Publications associées à Novel thin and compact H-plane SIW horn antenna

Enabling Wide Bandwidth in Substrate-Integrated Waveguide Slot Antennas by Using Low-Index Metamaterials

Romain Christophe Rémy Fleury, Jalaledin Tayebpour, Amir Jafargholi

This paper presents a solution to overcome the inherently limited bandwidth of substrate-integrated waveguide (SIW) slot antennas. It is analytically shown that by decreasing the permittivity of a dielectric loaded slot antenna, the resulting bandwidth inc ...

American Physical Society (APS)2024

Biomaterial devices on Arecanut palm leaf for microwave applications

Anja Skrivervik, Sujith Raman

This paper presents an investigation on the possibility of arecanut palm leaf as a biomaterial substrate for various microwave devices such as transmission lines, antenna, filter and a radio frequency identification device (RFID). The dielectric properties ...

IEEE2023

4-Port Microstrip planar resonator for multiband microwave material characterization applications

Anja Skrivervik, Sujith Raman

Planar microstrip resonators suitable for material characterization application are presented in this paper. The prototype consists of three resonators fed through four ports in a planar dielectric substrate without any additional resonators. The resonator ...

IEEE2022

Smooth GaN membranes by polarization-assisted electrochemical etching

Jean-François Carlin, Nicolas Grandjean, Joachim Armand Simonne Ciers

III-nitride membranes offer promising perspectives and improved device designs in photonics, electronics, and optomechanics. However, the removal of the growth substrate often leads to a rough membrane surface, which increases scattering losses in optical ...

AMER INST PHYSICS2021

Broadband Nonreciprocal Acoustic Propagation Using Programmable Boundary Conditions: From Analytical Modeling to Experimental Implementation

Etienne Thierry Jean-Luc Rivet, Sami Driss Karkar, Gaël Matten

We theoretically, numerically and experimentally demonstrate the acoustic isolator effect in a one-dimensional waveguide with direction-dependent controlled boundary conditions. A theoretical model is used to explain the principle of nonreciprocal propagat ...

American Physical Society (APS)2019

Two-Element Antenna-Active Phase Shifter Packaging at 77 GHz

Anja Skrivervik, Efe Öztürk

This work presents a low cost and wire-bonded active phase shifter chip to RF circuitry on PCB board packaging for implementing a two-element phased array antenna at 77 GHz. The 1.5 mm × 1.1 mm chip is embedded in RO3003 PCB board and its GSG ports are wir ...

IEEE2019

Wideband H-plane dielectric horn antenna

Juan Ramon Mosig, Maria Garcia Vigueras, Lei Wang, Marcos Alvarez Folgueiras

By flaring a dielectric waveguide in the H-plane, an H-plane dielectric horn is formed, which could be directly excited by an SIW feed. However, matching and radiation performances are poor due to the thinness of the substrate. To improve these performance ...

Inst Engineering Technology-Iet2017

Exciton-polariton flows in cross-dimensional junctions

Hugo Pierre Alexandre Flayac

We study the nonequilibrium exciton-polariton condensation in 1D to 0D and 1D to quasi-2D junctions by means of non-resonant spectroscopy. The shape of our potential landscape allows to probe the resonant transmission of a propagating condensate between a ...

Amer Physical Soc2017

Phase Corrected H-Plane Horn Antenna in Gap SIW Technology

Juan Ramon Mosig, Marc Esquius Morote, Lei Wang

This communication introduces a modified substrate integrated waveguide (SIW), the gap SIW, and deduces an approximate closed-form expression for calculating its effective width, taking into account the fringing and coupling fields around the gap. As an im ...

Ieee-Inst Electrical Electronics Engineers Inc2017

Design of Compact Air-Vias-Perforated SIW Horn Antenna With Partially Detached Broad Walls

Lei Wang

A novel substrate-integrated waveguide (SIW) horn antenna with partially detached broad walls is designed and analyzed. The conventional SIW horn antenna suffers from narrow-operating bandwidth, which mainly results from the mismatch at the horn aperture b ...

Ieee-Inst Electrical Electronics Engineers Inc2016

Excitation of resonant plasmonic cavities by integrated waveguides for sensing applications

Gaël David Osowiecki

Optical sensors represent a large growing market which is nowadays focusing onto advancement in mobile technology. Innovations in the field of optical sensors are mostly driven by the technological advancements in the domain of micro & nanofabrication. One ...

EPFL2016

Compact Microstrip Feedings with an Elevated Ground Plane for Thick Folded SIW

Juan Ramon Mosig, Lei Wang, Qi Wu

Folded substrate integrated waveguide (FSIW) has been proposed for further size reduction, while keeping the advantages of traditional SIW. FSIW-based horn antennas are very promising in millimeter wave applications. To improve the bandwidth and efficiency ...

Ieee2016

Horn Antennas and Dual-Polarized Circuits in Substrate Integrated Waveguide (SIW) Technology

Marc Esquius Morote

The Substrate Integrated Waveguide (SIW) technology is a very promising candidate to provide widespread commercial solutions for modern communications systems. Its main advantage is the possibility to integrate passive/active components and antennas in the ...

EPFL2014

Rigorous evaluation of propagation losses in arbitrarily shaped waveguide structures using boundary integral – resonant mode expansion and perturbation of boundary conditions

Michael Mattes

The accurate consideration of propagation losses in arbitrarily shaped waveguide-based structures is studied in this paper. For such a purpose, a software tool based on the perturbation of the boundary conditions on the waveguide metallic walls and on the ...

Inst Engineering Technology-Iet2014

Orthomode transducer for dual polarized substrate integrated circuits and antennas

Juan Ramon Mosig, Michael Mattes, Marc Esquius Morote

A complete dual polarized substrate integrated structure is presented. It comprises planar excitation schemes for both orthogonal TE10 and TE01 modes along with an orthomode transducer (OMT) to combine/split them. The whole structure is compact (only 2 lay ...

2014

Feeding structure influence on performance of two UWB antennas near a human arm

Anja Skrivervik, Mohsen Koohestani

This paper reports a study of the feeding structure influence on impedance matching and system fidelity factor of two loaded UWB antennas when placed near a human arm. To this aim, two identical dielectric loaded versions of the same UWB antenna designs wi ...

2014

A printed transition for matching improvement of SIW horn antennas

Juan Ramon Mosig, Jean-François Zürcher, Benjamin Fuchs, Marc Esquius Morote

The substrate integrated waveguide (SIW) technology allows to construct several types of commonly used antennas in a planar way. However, frequency limitations associated to commercial substrates appear in the implementation of certain types of antennas, e ...

Institute of Electrical and Electronics Engineers2013

Ka-Band Rectangular Waveguide to Suspended Stripline Transition

Juan Ramon Mosig, Jean-François Zürcher, Rafal Glogowski

A Ka-band transition between a rectangular waveguide and a suspended stripline (SSL) is proposed. It uses a configuration in which the SSL substrate is perpendicular to the waveguide main axis. A patch printed on the SSL substrate is used to match the char ...

Institution of Engineering and Technology2013

A Low-Loss Planar Ka-Band Antenna Subarray for Space Applications

Juan Ramon Mosig, Jean-François Zürcher, Rafal Glogowski

This paper presents the design, optimization, and experimental characterization of a planar antenna subarray for space applications. The proposed component is intended to be used as a building block for a large Ka-band antenna systems. It is a one-dimensio ...

Institute of Electrical and Electronics Engineers2013

Practical issues related to the design of UWB directional couplers in strip line technology

Juan Ramon Mosig, Baptiste Fernand Hornecker

Recently, the study of slot-coupled directional couplers has led to compact and elegant topologies for UWB applications. The most common design consists in two elliptically shaped lines coupled through an elliptically shaped slot in a common ground plane. ...

Ieee2013