Publications related to Two-phase flow operational maps for multi-microchannel evaporators

Related publications (31)

Design and assessment of an evaporating water-cooled methanation reactor for a SOE-based power-to-methane system

The transition towards clean renewable energy sources, where wind and solar are prone to variation, requires adequate energy storage. Power-to-methane (PtM) systems can be part of the solution. Specifically, solid-oxide-electrolyser (SOE) based PtM systems ...

EPFL2024

General and Unified Model of the Power Flow Problem in Multiterminal AC/DC Networks

Mario Paolone, Willem Lambrichts

This paper proposes a generic and unified model of the power flow (PF) problem for multiterminal hybrid AC/DC networks. The proposed model is an extension of the standard AC-PF. The DC network is treated as an AC one and, in addition to the Slack, PV and P ...

IEEE Institute of Electrical and Electronics Engineers2024

Heat transfer of uncoated and nanostructure coated commercially micro-enhanced refrigeration tubes under pool boiling conditions

John Richard Thome

The heat transfer performance of commercially produced micro-enhanced tubes with and without a nanocoating was investigated under pool boiling of saturated refrigerant. These multiscale enhancements were on the outside of 19 mm horizontal copper tubes heat ...

Pergamon-Elsevier Science Ltd2023

Experimental study of the hydrodynamic and thermal performances of ventilated wall structures

Dolaana Khovalyg, Mohammad Rahiminejad

The presence of a ventilated air gap behind the external cladding in a building envelope is known to have a tangible contribution to the overall performance of the wall assembly. In the present study, the hydrodynamic and thermal performances of ventilated ...

2023

Small-scale turbopumps for waste heat recovery applications based on an organic Rankine cycle: a study from pre-design to experimental validation

Sajjad Zakeralhoseini

The organic Rankine cycle (ORC) system is among the technologies applied to exploit waste heat in vehicles. Since common organic fluids have lower latent heat than water, higher mass flow rates are required to convert the same waste heat, considerably incr ...

EPFL2023

Development of next-generation microfluidic systems for enhanced, faster, and cost-effective immunoassays for tissue diagnostics - Ac electrothermal flow & Acoustofluidics

Muaz Salama Abdelmonem Draz

The application of microfluidics in the field of surface-based assays and more specifically, the spatial molecular profiling of tumor tissues has gained a lot of interest, especially with the increased interest in personalized medicine and targeted therapy ...

EPFL2023

Near-junction microfluidic cooling for high power-density GaN-on-Si electronics: A wafer, device, packaging, and system-level investigation

Remco Franciscus Peter van Erp

Electrification of the energy section, from generation to end-use, plays an essential role in reducing global CO2 emission. Innovations in power electronics are required to increase conversion efficiency and power density. Gallium nitride (GaN) transistors ...

EPFL2022

Heat transfer of flow boiling carbon dioxide in vertical upward direction

Jürg Alexander Schiffmann, Rémi Revellin, David Schmid

Heat transfer measurements of flow boiling Carbon Dioxide (CO2) in vertical upward direction have been carried out with a dedicated test facility at the European Organization for Nuclear Research (CERN). The experiments have been conducted in a vertical up ...

2022

Design and management of three-dimensional multi-processor systems-on-chip with integrated flow cell arrays

Halima Najibi

Three-Dimensional Multi-Processor Systems-on-Chip (3D MPSoCs) are promising solutions for highly intensive Artificial Intelligence (AI) and Big Data applications. They combine remarkably dense computation capabilities and massive communication bandwidths. ...

EPFL2022

Flow Boiling of Carbon Dioxide at Different Channel Orientations for the Thermal Management of Future Detector Technologies at the High-Luminosity Large Hadron Collider at CERN

David Schmid

The global warming potential (GWP) of working fluids in thermodynamic cycles and their environmental impact have been gaining considerable attention within the recent years. The global objectives on climate protection are becoming increasingly ambitious, w ...

EPFL2022

Compact Thermosyphon Cooling System For High Heat Flux Servers: Validation Of Thermosyphon Simulation Code Considering New Test Data

John Richard Thome, Jackson Braz Marcinichen, Raffaele Luca Amalfi, Filippo Cataldo

Passive, gravity-driven thermosyphons represent a stepchange in technology towards the goal of greatly reducing PUE (Power Usage Effectiveness) of datacenters by replacing energy hungry fans of air-cooling approach with a highly-reliable solution able to d ...

AMER SOC MECHANICAL ENGINEERS2021

Influencing factors on flow boiling of carbon dioxide in enhanced tubes and comparison with correlations

John Richard Thome

Carbon dioxide two-phase flow characteristics are different from those of conventional refrigerants, due to the CO2 particular thermodynamic and transport properties obtained by working at high reduced pressures. Moreover, the use of peculiar heat transfer ...

IOP PUBLISHING LTD2020

Towards Deeply Scaled 3D MPSoCs with Integrated Flow Cell Array Technology

David Atienza Alonso, Marina Zapater Sancho, Alexandre Sébastien Julien Levisse, Mohamed Mostafa Sabry Aly, Halima Najibi

Deeply-scaled three-dimensional (3D) Multi-Processor Systems-on-Chip (MPSoCs) enable high performance and massive communication bandwidth for next-generation computing. However, as process nodes shrink, temperature-dependent leakage dramatically increases, ...

2020

Multi-Objective Management of Multiprocessor Systems: From Heuristics to Reinforcement Learning

Arman Iranfar

In my thesis, I reveal several already-existing and emerging challenges in multi-objective management of multiprocessor systems, and address them through novel solutions, from heuristics to RL, depending on the complexity of the problem. Conventional multi ...

EPFL2020

Flow boiling heat transfer and two-phase flow phenomena of CO2 in macro-and micro-channel evaporators: Fundamentals, applications and engineering design

John Richard Thome

The paper presents a comprehensive review of fundamentals and engineering applications of CO2 flow boiling heat transfer, flow patterns and two-phase pressure drops in macro- and micro-channel evaporators. First, distinctions of macro- and micro-channels a ...

PERGAMON-ELSEVIER SCIENCE LTD2021

Co-designing electronics with microfluidics for more sustainable cooling

Elison de Nazareth Matioli, Luca Nela, Remco Franciscus Peter van Erp, Reza Soleiman Zadeh Ardebili, Georgios Kampitsis

Thermal management is one of the main challenges for the future of electronics1,2,3,4,5. With the ever-increasing rate of data generation and communication, as well as the constant push to reduce the size and costs of industrial converter systems, the powe ...

NATURE RESEARCH2020

Optimization based approach to assist the transition of large energy users to low temperature networks

François Maréchal, Alberto Mian, Jessen Page, Francesca Belfiore

Distric Energy System (DES) represents a promising opportunity to improve energy efficiency and boost the decarbonization of the European energy sector. If most of the studies focus on small consumers typically located within urban areas, large energy user ...

Curran Associates, Inc.2020

Thermal management of components for high energy physics experiments and space applications

Timothée Robert Sophus Frei

High-energy physics (HEP) experiments and space missions share a common challenge: thermal management in harsh environments. The severe constraints in both fields make cooling of electronic components a major design concern. This thesis aims to develop hig ...

EPFL2021

Copper battery for heat to power conversion and energy storage

Sunny Isaïe Maye

An important part of the electricity production relies on heat conversion. Indeed power plants burn fuels like natural gas, coal or use nuclear fission to produce heat that can be transformed into electricity through a thermodynamic cycle and the mechanica ...

EPFL2020

Energy-Efficient Design Techniques for High-Speed Wireline Serial Links

Firat Çelik

The exponential growth in computing power and multimedia services has caused a tremendous increase in data traffic in recent years. This increase in data traffic brings a strong demand for data bandwidth of electrical input/output (I/O) links and pushes th ...

EPFL2021