Publications related to Complex image method for RF antenna-plasma inductive coupling calculation in planar geometry. Part I: basic concepts

Related publications (32)

Modeling and optimization of PCB coils for inductive power transfer systems

The auxiliary power supply for medium voltage converters requires high insulation capability between the source and the load. Inductive power transfer technology, with an air gap between the primary and secondary coil, offers such high insulation capabilit ...

EPFL2024

A Two-Wired High Input Impedance and High CMRR Active Electrode Insensitive to Component Mismatch

Alexandre Schmid, Mehdi Saberi

This article proposes a new two-wired amplifying active electrode (AE), presenting a high input impedance and a high common-mode rejection ratio (CMRR). In the proposed structure, the input impedance and the CMRR of the system are considerably increased by ...

Ieee-Inst Electrical Electronics Engineers Inc2024

Impact of beam-coupling impedance on the Schottky spectrum of bunched beam

Tatiana Pieloni, Nicolas Frank Mounet, Christophe Emmanuel R. Lannoy

The Schottky monitors of the Large Hadron Collider (LHC) can be used for non-invasive beam diagnostics to estimate various bunch characteristics, such as tune, chromaticity, bunch profile or synchrotron frequency distribution. However, collective effects, ...

Iop Publishing Ltd2024

On the use of Cramér-Rao Lower Bound for least-variance circuit parameters identification of Li-ion cells

Mario Paolone, Vladimir Sovljanski

Electrochemical Impedance Spectroscopy (EIS) and Equivalent Circuit Models (ECMs) are widely used to characterize the impedance and estimate parameters of electrochemical systems such as batteries. We use a generic ECM with ten parameters grouped to model ...

2024

Performance Comparison of Cables With Partial Transposition

Pierluigi Bruzzone, Kamil Sedlák, Chiara Frittitta, Federica Demattè

The need of full transposition of the current carrying elements (strands) in large cables is frequently retained as top design criterion for conductors operating in pulsed mode. However, when the transposition error, i.e., the inductance difference among t ...

IEEE Institute of Electrical and Electronics Engineers2024

Enabling Wide Bandwidth in Substrate-Integrated Waveguide Slot Antennas by Using Low-Index Metamaterials

Romain Christophe Rémy Fleury, Amir Jafargholi

This paper presents a solution to overcome the inherently limited bandwidth of substrate-integrated waveguide (SIW) slot antennas. It is analytically shown that by decreasing the permittivity of a dielectric loaded slot antenna, the resulting bandwidth inc ...

American Physical Society (APS)2024

High-frequency response of a hemispherical grounding electrode

Farhad Rachidi-Haeri, Marcos Rubinstein, Antonio Sunjerga

The lightning discharge current is characterized by a high-frequency spectrum extending from DC to about 10 MHz. The calculation of the grounding impedance is one of the most important aspects of designing lightning protection systems. The search for analy ...

Elsevier2024

DC Power Distribution Networks with Direct Current Transformers

Renan Pillon Barcelos

The shift towards DC power distribution networks, enabled by power electronics technologies, is changing the nature of electrical power systems. Nowadays, DC power distribution networks can effectively support the high penetration of distributed energy res ...

EPFL2024

A modular multiple frequency inductive link to wirelessly power multiple miniaturized implants

Sandro Carrara, Diego Ghezzi, Gian Luca Barbruni

A modular multiple frequency coils inductive link system to wirelessly provide power for at least a medical implant at an output of a receiving coil, whereby the receiving coil is configured to be implanted in an organism. The modular multiple frequency co ...

2024

Characterization of low-temperature plasmas generated by dielectric barrier discharges for bacterial inactivation

Lorenzo Ibba

Low-temperature plasmas (LTPs) at atmospheric pressure hold great promise for disinfection and sterilization applications. When compared to traditional sterilization technologies like autoclaving, LTPs may offer several benefits, including reduced energy c ...

EPFL2024

Electromagnetic time reversal for online partial discharge location in power cables: Influence of interfering reflections from grid components

Farhad Rachidi-Haeri, Marcos Rubinstein

In online single-sided partial discharge (PD) location, the measured PD reflection patterns are affected by the characteristics of all the components of the associated power network. This paper analyses the performance of a PD location method based on elec ...

2024

Re-design of EU DEMO with a low aspect ratio

Xabier Sarasola Martin

The design point that had been chosen for EU DEMO in 2016 is reviewed here and a modification is proposed with a lower aspect ratio. Previously the same aspect ratio, A, was chosen for EU DEMO as in major tokamak experiments including ITER (A = 3.1), and, ...

Elsevier2024

Modeling and Design Optimization of Loosely Coupled PCB Spiral Coils in Inductive Power Transfer Systems

Drazen Dujic, Xiaotong Du

There are various possibilities to realize coil winding designs for an inductive power transfer system. In order to achieve high power transfer efficiency and power density and explore trade-offs between the two, design optimization around the coil link is ...

2023

NbN films with high kinetic inductance for high-quality compact superconducting resonators

Edoardo Charbon, Pasquale Scarlino, Fabrizio Minganti, Simone Frasca, Marco Scigliuzzo, Fabian Oppliger, Vincent Jean Yves Jouanny

Niobium nitride (NbN) is a particularly promising material for quantum technology applications, as it shows the degree of reproducibility necessary for large-scale superconducting circuits. We demonstrate that resonators based on NbN thin films present a o ...

American Physical Society (APS)2023

Self-Synchronized Grid Impedance Estimation Unit using Interpolated DFT Technique

Drazen Dujic, Andrea Cervone, Jules Christian Georges Macé

Estimating the impedance of a grid-connected device or of a grid at the point of common coupling is important for evaluating the interaction between them. Impedance measurement involves a perturbation injection device, that perturbs the system, and a measu ...

2023

Gate unit for a gate-commutated thyristor and integrated gate-commutated thyristor

Drazen Dujic, Jakub Kucka

The invention relates to a gate unit (22) for controlling a gate commutated thyristor (21), comprising: - a voltage selector (26) for selectively applying a high supply potential (Vpos), a middle supply potential (Vmid), and a low supply potential (Vneg); ...

2023

First developments towards producing inductive magnetic sensors using state-of-the-art photolithography techniques

Ambrine Douhane, Marcus Cemes, Duccio Testa

Inductive magnetic sensors are needed for tokamak operation to provide the low-frequency (LF) measurements leading to the equilibrium reconstruction and to monitor the higher frequency (HF) instabilities; the HF magnetic sensors are often also used as a ba ...

2023

Portable impedance-sensing device for microorganism characterization in the field

Sandro Carrara

A variety of biosensors have been proposed to quickly detect and measure the properties of individual microorganisms among heterogeneous populations, but challenges related to cost, portability, stability, sensitivity, and power consumption limit their app ...

Nature Portfolio2023

Full-discharge simulation and optimization with the RAPTOR code, from present tokamaks to ITER and DEMO

Simon Van Mulders

Tokamak devices aim to magnetically confine a hydrogen plasma at sufficiently high pressure to achieve net energy production from nuclear fusion of light isotopes. Predictive modeling and optimization is crucial for reliable operation of tokamak reactors, ...

EPFL2023

Integrated Electronics for Deep Implants to Remotely Monitor Hemodynamics

Mustafa Besirli

The integration of technology in the medical field has greatly improved accuracy in diagnoses, thus leading to more effective treatments. Wearable and implantable medical devices offer great potential for remote patient monitoring, particularly for heart f ...

EPFL2023