Publications related to Considerations for design optimization of high-power medium-frequency transformers

Related publications (9)

Analysis of Power Consumption and Propagation Delay in Voltage Level Shifters

The analysis of the operation of non-linear circuits such as voltage level shifters and latched comparators and therefore prediction of their propagation delay and power consumption are challenging. This is because the operating points of the employed non- ...

Institute of Electrical and Electronics Engineers (IEEE)2025

Evaluation of Magnetic Integration in Modularized-Bridge-Rectifier Solid-State Transformer

Drazen Dujic, Zhenchao Li

Modularized Bridge Rectifier (mBR) is a promising solid-state transformer (SST) topology that replaces active front-end stages with diodes and utilizes multiple isolated DC/DC converters. This paper investigates magnetic integration schemes to mitigate the ...

2025

DC Power Distribution Networks with Direct Current Transformers

Renan Pillon Barcelos

The shift towards DC power distribution networks, enabled by power electronics technologies, is changing the nature of electrical power systems. Nowadays, DC power distribution networks can effectively support the high penetration of distributed energy res ...

EPFL2024

A 69 µm2 Sub-nW/kHz Capacitor-less Ring Oscillator for Ultra-Miniaturized Implants

Sandro Carrara, Gian Luca Barbruni, Ali Meimandi

This paper presents an ultra-miniaturized, ultra-low-power, capacitor-less CMOS ring oscillator based on dynamic leakage suppression technique. Measurement results demonstrated an oscillation frequency of 21.89 kHz and a power consumption of 7.9 nW for a s ...

Institute of Electrical and Electronics Engineers Inc.2024

Distributed flexibility as a cost-effective alternative to grid reinforcement

Christophe Ballif, Nicolas Würsch, Jordan Holweger, Alejandro Pena Bello, Noémie Alice Yvonne Ségolène Jeannin

The deployment of distributed photovoltaics (PV) in low-voltage networks may cause technical issues such as voltage rises, line ampacity violations, and transformer overloading for distribution system operators (DSOs). These problems may induce grid reinfo ...

ELSEVIER2023

Pushing the Limits of Efficiency and Power Density in High-Frequency Power Conversion Based on Wide-Band-Gap Technologies

Armin Jafari

The emergence of wide-band-gap (WBG) power transistors with low conduction losses and high-speed switching speeds has paved the way for more-than-ever efficient power electronics systems and huge energy saving potentials. Likewise, power density- the ratio ...

EPFL2021

Turbine mode start-up simulation of a FSFC variable speed pump-turbine prototype - Part I: 1D simulation

Drazen Dujic, François Avellan, Sébastien Alligné, Antoine Béguin

Variable speed hydroelectric units equipped with full size frequency converter (FSFC) offer high operational flexibility enabling fast operating point transitions which increase grid regulation capacities. The XFLEX HYDRO H2020 European research project ai ...

IOP Publishing2021

Resonances on GaN-on-Si Epitaxies: A Source of Output Capacitance Losses in Power HEMTs

Elison de Nazareth Matioli, Armin Jafari, Mohammad Samizadeh Nikooytabalvandani, Riyaz Mohammed Abdul Khadar, Minghua Zhu

GaN-on-Si high-electron-mobility transistors (HEMTs) exhibit excellent properties for efficient power conversion. Nevertheless, a considerable energy loss associated with the charging and discharging of the output capacitance (COSS) in these transistors se ...

Institute of Electrical and Electronics Engineers2021

Critical Parasitic Elements of Coupled Inductors for Ultra-High Voltage Flyback Converters Used to Drive Capacitive Actuators

Yves Perriard, Alexis Boegli, Morgan Almanza, Raphaël Johannes Charles Mottet

This paper presents the critical parasitic elements of coupled inductors and their influence when designing a low input (12V) and ultra-high output voltage (>4000V) DC-DC Flyback Converter. The aim is to design a compact converter capable to supply the ult ...

IEEE2019