Publication

Cathode-supported micro-tubular SOFCs based on Nd1.95NiO4 + δ: Fabrication and characterisation of dip-coated electrolyte layers

Related publications (30)

Spinel Protective Coatings for Solid Oxide Cell (SOC) Interconnects (ICs)

Abstract The degradation of metal interconnects (ICs) in Solid Oxide Cells (SOCs) primarily results from chromium (Cr) oxide scale growth on stainless-steel substrates, causing ohmic loss and air-side electrode poisoning by Cr. This thesis addresses these ...

EPFL2024

Quantifying mass transport limitations in a microfluidic CO2 electrolyzer with a gas diffusion cathode

Sophia Haussener, Venu Gopal Agarwal

A gas diffusion electrode (GDE) based CO2 electrolyzer shows enhanced CO2 transport to the catalyst surface, significantly increasing current density compared to traditional planar immersed electrodes. A two-dimensional model for the cathode side of a micr ...

2024

Hydrogen-induced tunable remanent polarization in a perovskite nickelate

Michele Kotiuga

Materials with field-tunable polarization are of broad interest to condensed matter sciences and solid-state device technologies. Here, using hydrogen (H) donor doping, we modify the room temperature metallic phase of a perovskite nickelate NdNiO3 into an ...

Nature Portfolio2024

Electrochemical devices and computer science: water/thermal management of proton exchange membrane fuel cells and electrolyzers in different scales

Hossein Pourrahmani

The current restrictions on the registration of combustion engines in different countries and the harmful impacts of fossil fuels on the environment and human health have motivated decision-makers to use batteries and/or fuel cells as alternatives for comb ...

EPFL2023

Reversible photo-electrochemical device for solar hydrogen and power generation

Sophia Haussener, Alexandre Dominique M. Cattry, Saurabh Yuvraj Tembhurne, Matthieu Jonin, Mahendra Patel

A reversible photo-electrochemical device operating under concentrated irradiation could offer a stand-alone solution for producing solar fuel (in photo-driven electrolysis mode) and power (in fuel cell mode). This strategy would present the advantage of h ...

2024

Microstructure - Electrochemical Surface Reactivity Relationship of Electrochemically Grown Manganese Oxides Films

Roberto Cestaro

This Thesis provides a comprehensive and correlative investigation of the microstructure, chemical state, and electrochemical reactivity of manganese oxide (MnOx) films, aiming to gain a deeper understanding of the deposition and dissolution mechanism of M ...

EPFL2024

Membrane electrode assembly simulation of anion exchange membrane water electrolysis

Jan Van Herle, Zoé Mury, Suhas Nuggehalli Sampathkumar, Khaled Lawand

Anion exchange membrane water electrolysis (AEMWE) offers a green hydrogen production method that eliminates the need for platinum group metals (PGM) as electrocatalysts. This study employs a COMSOL (R) 6.0 model to simulate a 1x1 cm(2) Ni fibre - Raney (R ...

Elsevier2024

Electrochemical Hydrophobic Tri-layer Interface Rendered Mechanically Graded Solid Electrolyte Interface for Stable Zinc Metal Anode

Lei Zhang, Kangning Zhao

The aqueous zinc-ion battery is promising as grid scale energy storage device, but hindered by the instable electrode/electrolyte interface. Herein, we report the lean-water ionic liquid electrolyte for aqueous zinc metal batteries. The lean-water ionic li ...

Wiley-VCH Verlag GmbH2024

Quasi-operando Transmission Electron Microscopy Diagnostics for Electrocatalytic Processes in Liquids

Vasiliki Tileli

It is of great interest to the energy community to understand how the mechano-physico-chemical phenomena that eventually lead to device degradation are related to the startup, operation, and shutdown phases. For electrocatalytic systems operating in liquid ...

Swiss Chemical Soc2024

An Advanced Alkaline Al-Air Fuel Cell Using L-Ascorbic Acid Interface Layer upon Al Anode via Gradient Anti-corrosion

Pengfei Zhang, Manhui Wei

Al metal is considered as an excellent anode material for metal-air fuel cells thanks to the advantages in terms of capacity and energy density. However, the anodic parasitic corrosion has brought great obstacles to the performance breakthrough of Al-air f ...

AMER CHEMICAL SOC2023

Pathways to enhance electrochemical CO2 reduction identified through direct pore-level modeling

Sophia Haussener, Shuo Liu, Etienne Boutin, Evan Fair Johnson

Electrochemical conversion of CO2 to fuels and valuable products is one pathway to reduce CO2 emissions. Electrolyzers using gas diffusion electrodes (GDEs) show much higher current densities than aqueous phase electrolyzers, yet models for multi-physical ...

2023

Expansion Work Recovery of Hydrogen for a FC-Truck-Tentative Design of an Expansion Machine

Alfred Rufer

Hydrogen powered vehicles use high-pressure reservoirs from which the gas is transferred to the low-pressure fuel-cell via a classical pressure reduction valve. In these systems no expansion work is recovered and the question is addressed of the potential ...

MDPI2023

Electrolyte engineering via ether solvent fluorination for developing stable non-aqueous lithium metal batteries

Mounir Driss Mensi, Yubo Zhao

Fluorination of solvents, useful for non-aqueous lithium-based batteries, improves the electrochemical stability but decreases the ionic conductivity. Here, the authors report a targeted functionalization of an ether solvent to balance the electrolyte ioni ...

Nature Portfolio2023

Readiness evaluation of SOFC-MGT hybrid systems with carbon capture for distributed combined heat and power

Jürg Alexander Schiffmann, Jan Van Herle, Michele Gaffuri, Victoria Xu Hong He

The aggravation of climate change calls for the timely development and implementation of highly efficient, renewable, zero- or negative-emission energy solutions with high technological readiness and feasibility levels. Solid oxide fuel cells (SOFC) consti ...

Elsevier2023

The thermodynamic and life-cycle assessments of a novel charging station for electric vehicles in dynamic and steady-state conditions

Jan Van Herle, Hossein Pourrahmani, Chengzhang Xu

The current study performs the thermodynamic and life-cycle assessments (LCA) of a novel charging station in two system designs. The goal is to design an efficient charging station for electric vehicles with high efficiencies and low environmental impacts ...

Nature Portfolio2023

Dataset for "Low-temperature processing of screen-printed piezoelectric KNbO3 with integration onto biodegradable paper substrates"

Luis Guillermo Villanueva Torrijo, Danick Briand, Morgan Mc Kay Monroe

This data set contains the data collected during the FNS project Green Piezo (Grant no. 179064) in association with the recent publication entitled “Low-temperature processing of screen-printed piezoelectric KNbO3 with integration onto biodegradable paper ...

Zenodo2023

Pure Amorphous and Ultrathin Phosphate Layer with Superior Ionic Conduction for Zinc Anode Protection

Kangning Zhao

Fast and uniform ion transport within the solid electrolyte interphase (SEI) is considered a crucial factor for ensuring the long-term stability of metal electrodes. In this study, we present the fabrication of ultrathin artificial interphases consisting o ...

Amer Chemical Soc2023

Low-temperature processing of screen-printed piezoelectric KNbO3 with integration onto biodegradable paper substrates

Luis Guillermo Villanueva Torrijo, Danick Briand, Morgan Mc Kay Monroe

The development of fully solution-processed, biodegradable piezoelectrics is a critical step in the development of green electronics towards the worldwide reduction of harmful electronic waste. However, recent printing processes for piezoelectrics are hind ...

2023

Hybridisation Scenarios of Solid Oxide Fuel Cells, Batteries, and Internal Combustion Engines for Waterborne Transportation

François Maréchal, Daniel Alexander Florez Orrego

The shipping industry was responsible for about 3% of global greenhouse gas (GHG) emissions in 2018. In this context, the International Maritime Organisation (IMO) has established stringent targets to reduce GHG emissions by at least 50% by 2050 compared t ...

Universidad de Las Palmas de Gran Canaria2023

Fast online diagnosis for solid oxide fuel cells: Optimisation of total harmonic distortion tool for real-system application and reactants starvation identification

Jan Van Herle, Hamza Moussaoui, Gerald Hammerschmid

This study investigates the potential application of total harmonic distortion (THD), as a fast online monitoring tool, to identify the early signs of failure modes in solid oxide fuel cells (SOFC). Indeed, the timely detection and identification of faults ...

ELSEVIER2023