Publications associées à c-texture versus a-texture low pressure metalorganic chemical vapor deposition ZnO films: Lower resistivity despite smaller grain size

Font Side Solutions for c-Si Solar Cells with High-Temperature Passivating Contacts

In this work, we studied the potential of using thin films deposited by plasma-enhanced chemical vapor deposition (PECVD) for two main purposes: introducing an n-type passivating contact at the front of a TOPCon solar cell, or simplifying the fabrication o ...

EPFL2024

Towards Scalable Electronics: Synthetic 2D Materials for Large-Area 2D Circuit Integration

Zhenyu Wang

In the past decades, a significant increase of the transistor density on a chip has led to exponential growth in computational power driven by Moore's law. To overcome the bottleneck of traditional von-Neumann architecture in computational efficiency, effo ...

EPFL2024

Microstructural and electrical characterization of high temperature passivating contacts for silicon solar cells

Sofia Libraro

Recombination at metal/semiconductor interfaces represents the main limitation in mainstream c-Si solar cells, primarily based on the passivated emitter and rear cell (PERC) concept. Full-area passivating contacts based on SiOx/poly-Si stacks are a candida ...

EPFL2024

Spinel Protective Coatings for Solid Oxide Cell (SOC) Interconnects (ICs)

Samaneh Daviran

Abstract The degradation of metal interconnects (ICs) in Solid Oxide Cells (SOCs) primarily results from chromium (Cr) oxide scale growth on stainless-steel substrates, causing ohmic loss and air-side electrode poisoning by Cr. This thesis addresses these ...

EPFL2024

Plasmonically enhanced molecular junctions for investigation of atomic-scale fluctuations in self-assembled monolayers

Sakthi Priya Amirtharaj

Molecular junctions represent a fascinating frontier in the realm of nanotechnology and are one of the smallest optoelectronic devices possible, consisting of individual molecules or a group of molecules that serve as the active element sandwiched between ...

EPFL2024

Colloidal Atomic Layer Deposition on Nanocrystals Using Ligand-Modified Precursors

Raffaella Buonsanti, Anna Loiudice, Petru Pasquale Albertini, Ona Segura Lecina, Coline Marie Agathe Boulanger, Philippe Benjamin Green, Mark Adrian Newton, Krishna Kumar, Jari Leemans

Atomic layer deposition (ALD) is a method to grow thin metal oxide layers on a variety of materials for applications spanning from electronics to catalysis. Extending ALD to colloidally stable nanocrystals promises to combine the benefits of thin metal oxi ...

Amer Chemical Soc2024

Durable Perovskite Solar Cells with 24.5% Average Efficiency: The Role of Rigid Conjugated Core in Molecular Semiconductors

Michael Graetzel, Shaik Mohammed Zakeeruddin, Peng Wang, Felix Thomas Eickemeyer, Ming Ren

Efficient and robust n-i-p perovskite solar cells necessitate superior organic hole-transport materials with both mechanical and electronic prowess. Deciphering the structure-property relationship of these materials is crucial for practical perovskite sola ...

Wiley-V C H Verlag Gmbh2024

Piezoelectric and elastic properties of Al0.60Sc0.40N thin films deposited on patterned metal electrodes

Luis Guillermo Villanueva Torrijo, Silvan Stettler, Marco Liffredo, Nan Xu, Federico Peretti

Sc-doped aluminum nitride (AlScN) allows for piezoelectric devices with large electromechanical coupling and the benefits increase with larger Sc doping in the film. However, with a larger Sc concentration, the process window narrows, and it is necessary t ...

2024

Light Emission and Conductance Fluctuations in Electrically Driven and Plasmonically Enhanced Molecular Junctions

Christophe Marcel Georges Galland, Sakthi Priya Amirtharaj, Wen Chen, Konstantin Malchow

Electrically connected and plasmonically enhanced molecular junctions combine the optical functionalities of high field confinement and enhancement (cavity function), and of high radiative efficiency (antenna function) with the electrical functionalities o ...

Amer Chemical Soc2024

Photo-doping of spiro-OMeTAD for highly stable and efficient perovskite solar cells

Michael Graetzel, Jacques-Edouard Moser, Etienne Christophe Socie, Aaron Tomas Terpstra, George Cameron Fish, Kai Zhu

A widely used component of high-efficiency perovskite solar cells (PSCs) is the molecular hole-transport material (HTM) spiro-OMeTAD. This organic solid needs to be p-doped to acquire sufficient hole conductivity. However, the conventional doping method us ...

2024

Optimizing Atomic Layer Deposition Processes with Nanowire-Assisted TEM Analysis

Johann Michler, Ivo Utke, Xavier Maeder

Atomic layer deposition (ALD) is one of the premier methods to synthesize ultra-thin materials on complex surfaces. The technique allows for precise control of the thickness down to single atomic layers, while at the same time providing uniform coverage ev ...

Wiley2024

Mixed ionic-electronic conduction in Ruddlesden-Popper and Dion-Jacobson layered hybrid perovskites with aromatic organic spacers

Michael Graetzel, Davide Moia, Joachim Maier, Jovana Milic, Algirdas Ducinskas, Mina Jung

The understanding of mixed ionic-electronic conductivity in hybrid perovskites has enabled major advances in the development of optoelectronic devices based on this class of materials. While recent investigations revealed the potential of using dimensional ...

Royal Society of Chemistry2024

Alleviating nanostructural phase impurities enhances the optoelectronic properties, device performance and stability of cesium-formamidinium metal-halide perovskites

Christophe Ballif, Aïcha Hessler-Wyser, Quentin Thomas Jeangros, Beat Ruhstaller, Mostafa Rabie Shlaly Bahr Othman, Daniel Anthony Jacobs, Christian Michael Wolff, Anaël Morgane Jaffrès, Austin George Kuba

The technique of alloying FA+ with Cs+ is often used to promote structural stabilization of the desirable alpha-FAPbI3 phase in halide perovskite devices. However, the precise mechanisms by which these alloying approaches improve the optoelectronic quality ...

Royal Soc Chemistry2024

Study of growth-induced point defects and their impact on InGaN-based optoelectronic devices

Yao Chen

GaN exhibits a decomposition tendency for temperatures far below its melting point and common growth temperatures used in metal-organic vapour phase epitaxy (MOVPE).This characteristic is known to be a major obstacle for realising GaN bulk substrate. There ...

EPFL2024

Pyroresistive response of percolating conductive polymer composites

Claudio Grimaldi

The pyroresistive response of conductive polymer composites (CPCs) has attracted much interest because of its potential applications in many electronic devices requiring a significant responsiveness to changes in external physical parameters such as temper ...

Amer Physical Soc2024

Strain relaxation and multidentate anchoring in n-type perovskite transistors and logic circuits

Mohammad Khaja Nazeeruddin, Olga Syzgantseva

The engineering of tin halide perovskites has led to the development of p-type transistors with field-effect mobilities of over 70 cm2 V-1 s-1. However, due to their background hole doping, these perovskites are not suitable for n-type transistors. Ambipol ...

Nature Portfolio2024

Axial-Equatorial Halide Ordering in Layered Hybrid Perovskites from Isotropic-Anisotropic 207Pb NMR

Manuel Cordova, David Lyndon Emsley, Aditya Mishra, Michael Allan Hope, Ümmügülsüm Günes

Bandgap-tuneable mixed-halide 3D perovskites are of interest for multi-junction solar cells, but suffer from photoinduced spatial halide segregation. Mixed-halide 2D perovskites are more resistant to halide segregation and are promising coatings for 3D per ...

Wiley-VCH Verlag GmbH2024

Supramolecular interactions using β-cyclodextrin in controlling perovskite solar cell performance

Jun Ho Yum, Kevin Sivula, Jiyoun Seo, Parnian Ferdowsi

In the context of perovskite solar cells (PSCs), enhancing device performance often involves adding a small excess of lead iodide (PbI2) to the precursor solution. However, the presence of unreacted PbI2 can lead to accelerated degradation compromising lon ...

Royal Society of Chemistry2024

Influence of Ventilation on Formation and Growth of 1-20 nm Particles via Ozone-Human Chemistry

Dusan Licina, Shen Yang, Marouane Merizak, Meixia Zhang

Ozone reaction with human surfaces is an important source of ultrafine particles indoors. However, 1-20 nm particles generated from ozone-human chemistry, which mark the first step of particle formation and growth, remain understudied. Ventilation and indo ...

Amer Chemical Soc2024

A thermotropic liquid crystal enables efficient and stable perovskite solar modules

Mohammad Khaja Nazeeruddin, Bin Ding, Jian Xu, Yong Ding, Cheng Liu

Perovskite solar cells have seen impressive progress in performance and stability, yet maintaining efficiency while scaling area remains a challenge. Here we find that additives commonly used to passivate large-area perovskite films often co-precipitate du ...

Nature Portfolio2024