Publications associées à Investigation of femtosecond laser-tuned thermomechanical properties of fused silica

Publications associées (29)

In-Sensor Passive Speech Classification with Phononic Metamaterials

Luis Guillermo Villanueva Torrijo, Daniel Moreno Garcia

Mitigating the energy requirements of artificial intelligence requires novel physical substrates for computation. Phononic metamaterials have vanishingly low power dissipation and hence are a prime candidate for green, always-on computers. However, their u ...

Wiley-V C H Verlag Gmbh2024

Influence of ionization and cumulative effects on laser-induced crystallization in multilayer dielectrics

Yves Bellouard, Victor Carle Adrien Boureau, Ruben Ricca

Crystallization of amorphous layers has been demonstrated under various radically different laser-exposure conditions, including continuous wave (cw) and pulsed lasers. Here, we investigate the specific role of ionization in the crystallization of dielectr ...

2024

Ultrahigh-quality-factor micro- and nanomechanical resonators using dissipation dilution

Tobias Kippenberg, Nils Johan Engelsen, Alberto Beccari

Mechanical resonators are widely used in sensors, transducers and optomechanical systems, where mechanical dissipation sets the ultimate limit to performance. Over the past 15 years, the quality factors in strained mechanical resonators have increased by f ...

Nature Portfolio2024

Enabling Wide Bandwidth in Substrate-Integrated Waveguide Slot Antennas by Using Low-Index Metamaterials

Romain Christophe Rémy Fleury, Amir Jafargholi

This paper presents a solution to overcome the inherently limited bandwidth of substrate-integrated waveguide (SIW) slot antennas. It is analytically shown that by decreasing the permittivity of a dielectric loaded slot antenna, the resulting bandwidth inc ...

American Physical Society (APS)2024

Femtosecond-laser direct-write photoconductive patterns on tellurite glass

Yves Bellouard, Gözden Torun

We report the formation of arbitrary photoconductive patterns made of tellurium (Te) nanocrystals by exposing a tellurite (TeO2-based) glass to femtosecond laser pulses. During this process, Te/TeO2-glass nanocomposite interfaces with photoconductive prope ...

American Physical Society (APS)2024

Modeling friction and wear using an adaptive discrete-continuum coupling

Manon Eugénie Voisin--Leprince

When two objects slide against each other, wear and friction occur at their interface. The accumulation of wear forms what is commonly referred to as a ``third-body''. Understanding third-body evolution has significant applications in industry, where contr ...

EPFL2024

Optothermal shaping of lamb waves with square and spiral phase fronts

Romain Christophe Rémy Fleury, Aleksi Antoine Bossart, Janez Rus

We introduce a Lamb-wave medium with tunable propagation velocities, which are controlled by a two-dimensional heating pattern produced by a laser beam. We utilized it to demonstrate that waves in an appropriately designed medium can propagate in the form ...

2024

Laser-based manufacturing of freeform glass micro-optics through topological transformation

Samuel Youcef Benketaf

Glass has been the material of choice for making optical elements, in large part due to its intrinsic properties: a temperature-dependent viscosity, which enables shaping the material into a broad variety of functional and artistic glassware. Silica glass ...

EPFL2024

Room-temperature quantum optomechanics using an ultralow noise cavity

Tobias Kippenberg, Guanhao Huang, Nils Johan Engelsen, Alberto Beccari

At room temperature, mechanical motion driven by the quantum backaction of light has been observed only in pioneering experiments in which an optical restoring force controls the oscillator stiffness1,2. For solid-state mechanical resonators in which oscil ...

Nature Portfolio2024

Towards Scalable Electronics: Synthetic 2D Materials for Large-Area 2D Circuit Integration

Zhenyu Wang

In the past decades, a significant increase of the transistor density on a chip has led to exponential growth in computational power driven by Moore's law. To overcome the bottleneck of traditional von-Neumann architecture in computational efficiency, effo ...

EPFL2024

All-Dielectric Nanophotonic via Glass Fluid Instabilities

Pierre-Luc Eloi Piveteau

In this thesis work, we propose to exploit an innovative micro/nano-fabrication process, based on controlled fluid instabilities of a thin viscous film of chalcogenide glass. Amorphous selenium and arsenic triselenide were used in this thesis work, and com ...

EPFL2024

Plasmonic Nanostructures for Photocatalysis: Material, Photonic and Electronic Effects

Fateme Kiani Shahvandi

Plasmonic photochemistry has a large potential to replace energy-intensive chemical processes with low-temperature, low-pressure light-driven chemical reactions. Plasmonic nanostructures have emerged as promising photocatalysts with exceptional and tunable ...

EPFL2024

Photothermal spectroscopy on-chip sensor for the measurement of a PMMA film using a silicon nitride micro-ring resonator and an external cavity quantum cascade laser

Simone Iadanza

Laser-based mid-infrared (mid-IR) photothermal spectroscopy (PTS) represents a selective, fast, and sensitive analytical technique. Recent developments in laser design permits the coverage of wider spectral regions in combination with higher power, enablin ...

Walter De Gruyter Gmbh2024

High-order geometric integrators for the variational Gaussian wavepacket dynamics and application to vibronic spectra at finite temperature

Roya Moghaddasi Fereidani

Molecular quantum dynamics simulations are essential for understanding many fundamental phenomena in physics and chemistry. They often require solving the time-dependent Schrödinger equation for molecular nuclei, which is challenging even for medium-sized ...

EPFL2024

Pyroresistive response of percolating conductive polymer composites

Claudio Grimaldi

The pyroresistive response of conductive polymer composites (CPCs) has attracted much interest because of its potential applications in many electronic devices requiring a significant responsiveness to changes in external physical parameters such as temper ...

Amer Physical Soc2024

Tomographic microscopy of functionally graded polymer-derived SiCN ceramics with tunable gradients

Jürgen Brugger, Lorenz Hagelüken

Polymer-derived ceramics (PDCs) are a very attractive class of materials due to their excellent properties such as resistance to high temperatures and harsh environments, adjustability of mechanical and functional behavior, and compatibility with a broad r ...

Elsevier Sci Ltd2024

Computational Homogenization for Inverse Design of Surface-based Inflatables

Mark Pauly, Florin Isvoranu, Francis Julian Panetta, Yingying Ren, Seiichi Eduardo Suzuki Erazo, Uday Kusupati

Surface-based inflatables are composed of two thin layers of nearly inextensible sheet material joined together along carefully selected fusing curves. During inflation, pressure forces separate the two sheets to maximize the enclosed volume. The fusing c ...

Association for Computing Machinery (ACM)2024

Design for demise applied to spacecraft structural panels and experiments for ClearSpace One platform

Alexandre Achille Looten

With growing awareness of the vulnerability of the near-Earth space region and the anticipated surge in satellite objects, efforts are underway to assess and implement various mitigation strategies. These aim to minimize the impact of space activities and ...

EPFL2024

Computational fluid dynamics simulations of the heat transfer properties of graphene-based nanolubricants and application to hydrodynamic lubrication

Roberto Guarino

In this paper, we consider experimental data available for graphene-based nanolubricants to evaluate their convective heat transfer performance by means of computational fluid dynamics (CFD) simulations. Single-phase models with temperature-dependent prope ...

Aip Publishing2024

Exciton migration in two-dimensional materials

Giovanni Consalvo Cistaro

Excitons play an essential role in the optical response of two-dimensional materials. These are bound states showing up in the band gaps of many-body systems and are conceived as quasiparticles formed by an electron and a hole. By performing real-time simu ...

Nature Portfolio2024