chemical processes have recently become the core of several studies in the geoengineering field, where the emphasis is placed on new and emerging applications. Microbially Induced Calcite Precipitation has been introduced as an alternative cementation ...

IOS Press, 20152015

Development and Characterization of Rice Husk and Recycled Polypropylene Composite Filaments for 3D Printing

Véronique Michaud

Nowadays the use of natural fiber composites has gained significant interest due to their low density, high availability, and low cost. The present study explores the development of sustainable 3D printing filaments based on rice husk (RH), an agricultural ...

2021

Aluminium and alkali uptake in calcium silicate hydrates (C-S-H)

Émilie Michèle L'Hôpital

Calcium silicate hydrate (C-S-H) is the main hydrate phase in Portland cements. Its composition varies depending on the Ca/Si ratio and on the presence of other ions such as aluminium (called CA- S-H) or alkalis. This thesis aimed to study the compositi ...

EPFL2014

Quantification of hydrogen in nanostructured hydrogenated passivating contacts for silicon photovoltaics combining SIMS-APT-TEM: A multiscale correlative approach

Franz-Josef Haug, Aïcha Hessler-Wyser, Quentin Thomas Jeangros, Mario Joe Lehmann

Multiscale characterization of the hydrogenation process of silicon solar cell contacts based on c-Si/SiOx/ncSiCx(p) has been performed by combining dynamic secondary ion mass-spectrometry (D-SIMS), atom probe tomography (APT), and transmission electron mi ...

ELSEVIER2021