High Heat Flux Flow Boiling in Silicon Multi-Microchannels: Part I – Heat Transfer Characteristics of R-236fa

Chat with Graph Search

Ask any question about EPFL courses, lectures, exercises, research, news, etc. or try the example questions below.

DISCLAIMER: The Graph Chatbot is not programmed to provide explicit or categorical answers to your questions. Rather, it transforms your questions into API requests that are distributed across the various IT services officially administered by EPFL. Its purpose is solely to collect and recommend relevant references to content that you can explore to help you answer your questions.

Heat transfer differs in the regions where the flow is developed and developing thermally. These regions can be differentiated by using the thermal entry length. Many researchers have presented correlations to determine the thermal entry length for natural ...

As personal environmental control systems (PECS) gain prominence over conventional whole-space conditioning, accurately predicting personalized and localized thermal sensation (TS) becomes increasingly important. This study systematically evaluates the rel ...

A thermal diode, which, by analogy to its electrical counterpart, rectifies heat current, is the building block for thermal circuits. To realize a thermal diode, we demonstrate thermal rectification in a GaAs telescopic nanowire system using the thermal br ...

The focus of this study is to evaluate the effects of porous media inside the gas flow channel of Proton Exchange Membrane Fuel Cells (PEMFC) on four different output parameters of voltage, power density, pressure drop, and Nusselt number (Nu) considering ...

This study is focused on the experimental characterization of two-phase heat transfer performance and pressure drops within an ultracompact heat exchanger (UCHE) suitable for electronics cooling applications. In this specific work, the UCHE prototype is an ...

The LHCb VELO Upgrade I, currently being installed for the 2022 start of LHC Run 3, uses silicon microchannel coolers with internally circulating bi-phase CO2 for thermal control of hybrid pixel modules operating in vacuum. This is the largest scale applic ...

Parallel convection and E × B drifts act together to redistribute heat between the strike-points mechanisms is enhanced near the secondary X-point and is shown to dominate over heat in the low field side snowflake minus (LFS SF−). The cumulative heat conve ...

In this study, total heat transfer rate and pressure drop along a shell and tube heat exchanger (STHX) with 6 porous baffles are numerically investigated. To study the impacts of segmental porous baffles, three values for the permeability (10(-9) m(2), 10( ...

System (2) for CO2 capture from a combustion engine (1) comprising an exhaust gas flow circuit (6) having an inlet end fluidly connected to an exhaust of the combustion engine, a heat exchanger circuit (12), a primary exhaust gas heat exchanger (H1) for tr ...

This study presents the development and evaluation of a novel shell-and-tube heat exchanger (STHX) design with segmental porous baffles. Computational fluid dynamics (CFD) in combination with machine learning tools are utilized to investigate the thermo-hy ...

Next-generation High-Performance Computing (HPC) systems need to provide outstanding performance with unprecedented energy efficiency while maintaining servers at safe thermal conditions. Air cooling presents important limitations when employed in HPC infr ...

Explosive silicic volcanism is driven by gas overpressure in systems that are inefficient at outgassing. The zone at the margin of a volcanic conduit-thought to play an important role in the outgassing of magma and therefore pore pressure changes and explo ...

Superconducting wires are not perfectly homogeneous in term of critical current as well as stabilization. In resistive fault current limiter applications this could lead to hot spots if the fault current is only slightly above the nominal current of the de ...

In the second article of the present two-part paper, upward single-phase heat transfer within a compact plate heat exchanger was investigated experimentally. The experimental setup, the data reduction technique and pressure drop results were presented in P ...

New experimental flow boiling heat transfer results averaged along a very low thermal conductivity polyimide channel are presented. The experimental setup consists of a horizontal, 285 mm-long, 2.689 mm inner diameter polyimide tube, heated by a counter-cu ...

A comprehensive experimental campaign has been conducted to measure the local heat transfer coefficients during flow boiling of refrigerants in multi-microchannel evaporators. Two additional refrigerants (R245fa and R236fa) were tested in two silicon evapo ...

This two-part paper presents experimental work to characterize thermal and hydraulic performances of a compact plate heat exchanger. Upward single-phase heat transfer and pressure drop of low pressure, liquid refrigerants R245fa and R236fa was investigated ...

This article introduces the energetic macroscopic representation (EMR) as approach for the dynamic nonlinear modeling of a reciprocating air compressor. EMR has been introduced recently for research development in complex electromechanical systems and is b ...

New enhanced boiling tubes from Wolverine Tube Inc. (Turbo-B5) and Wieland-Werke AG (Gewa-B5) were investigated using R-134a and R-236fa as test fluids. The tests were done at saturation temperatures of 5 and 15 degrees C, mass flow rates from 4 to 35 kg m ...

This paper presents an overview of new technologies and applications on thermoactive geostructures. A discussion session on issues involved with near surface geothermal systems is presented, focusing on opportunities for developing new technologies to addr ...

High Heat Flux Flow Boiling in Silicon Multi-Microchannels: Part I – Heat Transfer Characteristics of R-236fa

Chat with Graph Search

Heat transfer in the entrance region of annular laminar flow with constant and different heat flux on two walls

Rethinking local thermal sensation prediction: The role of heat flux over skin temperature in personalized models

Thermal Rectification in Telescopic Nanowires: Impact of Thermal Boundary Resistance

Evaluation Criterion of Proton Exchange Membrane (ECPEM) fuel cells considering inserted porous media inside the gas flow channel

Ultra-Compact Microscale Heat Exchanger for Advanced Thermal Management in Data Centers

Microchannel cooling for the LHCb VELO Upgrade I

Parallel convection and E × B drifts in the TCV snowflake divertor and their effects on target heat-fluxes

Thermal optimization of shell and tube heat exchanger using porous baffles

System for co2 capture from internal combustion engine

Shape optimization of segmental porous baffles for enhanced thermo-hydraulic performance of shell-and-tube heat exchanger

Design of a Two-Phase Gravity-Driven Micro-Scale Thermosyphon Cooling System for High-Performance Computing Data Centers

From rock to magma and back again: The evolution of temperature and deformation mechanism in conduit margin zones

Insulation effect on thermal stability of Coated Conductors wires in liquid nitrogen

High resolution infrared measurements of single-phase flow of R245fa and R236fa within a compact plate heat exchanger, Part 2: Heat transfer results

Experimental flow boiling heat transfer in a small polyimide channel

Local measurements and a new flow pattern based model for subcooled and saturated flow boiling heat transfer in multi-microchannel evaporators

High resolution infrared measurements of single-phase flow of R245fa and R236fa within a compact plate heat exchanger, Part 1: Experimental setup and pressure drop results

Energetic Macroscopic Representation of A Linear Reciprocating Compressor Model

Flow boiling data and prediction method for enhanced boiling tubes and tube bundles with R-134a and R-236fa including a comparison with falling film evaporation

New technologies and applications: materials and equipment in near surface geothermal systems