Publications associées à Reduction in the Interfacial Trap Density of Mechanochemically Synthesized MAPbI(3)

Publications associées (43)

Tuning Electronic and Optical Properties of 2D/3D Interfaces of Hybrid Perovskites through Interfacial Charge Transfer: Prediction of Higher-Efficiency Interface Solar Cells Using Hybrid-DFT Methods

The 2D/3D or 2D/quasi-2D composite mixed-dimensional construction of hybrid perovskite interfaces is gaining increasing attention due to their enhanced stability toward degradation without compromising the corresponding solar cell efficiency. Much of this ...

AMER CHEMICAL SOC2025

Buried Hole-selective Interface Engineering for High-efficiency Tin-lead Perovskite Solar Cells with Enhanced Interfacial Chemical Stability

Guixiang Li

Mixed Sn-Pb perovskites are attracting significant attention due to their narrow bandgap and consequent potential for all-perovskite tandem solar cells. However, the conventional hole transport materials can lead to band misalignment or induce degradation ...

ELSEVIER2025

High‐Efficiency Sn‐Pb Perovskite Solar Cells via Nucleation and Crystallization Control

Mohammad Khaja Nazeeruddin

The rapid crystallization of mixed tin‐lead (Sn‐Pb) perovskites and their dependence on antisolvent processes limit the development of large‐area Sn‐Pb perovskite solar cells (PSCs). Vacuum‐flash‐assisted solution processing (VASP) has emerged as a promisi ...

Wiley2025

Template-Assisted Growth of CsxFA1-xPbI3 with Pulsed Laser Deposition for Single Junction Perovskite Solar Cells

Christian Michael Wolff, Kerem Artuk

Cesium-formamidinium lead iodide (CsxFA1-xPbI3) perovskites are a promising methylammonium-free alternative for efficient single-junction solar cells. However, they have not been fully explored by vapor-phase deposition techniques. Herein, a template-assis ...

2025

Efficient Polycrystalline Single-Cation Perovskite Light-Emitting Diodes by Simultaneous Intracrystal and Interfacial Defect Passivation

Mohammad Khaja Nazeeruddin, Emad Oveisi

Polycrystalline perovskite light-emitting diodes (PeLEDs) have shown great promise with high efficiency and easy processability. However, PeLEDs using single-cation polycrystalline perovskite emitters have demonstrated low efficiency due to defects within ...

2025

Enhancing Indoor Photovoltaic Eﬃciency to 37.6% Through Triple Passivation Reassembly and n-Type to p-Type Modulation in Wide Bandgap Perovskites

Michael Graetzel, Lukas Pfeifer

Despite well‐matching indoor illumination spectra, the performance of wide bandgap perovskite solar cells (WB‐PSCs) for indoor photovoltaics (i‐PV) is hindered by photo‐induced halide phase segregation and trap‐assisted non‐radiative recombination. Herein, ...

Wiley2025

Beyond Flat: Undulated Perovskite Solar Cells on Microscale Si Pyramids by Solution Processing

Christophe Ballif, Aïcha Hessler-Wyser, Christian Michael Wolff, Kerem Artuk, Mostafa Rabie Shlaly Bahr Othman, Deniz Türkay

Microscale pyramids of silicon solar cells are often considered incompatible with solution-processed perovskite films. Thus, solution processing has mainly been used with submicron pyramids that are buried under thick perovskite films with flattened front ...

AMER CHEMICAL SOC2025

Nanowire morphology control in Sb metal-derived antimony selenide photocathodes for solar water splitting

Wenzhe Niu

We report a facile method to enhance the photoelectrochemical (PEC) performance of Sb2Se3 photocathodes by controlling the growth of bilayer Sb2Se3 consisting of vertically oriented nanorods on a compact Sb2Se3 layer. Sb2Se3 thin films with controllable na ...

Royal Society of Chemistry2025

Alleviating nanostructural phase impurities enhances the optoelectronic properties, device performance and stability of cesium-formamidinium metal-halide perovskites

Anaël Morgane Jaffrès, Christophe Ballif, Quentin Thomas Jeangros, Aïcha Hessler-Wyser, Christian Michael Wolff, Mostafa Rabie Shlaly Bahr Othman, Daniel Anthony Jacobs, Austin George Kuba

The technique of alloying FA+ with Cs+ is often used to promote structural stabilization of the desirable alpha-FAPbI3 phase in halide perovskite devices. However, the precise mechanisms by which these alloying approaches improve the optoelectronic quality ...

Royal Soc Chemistry2024

Unlocking high-performance photocapacitors for edge computing in low-light environments

Michael Graetzel, Sandy Sanchez Alonso

Driving continuous, low-power artificial intelligence (AI) in the Internet of Things (IoT) requires reliable energy harvesting and storage under indoor or low-light conditions, where batteries face constraints such as finite lifetimes and increased environ ...

2025

Enhanced performance of perovskite solar cell via up-conversion YLiF4:Yb, Er nanoparticles

Mounir Driss Mensi, Masaud Hassan S Almalki, Anwar Qasem M Alanazi

We report a simple and effective method for producing lanthanide ion-doped lithium-fluoride-based nanocrystals (YLiF4). We utilized those nanoparticles for up-conversion in fabricated perovskite solar cells. The obtained results shows that the up-conversio ...

Elsevier2024

Plasma-irradiated hafnia ferroelectrics for high-performance flexible thin film transistors

Arindam Bala

Integrating unconventional HfO2-based ferroelectrics in thin film transistors (TFTs) has proven effective in enhancing performance by stabilizing negative capacitance (NC). This is achieved by incorporating the ferroelectric in series with a high-permittiv ...

2025

A thermotropic liquid crystal enables efficient and stable perovskite solar modules

Mohammad Khaja Nazeeruddin, Bin Ding, Yong Ding

Perovskite solar cells have seen impressive progress in performance and stability, yet maintaining efficiency while scaling area remains a challenge. Here we find that additives commonly used to passivate large-area perovskite films often co-precipitate du ...

Nature Portfolio2024

Encapsulation strategies for mechanical impact and damp heat reliability improvement of lightweight photovoltaic modules towards vehicle-integrated applications

Fabiana Lisco

Lightweight modules are essential for next-generation vehicle-integrated photovoltaic (VIPV) applications, such as solar-powered cars, allowing integration of solar cells beyond the roof, and on the hood, boot and body panels, and thereby extending the dri ...

Elsevier2024

A comprehensive physical model for the sensitivity of silicon heterojunction photovoltaic modules to water ingress

Christophe Ballif, Alessandro Francesco Aldo Virtuani, Luca Gnocchi, Olatz Arriaga Arruti

Silicon heterojunction (SHJ)-solar modules-when encapsulated with ethylene vinyl acetate (EVA)-are known to be extremely sensitive to water ingress. The reason for this is, however, not clear. Here, we explain the root causes of this degradation mechanism ...

Cell Press2024

Axial-Equatorial Halide Ordering in Layered Hybrid Perovskites from Isotropic-Anisotropic 207Pb NMR

David Lyndon Emsley, Aditya Mishra, Michael Allan Hope, Manuel Cordova, Ümmügülsüm Günes

Bandgap-tuneable mixed-halide 3D perovskites are of interest for multi-junction solar cells, but suffer from photoinduced spatial halide segregation. Mixed-halide 2D perovskites are more resistant to halide segregation and are promising coatings for 3D per ...

Wiley-VCH Verlag GmbH2024

Tracking deep-level defects in degrading perovskite solar cells with a multifactorial approach

Vivek Subramanian

In this work, we provide a mechanistic understanding of the degradation of perovskite solar cells in operation by focusing on methylammonium lead triiodide (CH3NH3PbI3 or MAPbI3) and tracking the evolution of electronic defects via photo-induced current tr ...

Elsevier2024

Multifunctional sulfonium-based treatment for perovskite solar cells with less than 1% efficiency loss over 4,500-h operational stability tests

Ulf Anders Hagfeldt, Bowen Yang, Jiajia Suo, Yeonju Kim

The stabilization of grain boundaries and surfaces of the perovskite layer is critical to extend the durability of perovskite solar cells. Here we introduced a sulfonium-based molecule, dimethylphenethylsulfonium iodide (DMPESI), for the post-deposition tr ...

Nature Portfolio2024

Synergistic Redox Modulation for High-Performance Nickel Oxide-Based Inverted Perovskite Solar Modules

Mohammad Khaja Nazeeruddin, Bin Ding, Xianfu Zhang

Nickel oxide (NiOx)-based inverted perovskite solar cells stand as promising candidates for advancing perovskite photovoltaics towards commercialization, leveraging their remarkable stability, scalability, and cost-effectiveness. However, the interfacial r ...

Wiley2024

Font Side Solutions for c-Si Solar Cells with High-Temperature Passivating Contacts

Ezgi Genç

In this work, we studied the potential of using thin films deposited by plasma-enhanced chemical vapor deposition (PECVD) for two main purposes: introducing an n-type passivating contact at the front of a TOPCon solar cell, or simplifying the fabrication o ...

EPFL2024