Publication

Effect of B x del B direction on SOL energy transport in JET

Publications associées (31)

Full-F turbulent simulation in a linear plasma device using a gyro-moment approach

Simulations of plasma turbulence in a linear plasma device configuration are presented. These simulations are based on a simplified version of the gyrokinetic (GK) model proposed by Frei et al. [J. Plasma Phys. 86, 905860205 (2020)], where the full-F distr ...

Aip Publishing2024

Re-design of EU DEMO with a low aspect ratio

Hartmut Zohm

The design point that had been chosen for EU DEMO in 2016 is reviewed here and a modification is proposed with a lower aspect ratio. Previously the same aspect ratio, A, was chosen for EU DEMO as in major tokamak experiments including ITER (A = 3.1), and, ...

2024

Scenario optimization for the tokamak ramp-down phase in RAPTOR: A. Analysis and model validation on ASDEX Upgrade

Olivier Sauter, Federico Alberto Alfredo Felici, Anna Teplukhina, Simon Van Mulders, Cassandre Ekta Contré, Bernhard Sieglin

We discuss how the combination of experimental observations and rapid modeling has enabled to improve understanding of the tokamak ramp-down phase in ASDEX Upgrade. A series of dedicated experiments has been performed, to disentangle the effect of individu ...

Iop Publishing Ltd2024

Towards practical reinforcement learning for tokamak magnetic control

Jonas Buchli, Federico Alberto Alfredo Felici, Cristian Galperti, Brendan Tracey

Reinforcement learning (RL) has shown promising results for real-time control systems, including the domain of plasma magnetic control. However, there are still significant drawbacks compared to traditional feedback control approaches for magnetic confinem ...

Elsevier Science Sa2024

Scenario optimization for the tokamak ramp-down phase in RAPTOR. Part B: safe termination of DEMO plasmas

Olivier Sauter, Emiliano Fable, Federico Alberto Alfredo Felici, Anna Teplukhina, Simon Van Mulders, Cassandre Ekta Contré

An optimized plasma current ramp-down strategy is critical for safe and fast termination of plasma discharges in a tokamak demonstration fusion reactor (DEMO), both in planned and emergency scenarios, avoiding plasma disruptions and excessive heat loads to ...

Iop Publishing Ltd2024

Global fluid simulations of plasma turbulence in stellarators

António João Caeiro Heitor Coelho

In order to cope with the decarbonization challenge faced by many countries, fusion is one of the few alternatives to fossil fuels for the production of electricity. Two devices invented in the middle of the previous century have emerged as the most promis ...

EPFL2024

Full-discharge simulation and optimization with the RAPTOR code, from present tokamaks to ITER and DEMO

Simon Van Mulders

Tokamak devices aim to magnetically confine a hydrogen plasma at sufficiently high pressure to achieve net energy production from nuclear fusion of light isotopes. Predictive modeling and optimization is crucial for reliable operation of tokamak reactors, ...

EPFL2023

Studies on EU-DEMO 3D coils requirements and conceptual design for error field correction and plasma control

Pierluigi Bruzzone, Hartmut Zohm, Leonardo Pigatto

This work presents the initial studies on the requirements for the design of 3D coils on EU-DEMO. The use of 3D coils in present machines includes two main purposes: the first one is the Error Field Correction (EFC). The EFC aims at minimizing the intrinsi ...

Elsevier Science Sa2023

Study of correlations between LOC/SOC transition, intrinsic toroidal rotation reversal and TEM/ITG bifurcation with different working gases in TCV

Basil Duval, Aylwin Iantchenko, Filippo Bagnato, Oleg Krutkin

The effects of different working gases on the transition from linear ohmic confinement (LOC) regime to saturated ohmic confinement (SOC) regime and its relation to the intrinsic toroidal rotation reversal phenomenon were explored in the TCV tokamak. The en ...

IOP Publishing Ltd2023

Nonlinear saturation of resistive tearing modes in a cylindrical tokamak with and without solving the dynamics

Joaquim Loizu Cisquella

We show that the saturation of resistive tearing modes in a cylindrical tokamak, as well as the corresponding island width, can be directly calculated with a magnetohydrodynamics (MHD) equilibrium code without solving the dynamics and without considering r ...

Cambridge University Press2023

How accurate are flux-tube (local) gyrokinetic codes in modeling energetic particle effects on core turbulence?

Olivier Sauter, Alberto Bottino, Emanuele Poli

Flux-tube (local) gyrokinetic codes are widely used to simulate drift-wave turbulence in magnetic confinement devices. While a large number of studies show that flux-tube codes provide an excellent approximation for turbulent transport in medium-large devi ...

IOP Publishing Ltd2023

Occam's razor on the mechanism of resistive-wall-mode-induced beta limits in diverted tokamaks

Jonathan Graves, Daniele Brunetti

External kink modes, believed to be the drive of the 0-limiting resistive wall mode, are strongly stabilized by the presence of a separatrix. We thus propose a novel mechanism explaining the appearance of long-wavelength global instabilities in free bounda ...

2023

An experimental and computational study of tokamak plasma turbulence

Aylwin Iantchenko

Turbulence driven by small-scale instabilities results in strong heat and particle transport, which significantly shortens the confinement time and prevents the formation of a self-sustained plasma reaction in magnetic confinement devices. Control and poss ...

EPFL2023

The MAgnet Design Explorer algorithm (MADE) for LTS, Hybrid or HTS toroidal and poloidal systems of a tokamak with a view to DEMO

The European Roadmap to Fusion Electricity (Federici et al., 2018) [1] details the path to complete within the next three decades the DEMOnstration power plant, DEMO, aiming to a net gain of Energy Q=40. The 2018 DEMO baseline considers a 2 GW tokamak devi ...

2023

A Gyrokinetic Moment Model of the Plasma Boundary in Fusion Devices

Baptiste Jimmy Frei

The overall performance of fusion devices, such as tokamaks, is strongly correlated to the phenomena that occur in the boundary region, the outer plasma region that faces the wall of the device. The boundary plays a crucial role in regulating the heat and ...

EPFL2023

Measuring the electron energy distribution in tokamak plasmas from polarized electron cyclotron radiation

Arsène Stéphane Tema Biwole

In this doctoral thesis, a promising technique has been used for the measurement of non-thermal electrons in TCV. The technique employs a Vertical viewing ECE to more easily discriminate the radiation according to the energy of the electrons. Successful ...

EPFL2023

Electron temperature fluctuation measurements with Correlation Electron Cyclotron Emission in L-mode and I-mode plasmas at ASDEX Upgrade

Pedro Andres Molina Cabrera

The Correlation Electron Cyclotron Emission (CECE) diagnostic at ASDEX Upgrade (AUG) is used to investigate the features of outer core and pedestal (rho(pol) = 0.85-1.0) turbulence across confinement regime transitions. The I-mode confinement regime is a p ...

E D P SCIENCES2023

Improved Plasma Vertical Position Control on TCV Using Model-Based Optimized Controller Synthesis

Stefano Coda, Federico Alberto Alfredo Felici, Cristian Galperti, Federico Pesamosca

Elongated plasmas lead to improved performance in tokamaks but make the plasma prone to vertical instability, which requires active feedback control, a critical issue for future fusion reactors. Vertical control was optimized for the TCV tokamak by applyin ...

2022

Heavy impurity transport in the presence of 3D MHD ideal perturbations

Eduardo José Lascas Neto

Heavy impurity accumulation poses a problem for the operation of tokamaks featuring tungsten plasma facing components. Early termination of the plasma due to tungsten accumulation is often observed following long living 3D MHD perturbations. Such scenari ...

EPFL2022

Impact of the plasma operation on the technical requirements in EU-DEMO

Olivier Sauter, Minh Quang Tran, Hartmut Zohm, Emiliano Fable, Simon Van Mulders

The plasma design point during stationary phase operation of EU-DEMO has been described extensively in the past, and the assumptions employed for its definition have been supported by various investigations. However, a stationary snapshot is by far not suf ...

2022