Touradj EbrahimiTouradj EBRAHIMI received his M.Sc. and Ph.D., both in Electrical Engineering, from the Swiss Federal Institute of Technology (EPFL), Lausanne, Switzerland, in 1989 and 1992 respectively. In 1993, he was a research engineer at the Corporate Research Laboratories of Sony Corporation in Tokyo, where he conducted research on advanced video compression techniques for storage applications. In 1994, he served as a research consultant at AT&T Bell Laboratories working on very low bitrate video coding. He is currently Professor at EPFL heading its Multimedia Signal Processing Group. He is also the Convenor of JPEG standardization Committee. He was also adjunct Professor with the Center of Quantifiable Quality of Service at Norwegian University of Science and Technology (NTNU)between 2008 and 2012.
Prof. Ebrahimi has been the recipient of various distinctions and awards, such as the IEEE and Swiss national ASE award, the SNF-PROFILE grant for advanced researchers, Four ISO-Certificates for key contributions to MPEG-4 and JPEG 2000, and the best paper award of IEEE Trans. on Consumer Electronics . He became a Fellow of the international society for optical engineering (SPIE) in 2003. Prof. Ebrahimi has initiated more than two dozen National, European and International cooperation projects with leading companies and research institutes around the world. He is a co-founder of Genista SA, a high-tech start-up company in the field of multimedia quality metrics. In 2002, he founded Emitall SA, start-up active in the area of media security and surveillance. In 2005, he founded EMITALL Surveillance SA, a start-up active in the field of privacy and protection. He is or has been associate Editor with various IEEE, SPIE, and EURASIP journals, such as IEEE Signal Processing Magazine, IEEE Trans. on Image Processing, IEEE Trans. on Multimedia, EURASIP Image Communication Journal, EURASIP Journal of Applied Signal Processing, SPIE Optical Engineering Magazine. Prof. Ebrahimi is a member of Scientific Advisory Board of various start-up and established companies in the general field of Information Technology. He has served as Scientific Expert and Evaluator for Research Funding Agencies such as those of European Commission, The Greek Ministry of Development, The Austrian National Foundation for Scientific Research, The Portuguese Science Foundation, as well as a number of Venture Capital Companies active in the field of Information Technologies and Communication Systems. His research interests include still, moving, and 3D image processing and coding, visual information security (rights protection, watermarking, authentication, data integrity, steganography), new media, and human computer interfaces (smart vision, brain computer interface).
He is the author or the co-author of more than 200 research publications, and holds 14 patents. Prof. Ebrahimi is a member of IEEE, SPIE, ACM and IS&T.
See the URL below for more details:
http://mmspl.epfl.ch Jürgen BruggerI am a Professor of Microengineering and co-affiliated to Materials Science. Before joining EPFL I was at the MESA Research Institute of Nanotechnology at the University of Twente in the Netherlands, at the IBM Zurich Research Laboratory, and at the Hitachi Central Research Laboratory, in Tokyo, Japan. I received a Master in Physical-Electronics and a PhD degree from Neuchâtel University, Switzerland. Research in my laboratory focuses on various aspects of MEMS and Nanotechnology. My group contributes to the field at the fundamental level as well as in technological development, as demonstrated by the start-ups that spun off from the lab. In our research, key competences are in micro/nanofabrication, additive micro-manufacturing, new materials for MEMS, increasingly for wearable and biomedical applications. Together with my students and colleagues we published over 200 peer-refereed papers and I had the pleasure to supervise over 25 PhD students. Former students and postdocs have been successful in receiving awards and starting their own scientific careers. I am honoured for the appointment in 2016 as Fellow of the IEEE “For contributions to micro and nano manufacturing technology”. In 2017 my lab was awarded an ERC AdvG in the field of advanced micro-manufacturing.
Rosane Moura Dos Santos BarrettinoExpertise
Rosane Moura Dos Santos received the Diploma in Chemical Engineering from the Federal University of Bahia (UFBA), Brazil, in 2008, the MSc. degree of Science in Engineering from the University of Applied Sciences and Arts of Southern Switzerland (SUPSI), Switzerland, in 2011, and the Ph.D. in Materials Science and Technology from the Polytechnic of Turin, Italy, in 2015.She worked in UFBA, from 2004 to 2007, where she was a Research Technician. From May to August 2007, she went to Imperial College
Mihai Adrian IonescuD'origine et de nationalités roumaine et suisse, Mihai-Adrian Ionescu est né en 1965. Après le doctorat en Physique des Composants à Semiconducteurs de lInstitut National Polytechnique de Grenoble, M. Ionescu a travaillé comme chercheur post-doctoral au LETI-CEA Grenoble, sur la caractérisation des diélectriques low-k pour les technologies submicroniques CMOS. Après une courte période au sein du CNRS, comme chargé de recherche 1ere Classe il a effectué un séjour post-doctoral au Center for Integrated Systems, Stanford University, USA. Actuellement il est Professeur Nanoélectronique à lEcole Polytechnique Fédérale de Lausanne.
Simon Elias BibriExpertise
• Sustainable cities• Smarter eco-cities• Sustainable smart cities• Artificial Intelligence of Things (AIoT) • Generative Artificial Intelligence of Things (GAIoT)• Foundation Models (FMs) • Quantum Generative Artificial Intelligence (QGAI)• Urban Digital Twins (UDTs)• Urban Brain (UB) • Smart Circular Metabolism• Urban planning and design• Environmental sustainability and climate resilience• Sustainable smart energy• Sustainable smart transportation• Sustainable smart waste and water management•
Diego Ruben BarrettinoDiego Barrettino received the Dipl.-Ing. degree in Electronic Engineering from the University of Buenos Aires, Argentina, in 1997, and the Ph.D. degree in Electrical Engineering from the Swiss Federal Institute of Technology Zurich (ETHZ), Switzerland, in 2004. From 1997 to 2000, he worked in Allegro MicroSystems, Inc., where he was an Analog IC Designer of Hall-effect magnetic sensors. From 2000 to 2004, he was a Research Assistant at ETHZ. In 2004, he was a Postdoctoral Research Associate in the Universit
Maher KayalMaher Kayal received M.S. and Ph.D degrees in electrical engineering from the Ecole Polytechnique Fédérale de Lausanne (EPFL, Switzerland) in 1983 and 1989 respectively. He has been with the Electronics laboratories of the Ecole Polytechnique Fédérale de Lausanne (EPFL, Switzerland) since 1990, where he is currently a professor and director of the Energy Management and Sustainability" section. He has published many scientific papers, coauthor of three text books dedicated to mixed-mode CMOS design and he holds eleven patents. His technical contributions have been in the area of analog and Mixed-signal circuits design including highly linear and tunable sensors microsystems, signal processing and green energy management. Prizes and Honors : Electronics Letters journal Premium Award 2013, Outstanding Paper Award? IEEE Mixdes 2013 Basil Papadias paper Award, IEEE Powertech 2013 Best Paper Awards, Mixdes 2013 Best Paper Awards, ICCAS 2012 Outstanding Paper Award- IEEE Mixdes 2012. Poland Section IEEE ED Chapter special award in 2011. Credit Suisse Award for Best Teaching- 2009. The William M. Portnoy Award at the Energy Conversion Congress and Exposition , California Sept 2009. Best Paper Award - IEEE-Mixdes 2009. High Quality Paper - IEEE Power Tech Conference June 2009. Best Paper Award - IEEE-Mixdes 2007. Best Paper Award - IEEE-TTTC International Conference on Automation, Quality and Testing, Robotics - 2006. Best Application Specific Integrated Circuit at the International European Design and Test Conference ED&TC - 1997. Ascom Award for the Best Work in Telecommunication Fields 1990. Publications Books. Books: Methodology for the Digital Calibration of Analog Circuits and Systems, Marc Pastre & Maher Kayal. Springer Publisher- (ISBN 1-4020-4252-3)-2006. Structured Analog CMOS Design, Danica Stefanovic & Maher Kayal. Springer Publisher-(ISBN 978-1-4020-8572-7)-2008. Linear CMOS RF Amplifiers for Wireless Applications, Maher Kayal, Springer Publisher. (ISBN 978-90-481-9360-8)-2010. Coeditor of Microelectronics Education Kluwer Academic Publishers. (ISBN 1-4020-2072-4). -2004.
Bertrand Hervé Laurent LacourEnseignement et PhD Cours Construction mécanique I (pour GM) ME-101 Le cours ME-101 vise à l'acquisition des règles et du langage normalisé de la communication technique, et des bases de la conception mécanique.Ce cours intègre des travaux pratiques d'initiation à la Conception Assistée par Ordinateur avec le logiciel CATIA V5. Construction mécanique I (pour MT) ME-106 Le cours ME-106 vise à l'acquisition des règles et du langage normalisé de la communication technique, et d
César PulgarinExpertise
Mechanistic study of Advanced Oxidation Processes AOPs (i.e. electrochemical, TiO2 photo-assisted, ultrasound, photo-Fenton) and their combinations for chemical and biological pollutants treatment in industrial and domestic wastewaterAction mode of solar light during inactivation of bacteria and virus in water and surfaces. Coupling of biological and AOP systems for industrial waste-waters treatmentDesign, preparation, chemical characterization, activity evaluation and mechanistic description of (
Christophe MoserChristophe Moser is Associate Professor of Optics and the Section Director in the Microengineering department at EPFL. He obtained his PhD at the California Institute of Technology in optical information processing in 2000. He co-founded and was the CEO of Ondax Inc (acquired by Coherent Inc.), Monrovia California for 10 years before joining EPFL in 2010. His current interests are ultra-compact endoscopic optical imaging through multimode fibers, multimode fiber lasers, retinal imaging and additive manufacturing via volumetric 3D printing with light. He is the co-founder of Composyt light lab in the field of head worn displays in 2014 (acquired by Intel Corp), Earlysight SA and Readily3D. He is the author and co-author of 75 peer reviewed publications and 45 patents.
Stefano MischlerStefano Mischler obtained the diploma in materials science in 1983 at the Swiss Federal Institute of Technology ETHZ in Zurich. He accomplished his PhD thesis in the field of surface analysis and corrosion at the Materials department of the Swiss Federal Institute of Technology EPFL in Lausanne in 1988. In the years 1989-1990 he held a postdoctoral position at the United Kingdom Atomic Energy Establishment in Harwell (Oxfordshire) where he developed novel quantification procedures for Auger Electron Spectroscopy and high lateral resolution surface analytical methods for fiber reinforced ceramics. In 1991 he joined the newly created Tribology group at the Laboratory for Metallurgical Chemistry of the EPFL where he developed research activities in the field of wear-corrosion interactions (tribocorrosion) and of tribological coatings. He is currently head of the tribology group and is developing a reserach and training activity devoted to modern aspects of tribology and surface science and technology, including surface chemical effects in tribology, biotribology and biocorrosion, tribology in microfabrication processes and wear protection methods. In 2006 he spent a sabbatical leave of 3 months at the Tokyo Medical and Dental University, Institute of Biomaterials.
