José Miguel Molina Jorda

Chat with Graph Search

Ask any question about EPFL courses, lectures, exercises, research, news, etc. or try the example questions below.

DISCLAIMER: The Graph Chatbot is not programmed to provide explicit or categorical answers to your questions. Rather, it transforms your questions into API requests that are distributed across the various IT services officially administered by EPFL. Its purpose is solely to collect and recommend relevant references to content that you can explore to help you answer your questions.

Al/SiC composites with volume fractions of SiC between 0.55 and 0.71 were made from identical tapped and vibrated powder preforms by squeeze casting (SC) and by two different setups for gas pressure infiltration (GPI), one that allows short (1-2 min) liqui ...

The work needed to mechanically drive molten metal into a porous solid preform when producing a composite material by infiltration can significantly exceed the energy change required for thermodynamically reversible infiltration. We measure, by quantitativ ...

The thermal conductivity of aluminum matrix composites having a high volume fraction of SiC particles is investigated by comparing data for composites fabricated by infiltrating liquid aluminum into preforms made either from a single particle size, or by m ...

We present dynamic measurement of drainage curves in two systems having relevance to metal matrix composite processing, namely SiC/Al and SiC/Al-12.2at%Si. Data show that liquid/solid chemical reactions that cause a lowering of the contact angle do indeed ...

Aluminum matrix composites reinforced with mixtures of diamond and SiC particles of equal size were produced by gas pressure assisted liquid metal infiltration. Replacing SiC gradually by diamond particles results in a steady increase of thermal conductivi ...

Drainage curves (plots of the non-wetting fluid saturation versus applied pressure) for infiltration of SiC particle preforms with Al and Al-12.2 at.% Si are measured at 1023 K (750 degrees C) with a pressure infiltration apparatus adapted for direct track ...

A new technique is proposed for the direct measurement of capillary forces in systems of relevance to the infiltration processing of metal matrix composites. Capable of handling melt temperatures up to 1500 K and infiltration pressures up to 20 MPa, the te ...

The high-temperature wettability of AlN particle preforms with pure molten Cu, Al and Ph is quantified by means of drainage curves measured during pressure infiltration. By integrating the drainage curves obtained in this study, the work of immersion for e ...

José Miguel Molina Jorda

Chat with Graph Search

Influence of processing route on electrical and thermal conductivity of Al/SiC composites with bimodal particle distribution

Surface energy contributions to the work of infiltration in metal matrix composite processing

Thermal conductivity of Al-SiC composites with monomodal and bimodal particle size distribution

Direct measurement of drainage curves in infiltration of SiC particle preforms: influence of interfacial reactivity

Thermal conductivity of aluminum matrix composites reinforced with mixtures of diamond and SiC particles

Direct measurement of drainage curves in infiltration of SiC particle preforms

Measuring and tailoring capillary forces during liquid metal infiltration

High-temperature wettability of aluminum nitride during liquid metal infiltration

Assessing predictive schemes for thermal conductivity against diamond-reinforced silver matrix composites at intermediate phase contrast

Infiltration of graphite preforms with Al-Si eutectic alloy and mercury