Publications associées à Development of the ITER Continuous External Rogowski: From conceptual design to final design

Publications associées (32)

Scenario optimization for the tokamak ramp-down phase in RAPTOR: A. Analysis and model validation on ASDEX Upgrade

Olivier Sauter, Federico Alberto Alfredo Felici, Anna Teplukhina, Simon Van Mulders, Cassandre Ekta Contré

We discuss how the combination of experimental observations and rapid modeling has enabled to improve understanding of the tokamak ramp-down phase in ASDEX Upgrade. A series of dedicated experiments has been performed, to disentangle the effect of individu ...

Iop Publishing Ltd2024

Towards practical reinforcement learning for tokamak magnetic control

Federico Alberto Alfredo Felici, Jonas Buchli, Cristian Galperti

Reinforcement learning (RL) has shown promising results for real-time control systems, including the domain of plasma magnetic control. However, there are still significant drawbacks compared to traditional feedback control approaches for magnetic confinem ...

Elsevier Science Sa2024

Re-design of EU DEMO with a low aspect ratio

Xabier Sarasola Martin

The design point that had been chosen for EU DEMO in 2016 is reviewed here and a modification is proposed with a lower aspect ratio. Previously the same aspect ratio, A, was chosen for EU DEMO as in major tokamak experiments including ITER (A = 3.1), and, ...

Elsevier2024

Gyrokinetic simulations of turbulence in magnetic fusion plasmas using a delta-f PIC scheme with evolving background

Moahan Murugappan

Using the GKEngine code which simulates an electrostatic plasma with adiabatic electron response under a sheared-slab geometry, an attempt at developing a hybrid approach between the delta-f and full-f schemes to describe plasma profiles exhibiting high fl ...

EPFL2024

The effect of plasma shaping on high density H-mode SOL profiles and fluctuations in TCV

Nicola Vianello, Benoît Labit, Holger Reimerdes, Christian Gabriel Theiler, Cedric Kar-Wai Tsui, Umar Sheikh, Guang-Yu Sun, Claudia Colandrea, Sophie Danielle Angelica Gorno, Luke Simons

The impact of plasma shaping on the properties of high density H-mode scrape-off layer (SOL) profiles and transport at the outer midplane has been investigated on Tokamaka configuration variable. The experimental dataset has been acquired by evolving the u ...

IOP Publishing Ltd2024

Global fluid simulations of plasma turbulence in stellarators

António João Caeiro Heitor Coelho

In order to cope with the decarbonization challenge faced by many countries, fusion is one of the few alternatives to fossil fuels for the production of electricity. Two devices invented in the middle of the previous century have emerged as the most promis ...

EPFL2024

Benign termination of runaway electron beams on ASDEX Upgrade and TCV

Stefano Coda, Basil Duval, Joan Decker, Umar Sheikh, Claudia Colandrea, Luke Simons, Jean Arthur Cazabonne

This paper discusses the development of a benign termination scenario for runaway electron (RE) beams on ASDEX Upgrade and TCV. A systematic study revealed that a low electron density (n e) companion plasma was required to achieve a large MHD instability, ...

Iop Publishing Ltd2024

Inter-discharge optimization for fast, reliable access to ASDEX Upgrade advanced tokamak scenario

Olivier Sauter, Federico Alberto Alfredo Felici, Simon Van Mulders, Cassandre Ekta Contré

Rapid inter-discharge simulation and optimization using the RAPTOR code have allowed the development of a reliable and reproducible early heating strategy for an advanced tokamak (AT) scenario on ASDEX Upgrade. Solving for electron heat and current diffusi ...

IOP Publishing Ltd2024

Impact of microwave beam scattering by density fluctuations on the electron-cyclotron power deposition profile in tokamaks

Stefano Coda, Joan Decker, Oleg Krutkin, Umesh Kumar, Jean Arthur Cazabonne

Electron-cyclotron waves are a tool commonly used in tokamaks, in particular to drive current. Their ability to drive current in a very localized manner renders them an optimal tool for MHD mode mitigation. However, such applications require high accuracy ...

IOP Publishing Ltd2024

Full-F turbulent simulation in a linear plasma device using a gyro-moment approach

Paolo Ricci, Baptiste Jimmy Frei

Simulations of plasma turbulence in a linear plasma device configuration are presented. These simulations are based on a simplified version of the gyrokinetic (GK) model proposed by Frei et al. [J. Plasma Phys. 86, 905860205 (2020)], where the full-F distr ...

Aip Publishing2024

Scenario optimization for the tokamak ramp-down phase in RAPTOR. Part B: safe termination of DEMO plasmas

Olivier Sauter, Federico Alberto Alfredo Felici, Emiliano Fable, Anna Teplukhina, Simon Van Mulders, Cassandre Ekta Contré

An optimized plasma current ramp-down strategy is critical for safe and fast termination of plasma discharges in a tokamak demonstration fusion reactor (DEMO), both in planned and emergency scenarios, avoiding plasma disruptions and excessive heat loads to ...

Iop Publishing Ltd2024

The magnet feeders for the European DEMO fusion reactor: Conceptual design and recent advances

Rainer Wesche, Roberto Guarino

The magnet feeders are part of the critical systems of a fusion reactor since they represent the interface between the in-cryostat components at 4.5 K and the room-temperature cryogenic plant and power supply. The European DEMO tokamak foresees 16 toroidal ...

2024

Studies on EU-DEMO 3D coils requirements and conceptual design for error field correction and plasma control

Pierluigi Bruzzone

This work presents the initial studies on the requirements for the design of 3D coils on EU-DEMO. The use of 3D coils in present machines includes two main purposes: the first one is the Error Field Correction (EFC). The EFC aims at minimizing the intrinsi ...

Elsevier Science Sa2023

Setting priorities in CNF particle size measurement: What is needed vs. what is feasible

Tiffany Abitbol

Measuring the size of cellulose nanomaterials can be challenging, especially in the case of branched and entangled cellulose nanofibrils (CNFs). The International Organization for Standardization, Technical Committee 6, Task Group 1-Cellulosic Nanomaterial ...

TECH ASSOC PULP PAPER IND INC2023

Equilibrium pressure limits in stellarators

Antoine Baillod

This thesis delves into the potential of magnetic fusion energy, and in particular focuses on the stellarator concept. Stellarators use external coils to produce 3-dimensional (3D) magnetic fields that confine a thermonuclear plasma in a topologically toro ...

EPFL2023

Full-discharge simulation and optimization with the RAPTOR code, from present tokamaks to ITER and DEMO

Simon Van Mulders

Tokamak devices aim to magnetically confine a hydrogen plasma at sufficiently high pressure to achieve net energy production from nuclear fusion of light isotopes. Predictive modeling and optimization is crucial for reliable operation of tokamak reactors, ...

EPFL2023

AC loss and electrical resistance of the RW3 diffusion-bonded joint

Vincenzo D'Auria

For the European DEMO fusion reactor, several options of the Toroidal Field (TF) coil design were proposed. The winding of the TF coil option 1 is based on React&Wind (RW), Nb3Sn, graded conductors in order to optimize the amount of superconductor accordin ...

2023

Electron temperature fluctuation measurements with Correlation Electron Cyclotron Emission in L-mode and I-mode plasmas at ASDEX Upgrade

Pedro Andres Molina Cabrera

The Correlation Electron Cyclotron Emission (CECE) diagnostic at ASDEX Upgrade (AUG) is used to investigate the features of outer core and pedestal (rho(pol) = 0.85-1.0) turbulence across confinement regime transitions. The I-mode confinement regime is a p ...

E D P SCIENCES2023

Excitation of toroidal Alfvén eigenmodes with counter-current NBI in the TCV tokamak

Laurie Porte, Alexander Karpushov, Matteo Vallar, Samuele Mazzi

In TCV, unstable modes excited by resonant interaction between the shear Alfvèn waves in con- tinuum gaps and energetic particles have been observed in scenarios with Neutral Beam Injection (NBI). TCV is a middle-size device (R 0 /a = 0.88/0.25) equipped w ...

IOP Publishing Ltd2023

The MAgnet Design Explorer algorithm (MADE) for LTS, Hybrid or HTS toroidal and poloidal systems of a tokamak with a view to DEMO

Xabier Sarasola Martin

The European Roadmap to Fusion Electricity (Federici et al., 2018) [1] details the path to complete within the next three decades the DEMOnstration power plant, DEMO, aiming to a net gain of Energy Q=40. The 2018 DEMO baseline considers a 2 GW tokamak devi ...

2023