Mediaspace scheduled maintenance: Aug 25, 2026 07:00 - 12:00 AM. During this time, videos will be temporarily unavailable. Check status updates.

Concept

Pump

Related publications (31)

Fast-Response Variable-Stiffness Magnetic Catheters for Minimally Invasive Surgery

Dario Floreano, Jun Shintake, Yegor Piskarev, Yi Sun

In minimally invasive surgery, such as cardiac ablation, magnetically steered catheters made of variable-stiffness materials can enable higher dexterity and higher force application to human tissue. However, the long transition time between soft and rigid ...

2024

Small-scale turbopumps for waste heat recovery applications based on an organic Rankine cycle: a study from pre-design to experimental validation

Sajjad Zakeralhoseini

The organic Rankine cycle (ORC) system is among the technologies applied to exploit waste heat in vehicles. Since common organic fluids have lower latent heat than water, higher mass flow rates are required to convert the same waste heat, considerably incr ...

EPFL2023

Fiber pumps for wearable fluidic systems

Herbert Shea, Vito Cacucciolo, Michael James Henry Smith

Incorporating pressurized fluidic circuits into textiles can enable muscular support, thermoregulation, and haptic feedback in a convenient wearable form factor. However, conventional rigid pumps, with their associated noise and vibration, are unsuitable f ...

American Association for the Advancement of Science2023

Dielectric Elastomer Actuator-Based Valveless Impedance-Driven Pumping for Meso- and Macroscale Applications

Yves Perriard, Yoan René Cyrille Civet, Thomas Guillaume Martinez, Armando Matthieu Walter, Amine Benouhiba, Francesco Clavica, Silje Ekroll Jahren

Impedance pumps are simple designs that allow the generation or amplification of flow. They are fluid-filled systems based on flexible tubing connected to tubing with different impedances. A periodic off-center compression of the flexible tubing causes the ...

2023

Design, computational and experimental investigation of a small-scale turbopump for organic Rankine cycle systems

Jürg Alexander Schiffmann, Sajjad Zakeralhoseini

The hydraulic design, computational analysis, and experimental investigations of a high-speed small-scale turbopump for mobile waste heat recovery applications based on organic Rankine cycle systems are presented in this paper. Such applications demand hig ...

Elsevier2023

High-speed turbocompressors for natural fluid heat-pumps: from integrated design to digital-twin

Luis Eric Olmedo Ocampo

Compressors for commercial and industrial heat-pumps in the 100kW-load range are currently dominated by positive displacementmachines. In the context of refrigerant phaseouts and changing regulations, natural refrigerants are seen as a compelling alternati ...

EPFL2023

Research data supporting 'Fiber pumps for wearable fluidic systems'

Herbert Shea, Vito Cacucciolo, Michael James Henry Smith

The dataset supporting 'Fiber pumps for wearable fluidic systems', published in Science in March 2023. In this work, we present a fluidic pump in the form of a flexible and stretchable tube. These tubes - or 'fiber pumps' - can generate significant fluidic ...

2023

Modeling of solids particle diversion to promote uniform growth of multiple hydraulic fractures

Guanyi Lu

Solid particulate additives are sometimes used to promote the uniform growth of multiple hydraulic fractures in horizontal oil and gas wells. The principle is that solid particulates block, accumulate, and form larger porous plugging zones preferentially a ...

ELSEVIER2023

Structural impact of the start-up sequence on Pelton turbines lifetime: Analytical prediction and polynomial optimization

Mario Paolone, Elena Vagnoni, Aldo Leonardo Alerci

Hydropower plants play a crucial role in the power system facing ambitious renewable energy targets. Due to their inherent controllability, they are well suited to provide flexibility to the grid. However, an increased flexibility provision leads to a prol ...

Pergamon-Elsevier Science Ltd2023

Bioinspired Soft Bendable Peristaltic Pump Exploiting Ballooning for High Volume Throughput

Josephine Anna Eleanor Hughes

Interest in bioinspired peristaltic pumps has grown in popularity among the scientific community in the last decade thanks to their extreme flexibility and their intrinsic compliance. In this paper, we propose a soft peristaltic pump exploiting ballooning. ...

IEEE-INST ELECTRICAL ELECTRONICS ENGINEERS INC2022

InP/Si3N4 Hybrid External-Cavity Laser with sub-kHz Linewidth Acting as a Pump Source for Kerr Frequency Combs

Tobias Kippenberg, Junqiu Liu

We report on an InP/Si3N4 hybrid integrated ECL that relies on 3D-printed coupling elements such as intra-cavity photonic wire bonds and facet-attached microlenses. We demonstrate 90 nm tuning range, SMSR above 60 dB, and intrinsic linewidths of 979 Hz. We ...

IEEE2022

Numerical Studies of Brillouin-induced Polarization Pulling of Probe and Pump in Weakly-Birefringent Optical fibers with Applications to BOTDA

Luc Thévenaz, Marcelo Alfonso Soto Hernandez

Numerical solution of the involved governing equations confirm that the commonly used two orthogonal sets of gain- and loss-probes in BOTDA, differently affect the evolution of the pump state-of- polarization, thereby potentially compromising the minimizat ...

Optica Publishing Group2022

Closed-loop technique using gain balance for fast Brillouin Optical Time-Domain Analysis

Luc Thévenaz, Zhisheng Yang, Li Zhang, Ana Gabriela Correa Mena

A closed-loop servo control based on the gain ratio of two probing frequencies is proposed for fast BOTDA, where the feedback is independent of probe and pump loss, making it robust in harsh environment. ...

Optica Publishing Group2022

Generation of Optical Frequency Combs in an Optical Microresonator Pumped by a 780-nm Laser Diode in Self-Injection Locking Regime

Andrey Voloshin

Experimental data for the generation of optical frequency combs in magnesium fluoride microcavities with whispering gallery modes at 780 nm are presented. This wavelength corresponds to the normal group velocity dispersion for pumping by a laser diode oper ...

2022

Numerical investigation on the volute cutwater for pumps running in turbine mode

Elena Vagnoni, Alessandro Morabito

The hydropower sector has recently raised the interest in pump as turbine (PaT) that can be a valid trade-off between capital cost and performance in micro-scale installations. Nevertheless, the modest efficiency of PaTs often restricts their exploitation. ...

Pergamon-Elsevier Science Ltd2021

Gain-switched semiconductor laser driven soliton microcombs

Tobias Kippenberg, Junqiu Liu, Erwan Guillaume Albert Lucas, Wenle Weng, Jijun He

Dissipative Kerr soliton generation using self-injection-locked III-V lasers has enabled fully integrated hybrid microcombs that operate in turnkey mode and can access microwave repetition rates. Yet, continuous-wave-driven soliton microcombs exhibit low e ...

Nature Research2021

Techno-economic assessment of postcombustion carbon capture using high-performance nanoporous single-layer graphene membranes

Kumar Varoon Agrawal, Mostapha Dakhchoune, Marina Micari

High-performance membranes have emerged as an energy-efficient alternative to absorption-based postcombustion carbon capture. So far, the techno-economic analyses have been centered around the polymeric membranes. Recently, nanoporous single-layer graphene ...

2021

Investigation of the Time Resolution Set Up Used to Compute the Full Load Vortex Rope in a Francis Turbine

François Avellan, Arthur Tristan Favrel, Cécile Münch-Alligné, Andres Müller

The flow in a Francis turbine at full load is characterised by the development of an axial vortex rope in the draft tube. The vortex rope often promotes cavitation if the turbine is operated at a sufficiently low Thoma number. Furthermore, the vortex rope ...

2021

Non-evaporable getter pump operations in the TCV tokamak

Ambrogio Fasoli, Stefano Coda, Basil Duval, Yves Martin, Holger Reimerdes, Frédéric Dolizy, Marcelo Baquero Ruiz

A non-evaporable getter pump using the ZAO alloy was installed on TCV and operated during the 2019 experimental campaign. The pump performance, determined from in-situ pumping speed measurements, indicates that current getter pump technologies are well sui ...

2021

CFD simulations of a Y-junction for the implementation of hydraulic short-circuit operating mode

François Avellan, Cécile Münch-Alligné, Daniel Biner

In the framework of the XFLEX HYDRO H2020 European Project, one of the demonstrators focuses on the implementation of the hydraulic short-circuit on the pump storage power plant of Grand-Maison owned by Electricite De France (EDF). The Grand-Maison power p ...

IOP Publishing2021