Mediaspace scheduled maintenance: Aug 25, 2026 07:00 - 12:00 AM. During this time, videos will be temporarily unavailable. Check status updates.

Lecture

Transistor Bipolar: Introduction

Description

This lecture covers the electrical specifications, temperature behavior, and small signal linear model of bipolar transistors. It also explains the symbols, structures, and characteristics of transistors in different configurations.

In MOOC

Electronics II

Official source

Related concepts (31)

Transistor

A transistor is a semiconductor device used to amplify or switch electrical signals and power. It is one of the basic building blocks of modern electronics. It is composed of semiconductor material, usually with at least three terminals for connection to an electronic circuit. A voltage or current applied to one pair of the transistor's terminals controls the current through another pair of terminals. Because the controlled (output) power can be higher than the controlling (input) power, a transistor can amplify a signal.

Bipolar junction transistor

A bipolar junction transistor (BJT) is a type of transistor that uses both electrons and electron holes as charge carriers. In contrast, a unipolar transistor, such as a field-effect transistor (FET), uses only one kind of charge carrier. A bipolar transistor allows a small current injected at one of its terminals to control a much larger current flowing between the terminals, making the device capable of amplification or switching. BJTs use two p–n junctions between two semiconductor types, n-type and p-type, which are regions in a single crystal of material.

History of the transistor

A transistor is a semiconductor device with at least three terminals for connection to an electric circuit. In the common case, the third terminal controls the flow of current between the other two terminals. This can be used for amplification, as in the case of a radio receiver, or for rapid switching, as in the case of digital circuits. The transistor replaced the vacuum-tube triode, also called a (thermionic) valve, which was much larger in size and used significantly more power to operate.

Resistor–transistor logic

Resistor–transistor logic (RTL) (sometimes also transistor–resistor logic (TRL)) is a class of digital circuits built using resistors as the input network and bipolar junction transistors (BJTs) as switching devices. RTL is the earliest class of transistorized digital logic circuit; it was succeeded by diode–transistor logic (DTL) and transistor–transistor logic (TTL). RTL circuits were first constructed with discrete components, but in 1961 it became the first digital logic family to be produced as a monolithic integrated circuit.

Transistor count

The transistor count is the number of transistors in an electronic device (typically on a single substrate or "chip"). It is the most common measure of integrated circuit complexity (although the majority of transistors in modern microprocessors are contained in the cache memories, which consist mostly of the same memory cell circuits replicated many times). The rate at which MOS transistor counts have increased generally follows Moore's law, which observed that the transistor count doubles approximately every two years.

Related lectures (52)

Transistor Bipolar Modeling: Small Signal Linear Model MOOC: Electronics II

Explains the small signal linear model of a bipolar transistor in operation.

The Transistor: An Invention of First Plan

Explores the invention, structure, and significance of the transistor in electronics.

Transistor Bipolaire: Summary and Examples MOOC: Electronics II

Covers the large signal equivalent diagrams of bipolar transistors in normal and saturation modes.

Introduction to Small Signal Configurations MOOC: Electronics II

Covers small signal configurations, transistor modeling, resistors, gain calculations, and assembly selection in electronics.

Transistor Amplifiers: Voltage Amplifiers MOOC: Electronics II