Publications related to On the issues related to compliance assessment of ICNIRP 2010 basic restrictions

Pyroresistive response of percolating conductive polymer composites

The pyroresistive response of conductive polymer composites (CPCs) has attracted much interest because of its potential applications in many electronic devices requiring a significant responsiveness to changes in external physical parameters such as temper ...

Amer Physical Soc2024

Direct observations of X-rays produced by upward positive lightning

Farhad Rachidi-Haeri, Marcos Rubinstein, Antonio Sunjerga, Thomas Chaumont

X-rays have been observed in natural downward cloud-to-ground lightning for over 20 years and in rocket-triggered lightning for slightly less. In both cases, this energetic radiation has been detected during the stepped and dart leader phases of downward n ...

Nature Publishing Group2024

Automated all-functionals infrared and Raman spectra

Nicola Marzari, Lorenzo Bastonero

Infrared and Raman spectroscopies are ubiquitous techniques employed in many experimental laboratories, thanks to their fast and non-destructive nature able to capture materials' features as spectroscopic fingerprints. Nevertheless, these measurements freq ...

Nature Portfolio2024

Measuring electrical properties in semiconductor devices by pixelated STEM and off-axis electron holography (or convergent beams vs. plane waves)

Victor Carle Adrien Boureau

We demonstrate the use of both pixelated differential phase contrast (DPC) scanning transmission electron microscopy (STEM) and off-axis electron holography (EH) for the measurement of electric fields and assess the advantages and limitations of each techn ...

Pergamon-Elsevier Science Ltd2024

Advanced Silicon and SWIR Single-Photon Avalanche Diodes: Design, Simulation, and Characterization

Ekin Kizilkan

Low-level light detection with high spatial and timing accuracy is a growing area of interest by virtue of applications such as light detection and ranging (LiDAR), biomedical imaging, time-resolved Raman spectroscopy, and quantum applications. Single-phot ...

EPFL2024

Characterization of low-temperature plasmas generated by dielectric barrier discharges for bacterial inactivation

Lorenzo Ibba

Low-temperature plasmas (LTPs) at atmospheric pressure hold great promise for disinfection and sterilization applications. When compared to traditional sterilization technologies like autoclaving, LTPs may offer several benefits, including reduced energy c ...

EPFL2024

Tri-axial H-Field Sensor with Frequency-shaped Response in the band 400 MHz - 6 GHz

German Augusto Ramirez Arroyave

This contribution presents an isotropic field probe to assess human exposition to broadband magnetic fields in the 400 MHz to 6 GHz band according to the ICNIRP 2020 guidelines. This device complements the current practice in this band, based on the measur ...

IEEE2023

Charging and Electric Field Effects on Hydrogen Molecules Physisorbed on Graphene

Klaus Kern, Shai Mangel, Alessio Scavuzzo, Tobias Wollandt

Molecular hydrogen adsorbed on graphene was investigated by analyzing rotational excitation spectra obtained with a gate-tunable scanning tunneling microscope (STM). Through the shift of the rotational excitation energy, the tunability of physisorbed H2 on ...

AMER CHEMICAL SOC2023

Universal machine learning for the response of atomistic systems to external fields

Yaolong Zhang

Machine learned interatomic interaction potentials have enabled efficient and accurate molecular simulations of closed systems. However, external fields, which can greatly change the chemical structure and/or reactivity, have been seldom included in curren ...

Nature Portfolio2023

Rotating spokes, potential hump and modulated ionization in radio frequency magnetron discharges

Liang Xu, Haomin Sun

In this work, the transition from the gradient drift instability (GDI) into an m = 1 rotating spoke in the radio frequency magnetron discharge was studied by means of the two-dimensional axial-azimuthal (z - y) particle-in-cell/Monte Carlo collision method ...

Iop Publishing Ltd2023

A review of the modeling approaches of the lightning M-component with special attention to their current and electric field characteristics

Farhad Rachidi-Haeri, Marcos Rubinstein, Carlo Alberto Nucci, Mohammad Azadifar, Qi Li

In this paper, we present the characteristics of current, electric fields and modeling approaches of lightning M-component mode of charge transfer. We consider both the classical M-components (occurring after return strokes) and M-component-type ICC (Initi ...

Elsevier2023

Breakdown development in a nanosecond pulsed dielectric barrier discharge in humid air in plane-to-plane geometry

Ivo Furno, Xin Yang, Lorenzo Ibba

We used the ns electric field induced second harmonic (EFISH) generation diagnostic to measure the electric field evolution in a 200 ns pulse, dielectric barrier, plane-to-plane discharge in humid air, on the time scale shorter than the laser pulse duratio ...

Iop Publishing Ltd2023

Positive Streamer Initiation in SF6/CO2 Based on Zener's Field Ionization

Guang-Yu Sun

In this study, experiments were performed to measure the inception and breakdown voltages of SF6/CO2 mixed gases with varying mixing ratios at two different pressures (1 and 2 bar). Using the preliminary data obtained from the experiments, a 3D particle mo ...

IEEE-INST ELECTRICAL ELECTRONICS ENGINEERS INC2023

Current propagation type self-consistent leader-return stroke model

Farhad Rachidi-Haeri, Marcos Rubinstein

A current propagation type return stroke model which is consistent with the estimated distribution of the charge on the leader channel is described. The model takes into account the dispersion of the return stroke current along the return stroke channel. T ...

Elsevier2023

Electrically tunable dipolar interactions between layer-hybridized excitons

Andras Kis, Fedele Tagarelli, Edoardo Lopriore

Transition-metal dichalcogenide bilayers exhibit a rich exciton landscape including layer-hybridized excitons, i.e. excitons which are of partly intra- and interlayer nature. In this work, we study hybrid exciton-exciton interactions in naturally stacked W ...

ROYAL SOC CHEMISTRY2023

Exact Expressions for Lightning Electromagnetic Fields: Application to the Rusck Field-To-Transmission Line Coupling Model

Farhad Rachidi-Haeri, Marcos Rubinstein

An exact analytical expression for the electric field of the return stroke as excited by a propagating step current source is derived in this paper. This expression could be advantageously used to evaluate the disturbances caused by lightning on overhead l ...

2023

Toward a brightness upgrade to the SwissFEL: A high gradient traveling-wave rf photogun

Anastasiya Magazinik, Mike Seidel, Paolo Craievich, Sven Reiche

The first generation of S-band injectors for free-electron lasers has illustrated high reliability and performance by driving the latest generation of high brightness machines. However, the ultimate electron beam brightness of these devices is limited by t ...

Amer Physical Soc2023

Directional sensitivity of cortical neurons towards TMS induced electric fields

Werner Alfons Hilda Van Geit, Aurélien Tristan Jaquier

We derived computationally efficient average response models of different types of cortical neurons, which are subject to external electric fields from Transcranial Magnetic Stimulation. We used 24 reconstructions of pyramidal cells (PC) from layer 2/3, 24 ...

2023

Surface Charge Boundary Condition Often Misused in CO2 Reduction Models

Sophia Haussener, Etienne Boutin, Evan Fair Johnson

The Poisson-Nernst-Planck equations have been used to model species transport in electrochemical CO2 reduction, where the surface charge boundary condition accounts for the potential drop across the Stern layer. A direct comparison of the published models ...

AMER CHEMICAL SOC2023

Effects of Electrode Design on the Melt Electrowriting of Sinusoidal Structures

Biranche Tandon

Melt electrowriting is a microscale manufacturing technique that uses polymer-based melts to create fibrous structures. An electric field is used to stabilize a continuous molten jet, which is then written onto a substrate as a microscale fiber. Herein, it ...

WILEY-V C H VERLAG GMBH2023