Publications associées à Experimental evaluation and modeling of fatigue of a 316L austenitic stainless steel in high-temperature water and air environments

Publications associées (34)

Deciphering tensile fatigue behavior of UHPFRC using magnetoscopy, DIC and acoustic emission

Eugen Brühwiler, Alain Nussbaumer, Jian Zhan

To explore the governing mechanism underlying the tensile fatigue behavior of Ultra-high Performance Fiber Reinforced Cementitious Composites (UHPFRC), this study tested eight specimens using four advanced non-destructive measurement techniques. First, mag ...

2025

Time-Dependent Deformation of Sandstone due to Chemical Corrosion: An Investigation Using the Heterogeneous Grain-Based Phase-Field Method

Alexandra Roma Larisa Kushnir

Fractures are diverse geological features. Despite extensive research on their varied geometries and growth mechanisms, there has been relatively little focus on how acid-rock interactions, such as reactive transport and precipitation, influence crack grow ...

SPRINGER WIEN2025

Influence of the Horizontal-to-Vertical Compressive Strength of Hollow Clay Bricks on the In-Plane Drift Capacity of Unreinforced Masonry Walls

Katrin Beyer, Savvas Saloustros, Ernesto Andrés Inzunza Araya

The seismic damage of masonry walls is reflected in cracks that tend to start at the head and bed joints and subsequently propagates through the masonry units. In this regard, the horizontal-to-vertical compressive strength ratio of bricks might have the a ...

2025

Fluid Chemistry Effect on Localized and Ductile Deformation of a Porous Sandstone

Marie Estelle Solange Violay, Gabriel Gérard Dominique Meyer, Francesco Lazari

In geological reservoirs, pore fluid chemistry can affect rock strength by inducing mineral dissolution, precipitation, and alteration, among other processes. Increasing pressure and temperature can shift deformation from localized to ductile, decreasing p ...

2025

Dataset for "Complexity of crack front geometry enhances toughness of brittle solids"

John Martin Kolinski, Chenzhuo Li, Xinyue Wei

This data package supports the publication 'Complexity of crack front geometry enhances toughness of brittle solids' by Xinyue Wei, Chenzhuo Li, Cían McCarthy, and John M. Kolinski Nature physics (2024) - https://doi.org/10.1038/s41567-024-02435-x DOI: 1 ...

Zenodo2024

Strain engineering and strain measurement by spring tethers on suspended epitaxial GaN-on-Si photonic crystal devices

Romuald Houdré, Jun Wang

Suspended epitaxial gallium nitride (GaN) on silicon (Si) photonic crystal devices suffer from large residual tensile strain, especially for long waveguides, because fine structures tend to crack due to large stress. By introducing spring-like tethers, des ...

Iop Publishing Ltd2024

Two-dimensional quasi-static delamination in composite laminates under Mode-I and Mode-II conditions

Congzhe Wang

Fiber-polymer composites consist of a polymer matrix and reinforcing fibers made of various materials. These composites exhibit exceptional properties, such as a high strength-to-weight ratio and excellent corrosion resistance, which has led to their incre ...

EPFL2024

A novel fatigue life prediction methodology based on energy dissipation in viscoelastic materials, synergistic effects of stress level, stress ratio, and temperature

Thomas Keller, Lulu Liu, Abdolvahid Movahedirad

This work introduces a new methodology to predict the fatigue life of viscoelastic materials by considering the creep effect on fatigue behavior under the concurrent effects of stress level, stress ratio, and temperature. The model established based on the ...

2024

Influence of fiber orientation on the tensile behavior of UHPFRC and reinforced UHPFRC under static and fatigue loadings

Jian Zhan

Ultra-high performance fiber reinforced cementitious composite (UHPFRC) is a modern class of cementitious building materials. Because of its superior mechanical properties and durability, it is increasingly used globally to rehabilitate, strengthen and mod ...

EPFL2024

Numerical investigation of two-dimensional Mode-II delamination in composite laminates

Thomas Keller, Anastasios Vassilopoulos, Congzhe Wang

Existing standards for delamination tests on composite materials typically employ one-dimensional (1D) beam specimens. However, such specimens may not represent real delamination scenarios in composite structures, where cracks tend to propagate in two dime ...

Elsevier Sci Ltd2024

Neutron-Gamma Noise Measurements in a Zero-Power Reactor Using Organic Scintillators

Andreas Pautz, Vincent Pierre Lamirand, Oskari Ville Pakari

Noise measurements in light water reactor systems aid in generating validation data for integral point kinetic parameter predictions and generating monitoring parameters for reactor safety and safeguards. The CROCUS zero-power reactor has been used to supp ...

Ieee-Inst Electrical Electronics Engineers Inc2024

Design and assessment of an evaporating water-cooled methanation reactor for a SOE-based power-to-methane system

Philippe Aubin

The transition towards clean renewable energy sources, where wind and solar are prone to variation, requires adequate energy storage. Power-to-methane (PtM) systems can be part of the solution. Specifically, solid-oxide-electrolyser (SOE) based PtM systems ...

EPFL2024

Strain-based analysis on the influence of local undercut geometry on fatigue crack initiation life

Alain Nussbaumer

The local undercut defects at the weld toe provide a potential initiation site for fatigue cracks and significantly impact the structure's fatigue strength. The influence of continuous undercut depth on fatigue performance is widely studied, but the resear ...

2024

Gamma noise to non-invasively monitor nuclear research reactors

Andreas Pautz, Vincent Pierre Lamirand, Oskari Ville Pakari, Pavel Frajtag, Tom Mager

Autonomous nuclear reactor monitoring is a key aspect of the International Atomic Energy Agency’s strategy to ensure nonproliferation treaty compliance. From the rise of small modular reactor technology, decentralized nuclear reactor fleets may strain the ...

Nature Research2024

Microsecond Time-Resolved Cryo-Electron Microscopy

Oliver Florian Harder

Recently, single-particle cryo-electron microscopy emerged as a technique capable of determining protein structures at near-atomic resolution and resolving protein dynamics with a temporal resolution ranging from second to milliseconds. This thesis describ ...

EPFL2024

Structural study of nickelate based heterostructures

Duncan Thomas Lindsay Alexander, Bernat Mundet, Chih-Ying Hsu

Heterostructures consisting of SmNiO3 and NdNiO3 alternating layers with additional LaAlO3 spacer layers were grown and fully characterized by means of x-ray diffraction, atomic force microscopy, and scanning transmission electron microscopy. A change in t ...

Aip Publishing2024

Nanoindentation hardness and modulus of Al2O3-SiO2-CaO and MnO-SiO2-FeO inclusions in iron

Eva Luisa Vogt, Jonathan Aristya Setyadji, Andreas Mortensen, Léa Deillon, Alejandra Inés Slagter, David Hernandez Escobar

Dataset corresponding to the following manuscript: Slagter, A., Setyadji, J.A., Vogt, E.L. et al. Nanoindentation Hardness and Modulus of Al2O3–SiO2–CaO and MnO–SiO2–FeO Inclusions in Iron. Metall Mater Trans A (2024). https://doi.org/10.1007/s11661-024-0 ...

Zenodo2024

Data set for control of Ge island coalescence for the formation of nanowires on silicon

Anna Fontcuberta i Morral, Alok Rudra, Santhanu Panikar Ramanandan, Joel René Sapera

This document contains all the data and the details of the analysis used in the manuscript titled " Control of Ge island coalescence for the formation of nanowires on silicon." https://doi.org/10.1039/D3NH00573A ...

EPFL Infoscience2024

Dataset for '3D printing of customizable transient bioelectronics and sensors'

Danick Briand, Nicolas Francis Fumeaux

This data set contains the data collected during the FNS project Green Piezo (Grant no. 179064) in association with the recent publication entitled “3D printing of customizable transient bioelectronics and sensors”. This work aims to study and demonstrate ...

Zenodo2024

Data and scripts for the RaFSIP scheme

Athanasios Nenes, Paraskevi Georgakaki

This repository contains microphysics routines, scripts, and processed data from the Weather Research and Forecasting (WRF) model simulations presented in the paper "RaFSIP: Parameterizing ice multiplication in models using a machine learning approach", by ...

Zenodo2024