Mediaspace scheduled maintenance: Aug 25, 2026 07:00 - 12:00 AM. During this time, videos will be temporarily unavailable. Check status updates.

Concept

Vacuum pump

Related publications (26)

Small-scale turbopumps for waste heat recovery applications based on an organic Rankine cycle: a study from pre-design to experimental validation

Sajjad Zakeralhoseini

The organic Rankine cycle (ORC) system is among the technologies applied to exploit waste heat in vehicles. Since common organic fluids have lower latent heat than water, higher mass flow rates are required to convert the same waste heat, considerably incr ...

EPFL2023

Dielectric Elastomer Actuator-Based Valveless Impedance-Driven Pumping for Meso- and Macroscale Applications

Yves Perriard, Yoan René Cyrille Civet, Thomas Guillaume Martinez, Armando Matthieu Walter, Amine Benouhiba, Francesco Clavica, Silje Ekroll Jahren

Impedance pumps are simple designs that allow the generation or amplification of flow. They are fluid-filled systems based on flexible tubing connected to tubing with different impedances. A periodic off-center compression of the flexible tubing causes the ...

2023

Bioinspired Soft Bendable Peristaltic Pump Exploiting Ballooning for High Volume Throughput

Josephine Anna Eleanor Hughes

Interest in bioinspired peristaltic pumps has grown in popularity among the scientific community in the last decade thanks to their extreme flexibility and their intrinsic compliance. In this paper, we propose a soft peristaltic pump exploiting ballooning. ...

IEEE-INST ELECTRICAL ELECTRONICS ENGINEERS INC2022

Piezoelectric suspended microchannel resonators

Damien Maillard

The objective of this PhD thesis is the development of a microfluidic platform for the real-time measurements of the mechanical properties of biological analytes at the single entity level. The systems developed for these purposes consist of piezoelectrica ...

EPFL2022

InP/Si3N4 Hybrid External-Cavity Laser with sub-kHz Linewidth Acting as a Pump Source for Kerr Frequency Combs

Tobias Kippenberg, Junqiu Liu

We report on an InP/Si3N4 hybrid integrated ECL that relies on 3D-printed coupling elements such as intra-cavity photonic wire bonds and facet-attached microlenses. We demonstrate 90 nm tuning range, SMSR above 60 dB, and intrinsic linewidths of 979 Hz. We ...

IEEE2022

Non-evaporable getter pump operations in the TCV tokamak

Ambrogio Fasoli, Stefano Coda, Basil Duval, Yves Martin, Holger Reimerdes, Frédéric Dolizy, Marcelo Baquero Ruiz

A non-evaporable getter pump using the ZAO alloy was installed on TCV and operated during the 2019 experimental campaign. The pump performance, determined from in-situ pumping speed measurements, indicates that current getter pump technologies are well sui ...

2021

Techno-economic assessment of postcombustion carbon capture using high-performance nanoporous single-layer graphene membranes

Kumar Varoon Agrawal, Mostapha Dakhchoune, Marina Micari

High-performance membranes have emerged as an energy-efficient alternative to absorption-based postcombustion carbon capture. So far, the techno-economic analyses have been centered around the polymeric membranes. Recently, nanoporous single-layer graphene ...

2021

Performance of a high vacuum, high temperature compatible millimeter-range viewing dump for the vertical ECE experiment on TCV

Ambrogio Fasoli, Laurie Porte, Arsène Stéphane Tema Biwole

A high vacuum and high temperature compatible viewing dump, made of MACOR, was designed and installed in TCV for Vertical ECE experiments in the 75-110 GHz frequency range. Measurements of the dump prior to installation in the tokamak showed in more than 9 ...

2021

Beam induced vacuum effects in the future circular hadron collider beam vacuum chamber

Lotta Maria Mether

EuroCirCol is a conceptual design study of a post-LHC, Future Circular Hadron Collider (FCC-hh) with 50 TeV of beam energy and 100 km long, which aims to expand the current energy and luminosity frontiers. The vacuum chamber of the FCC-hh will have to cope ...

2020

Electrically-Driven Soft Fluidic Actuators Combining Stretchable Pumps With Thin McKibben Muscles

Herbert Shea, Vito Cacucciolo

Soft wearable robots could provide support for lower and upper limbs, increase weight lifting ability, decrease energy required for walking and running, and even provide haptic feedback. However, to date most of wearable robots are based on electromagnetic ...

2020

Electron flux and pressure dynamic in the LHC vacuum pilot sector as a function of beam parameters and beam pipe properties

Ambrogio Fasoli, Elena Buratin

The Large Hadron Collider (LHC) is affected by the electron cloud (EC) phenomenon that can provoke beam instabilities, detrimental heat loads and pressure increases in the vacuum system. An innovative dedicated system called vacuum pilot sector (VPS) provi ...

2020

Optomechanical generation of a mechanical catlike state by phonon subtraction

Tobias Kippenberg, Liu Qiu, Itay Shomroni

We propose a scheme to prepare a macroscopic mechanical oscillator in a catlike state, close to a coherent state superposition. The mechanical oscillator, coupled by radiation-pressure interaction to a field in an optical cavity, is first prepared close to ...

AMER PHYSICAL SOC2020

Vortex siphon - from 1:1 scale physical model to SPH simulation and prototype

Giovanni De Cesare

The rail link between Geneva Cornavin Station, Eaux-Vives Station and Annemasse (CEVA) is currently under construction including a cut-and-cover tunnel built by slurry walls located in the alluvium of the Foron River. The covered trench cuts the groundwate ...

2019

Tests and developments of a long-pulse high-power 170 GHz absorbing matched load

Timothy Goodman, Stefano Alberti, Jean-Philippe Hogge, Damien Fasel, Francesca Maria Poli, Francisco Sanchez, Ioannis Pagonakis

The future EC systems will consist of several gyrotron sources providing MW-level millimeter wave power at a frequency around or above 170 GHz. The development of matched loads is necessary to test the new sources, the components for the transmission lines ...

ELSEVIER SCIENCE SA2019

A Molecular Dual Pump

Cristian Pezzato

Artificial molecular machines (AMMs) built from mechanically interlocked molecules (MIMs) can use energy ratchets to control the unidirectional motion of their component parts. These energy ratchets are operated by the alteration of kinetic barriers and th ...

AMER CHEMICAL SOC2019

Oxygen diffusion through air–water free surfaces in a pump–turbine operating in condenser mode

François Avellan, Elena Vagnoni, Loïc Andolfatto

The present research aims at understanding the mass transfer of air into water in a reversible pump turbine operating in condenser mode. In particular, the diffusion of oxygen through the water free-surface both in the vaneless gap between the impeller bla ...

2019

On the hysteresis of cavitation incipience and desinence in hydraulic machines

Mohamed Farhat, Ali Amini, Martino Reclari

The omnipresent vortical structures in hydraulic machines are extremely prone to the occurrence of cavitation. It is well known that besides the flow parameters, the incipience, development, and disappearance of cavitation within a vortex is very sensitive ...

IOP Publishing2019

Probing cardiac metabolism by hyperpolarized 13C MR using an exclusively endogenous substrate mixture and photo-induced nonpersistent radicals

Rolf Gruetter, Andrea Capozzi, Arnaud Comment, Josefina Adriana Maria Bastiaansen, Hikari Ananda Infinity Yoshihara

Purpose To probe the cardiac metabolism of carbohydrates and short chain fatty acids simultaneously in vivo following the injection of a hyperpolarized 13C-labeled substrate mixture prepared using photo-induced nonpersistent radicals. Methods Droplets of m ...

Wiley2018

Simulation of pump-turbine prototype fast mode transition for grid stability support

François Avellan, Christophe Nicolet, Nicolas Ruchonnet, Antoine Béguin

The paper explores the additional services that Full Size Frequency Converter, FSFC, solution can provide for the case of an existing pumped storage power plant of 2x210 MW, for which conversion from fixed speed to variable speed is investigated with a foc ...

2017

Experimental evidence of inter-blade cavitation vortex development in Francis turbines at deep part load condition

François Avellan, Arthur Tristan Favrel, Keita Yamamoto

Francis turbines are subject to various types of cavitation flow depending on the operating condition. To enable a smooth integration of the renewable energy sources, hydraulic machines are now increasingly required to extend their operating range, especia ...

Springer Verlag2017