Mediaspace scheduled maintenance: Aug 25, 2026 07:00 - 12:00 AM. During this time, videos will be temporarily unavailable. Check status updates.

Lecture

Operational Amplifier: Frequency-Dependent Gain Amplifier

Description

This lecture covers the frequency-dependent gain amplifier using operational amplifiers. It discusses the transfer function in the sinusoidal regime, the 1st order low-pass active filter, and the frequency behavior with different values of resistance and capacitance.

In MOOC

Electronics I

Official source

Quiz

Ontological neighbourhood

Information engineering

Signal processing: Filtering theory

Related concepts (24)

Electronic filter

Electronic filters are a type of signal processing filter in the form of electrical circuits. This article covers those filters consisting of lumped electronic components, as opposed to distributed-element filters. That is, using components and interconnections that, in analysis, can be considered to exist at a single point. These components can be in discrete packages or part of an integrated circuit. Electronic filters remove unwanted frequency components from the applied signal, enhance wanted ones, or both.

Low-pass filter

A low-pass filter is a filter that passes signals with a frequency lower than a selected cutoff frequency and attenuates signals with frequencies higher than the cutoff frequency. The exact frequency response of the filter depends on the filter design. The filter is sometimes called a high-cut filter, or treble-cut filter in audio applications. A low-pass filter is the complement of a high-pass filter. In optics, high-pass and low-pass may have different meanings, depending on whether referring to the frequency or wavelength of light, since these variables are inversely related.

High-pass filter

A high-pass filter (HPF) is an electronic filter that passes signals with a frequency higher than a certain cutoff frequency and attenuates signals with frequencies lower than the cutoff frequency. The amount of attenuation for each frequency depends on the filter design. A high-pass filter is usually modeled as a linear time-invariant system. It is sometimes called a low-cut filter or bass-cut filter in the context of audio engineering. High-pass filters have many uses, such as blocking DC from circuitry sensitive to non-zero average voltages or radio frequency devices.

Band-pass filter

A band-pass filter or bandpass filter (BPF) is a device that passes frequencies within a certain range and rejects (attenuates) frequencies outside that range. In electronics and signal processing, a filter is usually a two-port circuit or device which removes frequency components of a signal (an alternating voltage or current). A band-pass filter allows through components in a specified band of frequencies, called its passband but blocks components with frequencies above or below this band.

Operational amplifier

An operational amplifier (often op amp or opamp) is a DC-coupled high-gain electronic voltage amplifier with a differential input and, usually, a single-ended output. In this configuration, an op amp produces an output potential (relative to circuit ground) that is typically 100,000 times larger than the potential difference between its input terminals. The operational amplifier traces its origin and name to analog computers, where they were used to perform mathematical operations in linear, non-linear, and frequency-dependent circuits.

Related lectures (53)

Signal Sampling 4: Ideal Low-Pass Filtering

Explores ideal low-pass filtering of signals to reduce noise and distortions.

Signal Filtering MOOC: Information, Computation, Communication: Introduction to computational thinking

Explores signal filtering using low-pass filters to reduce noise and distortions in signals, showcasing frequency suppression and smoothing effects.

Demodulation Revisited

Revisits demodulation, focusing on eliminating unwanted high frequency components.

Memory Cache Organization and Signal Filtering

Discusses memory cache organization and signal filtering techniques using a moving average filter to recover desired signals.

Electrocardiogram & Photoplethysmogram: Circuits Design & Analysis Log in to Mediaspace to watch this video