Publication

Post-tensioned structural glass beams, experimental investigations

Publications associées (29)

Full-scale testing of European steel beams with reduced beam section under reversed cyclic loading

Steel beams with reduced beam section (RBS) are often used as part of prequalified connections in seismic regions. However, RBS connections are not as common in Europe. Reasons relate to easiness in fabrication, which requires on-site welding, and the seis ...

Springer Nature2022

Considerations on the partial safety factor format for reinforced concrete structures accounting for multiple failure modes

Aurelio Muttoni, Miguel Fernández Ruiz, Qianhui Yu

The increasing usage of nonlinear analyses for the design of reinforced concrete structures and the necessity of codes of practice to provide a consistent safety format for them is one of the challenges that new generations of codes of practice are facing. ...

ELSEVIER SCI LTD2022

Seismic stability of steel moment resisting frames with inelastic panel zones

Dimitrios Lignos, Andronikos Skiadopoulos

This paper summarizes preliminary findings of nonlinear simulations aiming to quantify the seismic demands of codecompliant steel MRFs with variable panel zone targeted shear distortions, 𝛾!. The probability of beam fractures is explicitly considered in th ...

Earthquake Engineering Research Institute2022

Re:Crete - A Footbridge made of Reused Concrete Blocks

Maléna Bastien Masse, Célia Marine Küpfer, Julie Rachel Devènes, Corentin Jean Dominique Fivet, Jan Friedrich Georg Brütting

Today, concrete is the most widely used construction material worldwide. Strong, versatile, durable, and vector of economic development, this exceptional material is also the principal cause of greenhouse-gas emissions, material depletion and waste generat ...

Asociación Española de Ingeniería Estructura2022

Fire performance evaluation of GFRP-balsa sandwich bridge decks

Niloufar Vahedi

Bridges are a critical component of national infrastructures and economies. A significant percentage of bridges built all around the world are made of reinforced concrete which according to building codes have a life span between 80-100 years. However, str ...

EPFL2022

Welded moment connections with highly dissipative panel zones for enhanced seismic performance of steel moment frames

Andronikos Skiadopoulos

Research conducted after the 1994 Northridge earthquake in the U.S. and the 1995 Kobe earthquake in Japan led to the development of today's pre-qualified beam-to-column connections for capacity-designed steel moment resisting frames (MRFs). Welded moment c ...

EPFL2022

Post-tensioning of glass beams: Analytical determination of the allowable pre-load

Alain Nussbaumer, Pieter Christian Louter, Jagoda Cupac

The effectiveness of post-tensioning in enhancing the fracture resistance of glass beams depends on the level of compressive pre-stress introduced at the glass edge surface that will in service be exposed to tensile stresses induced by bending. Maximum pre ...

2021

Flexural behaviour of post-tensioned glass beams: Experimental and analytical study of three beam typologies

Alain Nussbaumer, Pieter Christian Louter, Jagoda Cupac

The concept of post-tensioned glass beams builds on the concrete analogy of the reinforced glass beams. By additionally prestressing the reinforcement in a post-tensioned system, a compressive pre-stress is applied on the glass, enhancing the initial fract ...

2021

Hysteretic Behaviour of Shear Stud Connectors in Composite Steel Moment‐Resisting Frames

Dimitrios Lignos, Hammad El Jisr

In steel moment resisting frames (MRFs) with composite floor slabs, seismic loads are transmitted from the slab into the beam through shear studs. Shear strength degradation of the studs due to cyclic loading results into the loss of the load transfer mech ...

2021