Publications associées à Modeling snow and avalanches with the Material Point Method and finite strain elastoplasticity

Publications associées (29)

Noise-induced transitions past the onset of a steady symmetry-breaking bifurcation: The case of the sudden expansion

François Gallaire, Edouard Boujo, Yves-Marie François Ducimetière

We consider fluid flows, governed by the Navier-Stokes equations, subject to a steady symmetry-breaking bifurcation and forced by a weak noise acting on a slow timescale. By generalizing the multiple-scale weakly nonlinear expansion technique employed in t ...

2024

Anomalous dissipation and other non-smooth phenomena in fluids

Massimo Sorella

The thesis is dedicated to the study of two main partial differential equations (PDEs) in fluid dynamics: the Navier-Stokes equations, which describe the motion of incompressible fluids, and the transport equation with divergence-free velocity fields, whic ...

EPFL2024

Computational fluid dynamics simulations of the heat transfer properties of graphene-based nanolubricants and application to hydrodynamic lubrication

Roberto Guarino

In this paper, we consider experimental data available for graphene-based nanolubricants to evaluate their convective heat transfer performance by means of computational fluid dynamics (CFD) simulations. Single-phase models with temperature-dependent prope ...

Aip Publishing2024

Insights from an extensive triaxial testing campaign on a shale for comparative site characterization of a deep geological repository

Lyesse Laloui, Alessio Ferrari, Eleonora Crisci

Several boreholes were drilled for site comparison of a deep geological repository (DGR) in Northern Switzerland. The main target of the exploration program was the >100m thick Opalinus Clay, the designated host rock encountered at approximately 450 to 100 ...

Elsevier2024

Nonlinear simulation of plasma turbulence using a gyrokinetic moment-based approach

Antoine Cyril David Hoffmann

Plasma turbulence plays a fundamental role in determining the performances of magnetic confinement fusion devices, such as tokamaks. Advances in computer science, combined with the development of efficient physical models, have significantly improved our u ...

EPFL2024

Full-F turbulent simulation in a linear plasma device using a gyro-moment approach

Paolo Ricci, Baptiste Jimmy Frei

Simulations of plasma turbulence in a linear plasma device configuration are presented. These simulations are based on a simplified version of the gyrokinetic (GK) model proposed by Frei et al. [J. Plasma Phys. 86, 905860205 (2020)], where the full-F distr ...

Aip Publishing2024

Short-term behavior of glass fiber-polymer composite bending-active elastica beam under service load application

Thomas Keller, Landolf-Giosef-Anastasios Rhode-Barbarigos, Tara Habibi

Bending-active elastica beam is a structural configuration that is based on the elastic deformation of an initially straight beam. This deformation occurs when horizontal displacements are applied to a sliding support, causing the beam to bend into an arch ...

2024

Modeling the mechanics and rheology of porous and granular media: an elastoplastic continuum approach

Lars Kristoffer Uhlen Blatny

The complex mechanics of porous and granular media play a significant role in various industrial processes and natural phenomena. As an example, understanding the mechanics of how failure occurs, localizes and propagates in porous brittle solids under vari ...

EPFL2023

Visualization and modelling of dynamic flow in fibrous preforms for liquid composite molding

Helena Luisa Teixido Pedarros

Nowadays, Liquid Composite Molding techniques are often used to manufacture high quality fiber reinforced composite parts at a relatively low cost. These involve an infiltration process, in which a liquid resin is forced to ingress into a dry fibrous porou ...

EPFL2023

A fully-coupled highly-parallelized geomechanical simulator for assessing induced seismicity

Jean-François Molinari, Brice Tanguy Alphonse Lecampion, Guillaume Anciaux, Nicolas Richart, Emil Gallyamov

Induced seismicity caused by anthropogenic modification of the subsurface effective stress state has been observed in a number of industrial applications -- from hydrocarbon extraction (e.g., Groningen [1]), drilling waste-water disposal (e.g., [2]) to the ...

2023

Numerical simulation of immiscible incompressible viscous, viscoelastic and elastic multiphase flows

Léo Aurélio Diserens

A unified numerical framework is presented for the modelling of multiphasic viscoelastic and elastic flows. The rheologies considered range from incompressible Newtonian or Oldroyd-B viscoelastic fluids to Neo-Hookean elastic solids. The model is formulate ...

EPFL2023

Effect of wettability and textile architecture on fluid displacement and pore formation during infiltration of carbon fibrous preforms

Véronique Michaud, Baris Çaglar, Helena Luisa Teixido Pedarros

We seek to address how air entrapment mechanisms during infiltration are influenced by the wetting characteristics of the fluid and the pore network formed by the reinforcement. To this end, we evaluated the behavior of two model fluids with different surf ...

Elsevier Sci Ltd2023

Data-driven 1D wave propagation for site response analysis

Jean-François Molinari, Antonio Joaquin Garcia Suarez, Sacha Zenon Wattel

Prediction of ground motion triggered by earthquakes is a prime concern for both the seismology community and geotechnical earthquake engineering one. The subfield occupied with such a problem is termed site response analysis (SRA), its one-dimensional fla ...

WILEY2023

Strain Gradients and Magnetoresistance in Microstructured 3D Topological Semi-metals

Jonas De Jesus Diaz Gomez

Three-dimensional topological semimetals have emerged as strong candidates to probe new fundamental physical phenomena that could be exploited to develop next generation electronics. However, many aspects of their electronic properties remain unclear. Thi ...

EPFL2023

Influence of Viscous Lubricant on Nucleation and Propagation of Frictional Ruptures

Marie Estelle Solange Violay, François Xavier Thibault Passelègue, Federica Paglialunga

Fluids are pervasive in the Earth's crust and saturate fractures and faults. The combination of fluids and gouge layers developing along faults can generate fluids of different viscosities. Such viscous fluids were found to influence the reactivation, fric ...

2023

Permeability sets the linear path instability of buoyancy-driven disks

François Gallaire, Pier Giuseppe Ledda, Giuseppe Antonio Zampogna

The prediction of trajectories of buoyancy-driven objects immersed in a viscous fluid is a key problem in fluid dynamics. Simple-shaped objects, such as disks, present a great variety of trajectories, ranging from zig-zag to tumbling and chaotic motions. Y ...

Cambridge University Press2023

Rock-Flow Cell Parameters Evaluation Using Ultrasound Doppler Velocimetry

Giovanni De Cesare

This work presents a study of two-phase flow generated inside a rock-flow cell setup. It is characterized by a pipe section filled with fluid (oil in our studies) that is put into oscillation around its mass centre by an electric motor. This type of appara ...

2023

Three-dimensional buoyant hydraulic fractures: finite volume release

Brice Tanguy Alphonse Lecampion, Andreas Möri

In impermeable media, a hydraulic fracture can continue to expand even without additional fluid injection if its volume exceeds the limiting volume of a hydrostatically loaded radial fracture. This limit depends on the mechanical properties of the surround ...

Cambridge University Press2023

A Gyrokinetic Moment Model of the Plasma Boundary in Fusion Devices

Baptiste Jimmy Frei

The overall performance of fusion devices, such as tokamaks, is strongly correlated to the phenomena that occur in the boundary region, the outer plasma region that faces the wall of the device. The boundary plays a crucial role in regulating the heat and ...

EPFL2023

Highly Efficient Miniaturized Magnetorheological Valves Using Electropermanent Magnets

Yves Perriard, Christian Köchli, Adrien Jean-Michel Thabuis, Sofia Lydia Ntella, Bhawnath Tiwari, Kenny Jeanmonod

Fluidic systems enable actuation in various applications, such as automotive, medical, and industrial robotics. Miniaturized valves constitute a fundamental controlling element of modern fluidic systems, intriguing the interest of many researchers. This le ...

2023