Publications associées à Selective ion-induced grain growth: Thermal spike modeling and its experimental validation

Optimizing Atomic Layer Deposition Processes with Nanowire-Assisted TEM Analysis

Atomic layer deposition (ALD) is one of the premier methods to synthesize ultra-thin materials on complex surfaces. The technique allows for precise control of the thickness down to single atomic layers, while at the same time providing uniform coverage ev ...

Wiley2024

Scanning Tunneling Microscopy for Molecules: Effects of Electron Propagation into Vacuum

Klaus Kern, Abhishek Grewal

Using scanning tunneling microscopy (STM), we experimentally and theoretically investigate isolated platinum phthalocyanine (PtPc) molecules adsorbed on an atomically thin NaCl(100) film vapor deposited on Au(111). We obtain good agreement between theory a ...

Amer Chemical Soc2024

Towards Scalable Electronics: Synthetic 2D Materials for Large-Area 2D Circuit Integration

Zhenyu Wang

In the past decades, a significant increase of the transistor density on a chip has led to exponential growth in computational power driven by Moore's law. To overcome the bottleneck of traditional von-Neumann architecture in computational efficiency, effo ...

EPFL2024

Font Side Solutions for c-Si Solar Cells with High-Temperature Passivating Contacts

Ezgi Genç

In this work, we studied the potential of using thin films deposited by plasma-enhanced chemical vapor deposition (PECVD) for two main purposes: introducing an n-type passivating contact at the front of a TOPCon solar cell, or simplifying the fabrication o ...

EPFL2024

Influence of Ventilation on Formation and Growth of 1-20 nm Particles via Ozone-Human Chemistry

Dusan Licina, Shen Yang, Marouane Merizak, Meixia Zhang

Ozone reaction with human surfaces is an important source of ultrafine particles indoors. However, 1-20 nm particles generated from ozone-human chemistry, which mark the first step of particle formation and growth, remain understudied. Ventilation and indo ...

Amer Chemical Soc2024

On the importance of the humidity flux for the surface mass balance in the accumulation zone of the Greenland Ice Sheet

Sonja Wahl

It is highly uncertain how the humidity flux between the snow surface and the atmosphere contributes to the surface mass balance (SMB) of the interior Greenland Ice Sheet (GrIS). Due to sparse observations, evaluations of the simulated humidity flux are li ...

Copernicus Gesellschaft Mbh2024

Plasma-Assisted Hybrid Vapour Deposition Technology for Thin Film Fabrication

Caroline Hain

Continuous development of thin film deposition technologies is essential for the fabrication of films that meet the specific requirements of their target applications and working conditions. Therefore, it is necessary to increase the number of accessible a ...

EPFL2023

III-V Nitride Semiconductors Deposited At Low Temperature For Photovoltaic Applications

Jonathan Emanuel Thomet

This thesis reports on the study and use of low temperature processes for the deposition of indium gallium nitride (InGaN) thin films in order to alleviate some of the present drawbacks of its monolitic deposition on silicon for photovoltaic applications. ...

EPFL2023

Synthesis of metal oxide-overcoated carbon materials by liquid phase ALD and their applications in catalysis

Farzaneh Talebkeikhah

Coating nano particles and other substrates for efficiency enhancement, protection and obtaining new atomic structures is a widespread research topic in catalysis and material synthesis. Thus far, different approaches of coating, ranging from simplest to s ...

EPFL2023

Control of intermetallics in the interface in directed energy deposition of titanium on stainless steel 316L

Di Cui

Application of a single metal or alloy is often restricted by its properties from optimal combination of performance and cost. Therefore, there is a vast need of joining dissimilar metals for various applications in biomedical, aerospace, automobile and ma ...

EPFL2023

Methylamine Post-Deposition Treatments of Vapor-Deposited Perovskite Thin Films

Austin George Kuba

While the development of methylammonium lead iodide (MAPbI(3)) perovskite for photovoltaics has grown rapidly, the growth of high-quality material from vapor processes continues to be difficult due to challenges including crystallinity control. Methylamine ...

IEEE2023

Vapor Deposition of Perovskite Solar Cells

Quentin Jean-Marie Armand Guesnay

Thanks to the continuous improvement of crystalline silicon (c-Si) solar cells, largely dominating the market, photovoltaic electricity is nowadays the cheapest source of energy on the market. Yet, solar energy is far from being completely harvested, as t ...

EPFL2023

Limits between surface and inner clogging of riverbed by fine sediment

Giovanni De Cesare, Romain Maxime Dubuis

The deposition of fine sediment on top of the riverbed affects the reproduction of spawning fishes and some species of benthos. The clogging of the substrate resulting from this deposition is a well-known issue in rivers affected by anthropogenic activity ...

2023

Investigation of thermoelectric nanomaterials

David Thomas Osenberg

Thermoelectric conversion remains an active research field in light of its potential to enhance energy efficiency by waste heat recovery in a noise and wear-free manner. Nanostructuring is responsible for most of the recently reported improvements of the ...

EPFL2023

Full Solution Process of a Near-Infrared Light-Emitting Electrochemical Cell Based on Novel Emissive Ruthenium Complexes of 1,10-Phenanthroline-Derived Ligands and a Eutectic Alloy as the Top Electrode

Mohammad Khaja Nazeeruddin

Near-infrared luminescent materials have recently received considerable attention for a large number of applications, including in solid-state lighting, as bioimaging agents, as photovoltaic cells, and in the telecommunication industry. By adding diverse e ...

AMER CHEMICAL SOC2023

CVD of MoS2 single layer flakes using Na2MoO4 - impact of oxygen and temperature-time-profile

Andreas Stemmer, Christian Wäckerlin

Two-dimensional (2D) materials are of great interest in many fields due to their astonishing properties at an atomic level thickness. Many fundamentally different methods to synthesize 2D materials, such as exfoliation or chemical vapor deposition (CVD), h ...

Royal Soc Chemistry2023

Influence of Sphericity on Surface Termination of Icosahedral Colloidal Clusters

Esther Amstad

Colloids self-organize into icosahedral clusters composed of a Mackay core and an anti-Mackay shell under spherical confinement to minimize the free energy. This study explores the variation of surface arrangements of colloids in icosahedral clusters, focu ...

Wiley-V C H Verlag Gmbh2023

Transparent Porous Conductive Substrates for Gas-Phase Photoelectrochemical Hydrogen Production

Jun Ho Yum, Kevin Sivula, Linda Lazouni, Loï Charles Carbone, Benjamin Goldman, Rebekah Anne Wells, Simon Nussbaum, Marina Caroline Michèle Caretti, Elizaveta Potapova Mensi, Hannah Elizabeth Johnson, Emeline Cécile Rideau

Gas diffusion electrodes are essential components of common fuel and electrolysis cells but are typically made from graphitic carbon or metallic materials, which do not allow light transmittance and thus limit the development of gas-phase based photoelectr ...

Wiley-V C H Verlag Gmbh2023

Site-selective overgrowth of Ag nanocrystals by Polyvinylpyrrolidone-mediated atom deposition by Ostwald ripening

Francesco Stellacci, Paulo Henrique Jacob Silva, Alejandro Lapresta Fernandez

The growth modulation of metal nanocrystals (NCs) by Ostwald ripening (OR) involves control of the relocation of matter by diffusional mass transfer from the dissolution of small nanocrystals (SNCs) towards large nanocrystals whose surface energy is lower. ...

ELSEVIER2022

Structural and photophysical investigation of single-source evaporation of CsFAPbI(3) and FAPbI(3) perovskite thin films

Mohammad Khaja Nazeeruddin, Hiroyuki Kanda, Nadja Isabelle Desiree Klipfel, Albertus Adrian Sutanto, Maria Cristina Momblona Rincón

Thermal vacuum deposition is a stimulating technique for upscaling perovskite solar cells. However, the operational complexity of multisource vapor deposition (MSVD) and achieving stoichiometric perovskite layers may impede its implementation. The single-s ...

Royal Society of Chemistry2022