Publications related to On the Differential Input Impedance of an Electro-Explosive Device

Related publications (31)

A Two-Wired High Input Impedance and High CMRR Active Electrode Insensitive to Component Mismatch

This article proposes a new two-wired amplifying active electrode (AE), presenting a high input impedance and a high common-mode rejection ratio (CMRR). In the proposed structure, the input impedance and the CMRR of the system are considerably increased by ...

Ieee-Inst Electrical Electronics Engineers Inc2024

Impact of beam-coupling impedance on the Schottky spectrum of bunched beam

Tatiana Pieloni, Nicolas Frank Mounet, Christophe Emmanuel R. Lannoy

The Schottky monitors of the Large Hadron Collider (LHC) can be used for non-invasive beam diagnostics to estimate various bunch characteristics, such as tune, chromaticity, bunch profile or synchrotron frequency distribution. However, collective effects, ...

Iop Publishing Ltd2024

On the use of Cramér-Rao Lower Bound for least-variance circuit parameters identification of Li-ion cells

Mario Paolone, Vladimir Sovljanski

Electrochemical Impedance Spectroscopy (EIS) and Equivalent Circuit Models (ECMs) are widely used to characterize the impedance and estimate parameters of electrochemical systems such as batteries. We use a generic ECM with ten parameters grouped to model ...

2024

High-frequency response of a hemispherical grounding electrode

Farhad Rachidi-Haeri, Marcos Rubinstein, Antonio Sunjerga

The lightning discharge current is characterized by a high-frequency spectrum extending from DC to about 10 MHz. The calculation of the grounding impedance is one of the most important aspects of designing lightning protection systems. The search for analy ...

Elsevier2024

Portable impedance-sensing device for microorganism characterization in the field

Sandro Carrara

A variety of biosensors have been proposed to quickly detect and measure the properties of individual microorganisms among heterogeneous populations, but challenges related to cost, portability, stability, sensitivity, and power consumption limit their app ...

Nature Portfolio2023

Self-Synchronized Grid Impedance Estimation Unit using Interpolated DFT Technique

Drazen Dujic, Andrea Cervone, Jules Christian Georges Macé

Estimating the impedance of a grid-connected device or of a grid at the point of common coupling is important for evaluating the interaction between them. Impedance measurement involves a perturbation injection device, that perturbs the system, and a measu ...

2023

NbN films with high kinetic inductance for high-quality compact superconducting resonators

Edoardo Charbon, Pasquale Scarlino, Fabrizio Minganti, Simone Frasca, Marco Scigliuzzo, Fabian Oppliger, Vincent Jean Yves Jouanny

Niobium nitride (NbN) is a particularly promising material for quantum technology applications, as it shows the degree of reproducibility necessary for large-scale superconducting circuits. We demonstrate that resonators based on NbN thin films present a o ...

American Physical Society (APS)2023

Integrated Electronics for Deep Implants to Remotely Monitor Hemodynamics

Mustafa Besirli

The integration of technology in the medical field has greatly improved accuracy in diagnoses, thus leading to more effective treatments. Wearable and implantable medical devices offer great potential for remote patient monitoring, particularly for heart f ...

EPFL2023

Portable Multi-Frequency Impedance-Sensing Device for Bacteria Classification in a Flowing Liquid

Sandro Carrara

This paper presents a novel impedance-sensing device and its related microfluidics system developed to characterize the macroscopical properties of bacteria and microparticles. The system is based on a phase-sensitive detector with square-waves excitation ...

IEEE2022

Theoretical Efficiency and Dosimetry of Buffered On-body Transmitter Antennas for Wireless Powering of In-body Devices

Anja Skrivervik, Denys Nikolayev

The viable and safe application of wireless power transfer for powering bioelectronic implants requires understanding the wave propagation in heterogeneous and dispersive media, the electromagnetic exposure assessment, and the optimum design of the system ...

IEEE2022

A Capacitively-Coupled Chopper Instrumentation Amplifier for Implantable Bridge Sensor Systems

Marco Mattavelli, Catherine Dehollain, Diego Ruben Barrettino, Kerim Türe, Mustafa Besirli

This paper presents an energy and area efficient capacitively-coupled chopper instrumentation amplifier (CCIA) dedicated to implantable bridge sensor systems. Chopper stabilization is employed to decrease its offset and 1/f noise and the resulting ripple d ...

IEEE2022

Subthreshold VO2 vertical switches for large-bandwidth millimeter-wave and sub-terahertz detection

Mihai Adrian Ionescu, Fatemeh Qaderi Rahaqi, Ali Gilani, Daesung Park

n-linear impedance characteristics of VO2 offer solutions to highly sensitive radio-frequency (RF), millimeterwave (mm-wave), and terahertz (THz) detectors. We demonstrate high-speed broadband sensibility of miniaturized VO2 switches by utilizing the nonli ...

IEEE2022

High Performance Low cost Transition Connectors for 5G mmWave Applications

Anja Skrivervik

Millimeter wave (mmWave) is an interesting research area in recent years. Transition connectors are key components of mmWave passive systems. The commercially available cable connectors are lossy and expensive in mmWave frequencies. In this paper, various ...

IEEE2022

A Delta Sigma-Modulated Sample and Average Common-Mode Feedback Technique for Capacitively Coupled Amplifiers in a 192-nW Acoustic Analog Front-End

Kyojin Choo

This work presents an acoustic analog front-end based on a delta sigma-modulated sample and average common-mode feedback technique. The proposed feedback offers a process and temperature stable high pass (HP) frequency corner, unity dc feedback gain, and a ...

IEEE-INST ELECTRICAL ELECTRONICS ENGINEERS INC2022

Optimization of Edge Profile for Improved Anti-Resonance Quality Factor in Lithium Niobate SH0 Resonators

Luis Guillermo Villanueva Torrijo, Silvan Stettler

Thin-film lithium niobate (LNO) has been identified as a promising material platform for enabling high electromechanical coupling and low-loss piezoelectric resonators for filtering applications. In this work, the design and fabrication of fundamental shea ...

IEEE2022

Data-driven Power Electronic Converter Control Design in Power System Applications

Seyed Sohail Madani

In recent years, power systems have evolved in physical and cyber-physical layers. In the physical layer, the changes are motivated by environmental concerns resulting in the integration of new types of generation/demand/storage into the grid. These integr ...

EPFL2022

Terminal Characteristics Measurements and Analysis of the Three-Phase Active Front End Converter Building Block

Drazen Dujic, Marko Petkovic

The safe and reliable operation of modern power system imposes the need to describe and estimate the system stability through impedance-admittance measurement and identification. The integration and operation of medium voltage equipment in existing infrast ...

Wiley2021

A Closed Time-Reversal Cavity for Electromagnetic Waves in Transmission Line Networks

Farhad Rachidi-Haeri, Marcos Rubinstein, Mario Paolone, Reza Razzaghi, Zhaoyang Wang

A closed time-reversal (TR) cavity has been considered a purely theoretical concept whose experimental realization was assumed to be impossible. In this article, we demonstrate that it is, in fact, possible to realize a closed TR cavity using a network of ...

2021

Learning From Demonstration and Interactive Control of Variable-Impedance to Cut Soft Tissues

Aude Billard, Rui Wu

In this article, we propose an approach to extract variable-impedance during cutting tasks from human demonstrations, so as to ease soft-tissue cutting by robots. We model the dynamic adjustment of the human arm during interactions with the tissue and tran ...

2021

A Cryogenic Broadband Sub-1-dB NF CMOS Low Noise Amplifier for Quantum Applications

Edoardo Charbon, Andrea Ruffino, Yatao Peng

A cryogenic broadband low noise amplifier (LNA) for quantum applications based on a standard 40-nm CMOS technology is reported. The LNA specifications are derived from the readout of semiconductor quantum bits at 4.2 K, whose quantum information signals ar ...

2021