Publications associées à Gallium‐Based Thin Films for Wearable Human Motion Sensors

Publications associées (39)

Efficient Polycrystalline Single-Cation Perovskite Light-Emitting Diodes by Simultaneous Intracrystal and Interfacial Defect Passivation

Polycrystalline perovskite light-emitting diodes (PeLEDs) have shown great promise with high efficiency and easy processability. However, PeLEDs using single-cation polycrystalline perovskite emitters have demonstrated low efficiency due to defects within ...

2025

Plasma-irradiated hafnia ferroelectrics for high-performance flexible thin film transistors

Arindam Bala

Integrating unconventional HfO2-based ferroelectrics in thin film transistors (TFTs) has proven effective in enhancing performance by stabilizing negative capacitance (NC). This is achieved by incorporating the ferroelectric in series with a high-permittiv ...

2025

Direct laser writing of electronically conductive microstructures within soft hydrogel substrates

Veronica Navello, Stéphanie Lacour, Esther Amstad, Outman Akouissi, Lorenzo Lucherini

Hydrogels have emerged as promising materials for bioelectronic interfaces due to their tissue-like properties and high-water content. However, conventional hydrogels often suffer from poor electrical conductivity and mechanical stability, limiting their p ...

2025

Direct high-temperature MOCVD growth of GaN on foreign substrates

Alessandro Floriduz

GaN-based devices are ubiquitous in everyday life, ranging from InGaN/GaN light-emitting diodes (LEDs) for illumination to AlGaN/GaN high-electron-mobility transistors for compact power supplies. Nevertheless, despite the tremendous development in the past ...

EPFL2024

Nanostructure and Optical Property Tailoring of Zinc Tin Nitride Thin Films through Phenomenological Decoupling: A Pathway to Enhanced Control

Aïcha Hessler-Wyser, Johann Michler, Caroline Hain, Daniele Casari

This work addresses the need for precise control of thin film sputtering processes to enable thin film material tailoring on the example of zinc tin nitride (ZTN) thin films deposited via microwave plasma-assisted high power reactive magnetron sputtering ( ...

Amer Chemical Soc2024

Phase-stable indium sulfide achieves an energy conversion efficiency of 14.3% for solar-assisted carbon dioxide reduction to formate

Michael Graetzel, Jingshan Luo, Jing Gao, Jun Li

Tremendous efforts have been made in developing highly selective catalysts for electrochemical CO 2 conversion to formate. However, the rapid deactivation resulting from structural reconstruction and phase transition poses considerable challenges to the sy ...

Cell Press2024

Infrared-reflective ultrathin-metal-film-based transparent electrode with ultralow optical loss for high efficiency in solar cells

Michael Graetzel, Georgios Kakavelakis

In this work we study in-depth the antireflection and filtering properties of ultrathin-metal-film-based transparent electrodes (MTEs) integrated in thin-film solar cells. Based on numerical optimization of the MTE design and the experimental characterizat ...

Nature Portfolio2024

III-N blue-emitting epi-structures with high densities of dislocations: Fundamental mechanisms for efficiency improvement and applications

Pierre Christophe Lottigier

Since the dawn of humanity, human beings seeked to light their surroundings for their well-being, security and development. The efficiency of ancient lighting devices, e.g. oil lamps or candles, was in the order of 0.03-0.04% and jumped to 0.4-0.6% with th ...

EPFL2024

Study of growth-induced point defects and their impact on InGaN-based optoelectronic devices

Yao Chen

GaN exhibits a decomposition tendency for temperatures far below its melting point and common growth temperatures used in metal-organic vapour phase epitaxy (MOVPE).This characteristic is known to be a major obstacle for realising GaN bulk substrate. There ...

EPFL2024

M2SKD: Multi-to-Single Knowledge Distillation of Real-Time Epileptic Seizure Detection for Low-Power Wearable Systems

David Atienza Alonso, Amir Aminifar, Tomas Teijeiro Campo, Alireza Amirshahi, Saleh Baghersalimi, Farnaz Forooghifar

Integrating low-power wearable systems into routine health monitoring is an ongoing challenge. Recent advances in the computation capabilities of wearables make it possible to target complex scenarios by exploiting multiple biosignals and using high-perfor ...

2024

Generalization and Personalization of Machine Learning for Multimodal Mobile Sensing in Everyday Life

Lakmal Buddika Meegahapola

A range of behavioral and contextual factors, including eating and drinking behavior, mood, social context, and other daily activities, can significantly impact an individual's quality of life and overall well-being. Therefore, inferring everyday life aspe ...

EPFL2024

Advanced Modeling and Simulation of Luminescence Phenomena in Perovskite Semiconductors

Simon Jérôme Zeder

The utilization of MHPs in optoelectronics has surged over the past decade due to their favorable properties such as direct band gaps, a large JDOS near the band edge resulting in strong optical absorption, and high defect tolerance allowing operation clos ...

EPFL2024

Indoor Self-Powered Perovskite Optoelectronics with Ultraflexible Monochromatic Light Source

Hiroaki Jinno, Felix Thomas Eickemeyer, Lukas Pfeifer

Self-powered skin optoelectronics fabricated on ultrathin polymer films is emerging as one of the most promising components for the next-generation Internet of Things (IoT) technology. However, a longstanding challenge is the device underperformance owing ...

Wiley-V C H Verlag Gmbh2023

Additively manufactured stretchable zipping electrostatic actuators

Giulio Grasso

The use of soft and stretchable materials allows the development of adaptive robotic systems and human-machine interfaces that are more natural and comfortable to interact with. One of the application fields that benefits the most from these compliant mate ...

EPFL2024

Semiconductor-based device architectures in multimaterial fibers

William Nicolas Duncan Esposito

Semiconductor materials have given rise to today's digital technology and consumer electronics. Widespread adoption is closely linked to the ability to process and integrate them in devices at scale. Where flexibility and large surfaces are required, such ...

EPFL2023

Colloidal Atomic Layer Deposition on Nanocrystals Using Ligand-Modified Precursors

Raffaella Buonsanti, Anna Loiudice, Petru Pasquale Albertini, Ona Segura Lecina, Philippe Benjamin Green, Jari Leemans, Mark Adrian Newton, Coline Marie Agathe Boulanger, Krishna Kumar

Atomic layer deposition (ALD) is a method to grow thin metal oxide layers on a variety of materials for applications spanning from electronics to catalysis. Extending ALD to colloidally stable nanocrystals promises to combine the benefits of thin metal oxi ...

Amer Chemical Soc2024

Microstructural and electrical characterization of high temperature passivating contacts for silicon solar cells

Sofia Libraro

Recombination at metal/semiconductor interfaces represents the main limitation in mainstream c-Si solar cells, primarily based on the passivated emitter and rear cell (PERC) concept. Full-area passivating contacts based on SiOx/poly-Si stacks are a candida ...

EPFL2024

Scalable Approaches to III-V Nanowires for Photodetection

Nicholas Paul Morgan

III-V semiconductor nanowires have unique properties that make them ideal for advanced photodetectors on inexpensive substrates. For example, they exhibit enhanced or polarization-dependent light absorption, they can form complex heterostructures, and thei ...

EPFL2023

On-Demand Cross-Linkable Bottlebrush Polymers for Voltage- Driven Artificial Muscles

Frank Nüesch, Francis Owusu, Yeerlan Adeli

Dielectric elastomer actuators (DEAs) generate motion resembling natural muscles in reliability, adaptability, elongation, and frequency of operation. They are highly attractive in implantable soft robots or artificial organs. However, many applications of ...

AMER CHEMICAL SOC2023

Alleviating nanostructural phase impurities enhances the optoelectronic properties, device performance and stability of cesium-formamidinium metal-halide perovskites

Anaël Morgane Jaffrès, Christophe Ballif, Quentin Thomas Jeangros, Aïcha Hessler-Wyser, Christian Michael Wolff, Mostafa Rabie Shlaly Bahr Othman, Daniel Anthony Jacobs, Austin George Kuba

The technique of alloying FA+ with Cs+ is often used to promote structural stabilization of the desirable alpha-FAPbI3 phase in halide perovskite devices. However, the precise mechanisms by which these alloying approaches improve the optoelectronic quality ...

Royal Soc Chemistry2024