Home

Publication

Charge Generation and Photovoltaic Operation of Solid-State Dye-Sensitized Solar Cells Incorporating a High Extinction Coefficient Indolene-Based Sensitizer

About
Privacy
Disclaimer

Graph Chatbot

Related publications (40)

Page 1 of 2

Tuning Electronic and Optical Properties of 2D/3D Interfaces of Hybrid Perovskites through Interfacial Charge Transfer: Prediction of Higher-Efficiency Interface Solar Cells Using Hybrid-DFT Methods

Mohammad Khaja Nazeeruddin

The 2D/3D or 2D/quasi-2D composite mixed-dimensional construction of hybrid perovskite interfaces is gaining increasing attention due to their enhanced stability toward degradation without compromising the corresponding solar cell efficiency. Much of this ...

AMER CHEMICAL SOC2025

Efficient Polycrystalline Single-Cation Perovskite Light-Emitting Diodes by Simultaneous Intracrystal and Interfacial Defect Passivation

Mohammad Khaja Nazeeruddin, Emad Oveisi

Polycrystalline perovskite light-emitting diodes (PeLEDs) have shown great promise with high efficiency and easy processability. However, PeLEDs using single-cation polycrystalline perovskite emitters have demonstrated low efficiency due to defects within ...

2025

Buried Hole-selective Interface Engineering for High-efficiency Tin-lead Perovskite Solar Cells with Enhanced Interfacial Chemical Stability

Guixiang Li

Mixed Sn-Pb perovskites are attracting significant attention due to their narrow bandgap and consequent potential for all-perovskite tandem solar cells. However, the conventional hole transport materials can lead to band misalignment or induce degradation ...

ELSEVIER2025

High‐Efficiency Sn‐Pb Perovskite Solar Cells via Nucleation and Crystallization Control

Mohammad Khaja Nazeeruddin

The rapid crystallization of mixed tin‐lead (Sn‐Pb) perovskites and their dependence on antisolvent processes limit the development of large‐area Sn‐Pb perovskite solar cells (PSCs). Vacuum‐flash‐assisted solution processing (VASP) has emerged as a promisi ...

Wiley2025

Enhancing Indoor Photovoltaic Eﬃciency to 37.6% Through Triple Passivation Reassembly and n-Type to p-Type Modulation in Wide Bandgap Perovskites

Michael Graetzel, Lukas Pfeifer

Despite well‐matching indoor illumination spectra, the performance of wide bandgap perovskite solar cells (WB‐PSCs) for indoor photovoltaics (i‐PV) is hindered by photo‐induced halide phase segregation and trap‐assisted non‐radiative recombination. Herein, ...

Wiley2025

Template-Assisted Growth of CsxFA1-xPbI3 with Pulsed Laser Deposition for Single Junction Perovskite Solar Cells

Christian Michael Wolff, Kerem Artuk

Cesium-formamidinium lead iodide (CsxFA1-xPbI3) perovskites are a promising methylammonium-free alternative for efficient single-junction solar cells. However, they have not been fully explored by vapor-phase deposition techniques. Herein, a template-assis ...

2025

Nanowire morphology control in Sb metal-derived antimony selenide photocathodes for solar water splitting

Wenzhe Niu

We report a facile method to enhance the photoelectrochemical (PEC) performance of Sb2Se3 photocathodes by controlling the growth of bilayer Sb2Se3 consisting of vertically oriented nanorods on a compact Sb2Se3 layer. Sb2Se3 thin films with controllable na ...

Royal Society of Chemistry2025

Beyond Flat: Undulated Perovskite Solar Cells on Microscale Si Pyramids by Solution Processing

Christophe Ballif, Aïcha Hessler-Wyser, Christian Michael Wolff, Kerem Artuk, Mostafa Rabie Shlaly Bahr Othman, Deniz Türkay

Microscale pyramids of silicon solar cells are often considered incompatible with solution-processed perovskite films. Thus, solution processing has mainly been used with submicron pyramids that are buried under thick perovskite films with flattened front ...

AMER CHEMICAL SOC2025

Monolayer-Thick GaN/AlN Quantum Well Anodes and Far-UVC Field Emission Device at 226 nm

Nicolas Grandjean, Jean-François Carlin, Pierre Jean-François Jules Demolon

Far-UVC light sources in the spectral range of200-230 nm effectively kill bacteria and deactivate viruses while being not harmful to health, enabling persistent disinfection of air and surfaces in the presence of humans. So far only excimer lamps have been ...

IEEE2025

Interfacial engineering through lead binding using crown ethers in perovskite solar cells

Kevin Sivula, Jun Ho Yum, Jovana Milic, Jiyoun Seo, Yeonju Kim

In the domain of perovskite solar cells (PSCs), the imperative to reconcile impressive photovoltaic performance with lead-related issue and environmental stability has driven innovative solutions. This study pioneers an approach that not only rectifies lea ...

Elsevier2024

Identification and Mitigation of Degradation Mechanisms Induced by Heat and Light in NiOx-based Perovskite Solar Cells

Marion Solange Madeleine Dussouillez

Perovskite solar cells (PSCs) offer an attractive solution to increase the efficiency of PV panels via perovskite/silicon tandems thanks to their potential cost-effectiveness and high efficiency. In inverted PSC architecture (p-i-n), commonly used hole con ...

EPFL2024

Alleviating nanostructural phase impurities enhances the optoelectronic properties, device performance and stability of cesium-formamidinium metal-halide perovskites

Anaël Morgane Jaffrès, Christophe Ballif, Quentin Thomas Jeangros, Aïcha Hessler-Wyser, Christian Michael Wolff, Mostafa Rabie Shlaly Bahr Othman, Daniel Anthony Jacobs, Austin George Kuba

The technique of alloying FA+ with Cs+ is often used to promote structural stabilization of the desirable alpha-FAPbI3 phase in halide perovskite devices. However, the precise mechanisms by which these alloying approaches improve the optoelectronic quality ...

Royal Soc Chemistry2024

A thermotropic liquid crystal enables efficient and stable perovskite solar modules

Mohammad Khaja Nazeeruddin, Bin Ding, Yong Ding

Perovskite solar cells have seen impressive progress in performance and stability, yet maintaining efficiency while scaling area remains a challenge. Here we find that additives commonly used to passivate large-area perovskite films often co-precipitate du ...

Nature Portfolio2024

Durable Perovskite Solar Cells with 24.5% Average Efficiency: The Role of Rigid Conjugated Core in Molecular Semiconductors

Michael Graetzel, Shaik Mohammed Zakeeruddin, Peng Wang, Felix Thomas Eickemeyer

Efficient and robust n-i-p perovskite solar cells necessitate superior organic hole-transport materials with both mechanical and electronic prowess. Deciphering the structure-property relationship of these materials is crucial for practical perovskite sola ...

Wiley-V C H Verlag Gmbh2024

Enhanced performance of perovskite solar cell via up-conversion YLiF4:Yb, Er nanoparticles

Mounir Driss Mensi, Masaud Hassan S Almalki, Anwar Qasem M Alanazi

We report a simple and effective method for producing lanthanide ion-doped lithium-fluoride-based nanocrystals (YLiF4). We utilized those nanoparticles for up-conversion in fabricated perovskite solar cells. The obtained results shows that the up-conversio ...

Elsevier2024

Elimination of buried interfacial voids for efficient perovskite solar cells

Bin Ding, Xianfu Zhang

Establishing optimal interfacial contact is crucial for enhancing the efficiency of perovskite solar cells (PSCs). However, formation of voids at buried interface of perovskite films often hinders this critical objective. Our investigation reveals that the ...

Elsevier2024

Shortwave Infrared-Sensitive, Narrowband Organic Upconversion Devices with a Gain

Wei-Hsu Hu

Sensing and imaging of light in the shortwave infrared (SWIR) range is increasingly used in various fields, including bio-imaging, remote sensing, and semiconductor process control. SWIR-sensitive organic photodetectors (OPDs) are promising because organic ...

EPFL2024

Structural divergence of molecular hole selective materials for viable p-i-n perovskite photovoltaics: a comprehensive review

Mohammad Khaja Nazeeruddin, Peng Gao

Perovskite solar cells (PSCs) have garnered significant attention within the photovoltaic research community due to their remarkable progress in just one decade. Among the device configurations, the p-i-n structured PSC offers several advantages, including ...

Royal Society of Chemistry2024

Integration of Metal Meshes as Transparent Conducting Electrodes into Perovskite Solar Cells

Andreas Schueler, Jérémy Jacques Antonin Fleury, René Uwe Schneider, Jakob Heier, Chiara Ongaro

As the demand for photovoltaic technologies continues to grow, the quest for efficient and sustainable transparent conducting electrodes (TCEs) rapidly rises. Traditional solutions, such as indium tin oxide (ITO), face challenges related to indium scarcity ...

Wiley2024

From PV to EV: Mapping the Potential for Electric Vehicle Charging with Solar Energy in Europe

Christophe Ballif, Nicolas Würsch, Alejandro Pena Bello, Noémie Alice Yvonne Ségolène Jeannin, Jérémy Dumoulin

The electrification of the transport sector is a key element in decarbonizing our societies. However, energy systems will have to cope with additional electricity demand due to the charging needs of electric vehicles (EVs) together with the integration of ...

2024