Publications associées à High-Resolution Heat Transfer Measurements and Crossflow Regulation in Narrow Impingement Cooling Channels with Divergent Geometries

Publications associées (31)

Computational fluid dynamics simulations of the heat transfer properties of graphene-based nanolubricants and application to hydrodynamic lubrication

In this paper, we consider experimental data available for graphene-based nanolubricants to evaluate their convective heat transfer performance by means of computational fluid dynamics (CFD) simulations. Single-phase models with temperature-dependent prope ...

Aip Publishing2024

Decomposition method to evaluate district heating/cooling network potential at urban scale

Ana Catarina Gouveia Braz, François Maréchal, Luc Girardin, Bingqian Liu

In this work, a tool to design district heating networks (DHN) is presented and applied to the city of Lausanne as a case study. The evaluation of the buildings’ heat/cooling demand is performed using a Geographic Information System (GIS) database, built f ...

Associazione Italiana Di Ingegneria Chimica2024

Innovative thermophysical characterization of an ATF composite cladding: the case of silicon carbide

Andrea Cavaliere

Nuclear power is a powerful technology that plays an important role in the fight against climate change, and research is continuously engaged in studies that could further improve its safety. After the Fukushima accident, Accident Tolerant Fuels research h ...

EPFL2024

Plasmoid drift and first wall heat deposition during ITER H-mode dual-SPIs in JOREK simulations

Mengdi Kong

The heat flux mitigation during the thermal quench (TQ) by the shattered pellet injection (SPI) is one of the major elements of disruption mitigation strategy for ITER. It's efficiency greatly depends on the SPI and the target plasma parameters, and is ult ...

IOP Publishing Ltd2024

Design and assessment of an evaporating water-cooled methanation reactor for a SOE-based power-to-methane system

Philippe Aubin

The transition towards clean renewable energy sources, where wind and solar are prone to variation, requires adequate energy storage. Power-to-methane (PtM) systems can be part of the solution. Specifically, solid-oxide-electrolyser (SOE) based PtM systems ...

EPFL2024

Thermal conductivity of Li 3 PS 4 solid electrolytes with ab initio accuracy

Michele Ceriotti, Federico Grasselli, Davide Tisi, Lorenzo Gigli

The vast amount of computational studies on electrical conduction in solid-state electrolytes is not mirrored by comparable efforts addressing thermal conduction, which has been scarcely investigated despite its relevance to thermal management and (over)he ...

Amer Physical Soc2024

Unearthing the foundational role of anharmonicity in heat transport in glasses

Paolo Pegolo

The time-honored Allen -Feldman theory of heat transport in glasses is generally assumed to predict a finite value for the thermal conductivity, even if it neglects the anharmonic broadening of vibrational normal modes. We demonstrate that the harmonic app ...

Amer Physical Soc2024

Performance of energy piles foundation in hot-dominated climate: A case study in Dubai

Lyesse Laloui, Elena Ravera, Sofie Elaine ten Bosch

Energy piles represent an innovative technology that can help provide sustainable geothermal heating or cooling energy for thermal conditioning purposes. In hot-dominated climates, the interest is to inject heat in the ground and extract energy for space-c ...

Pergamon-Elsevier Science Ltd2024

Gyrokinetic turbulence modeling of a high performance scenario in JT-60SA

Stefano Coda, Stephan Brunner, Aylwin Iantchenko

Local gyrokinetic simulations are used to model turbulent transport for the first time in a representative high-performance plasma discharge projected for the new JT-60SA tokamak. The discharge features a double-null separatrix, 41 MW of combined neutral b ...

IOP Publishing Ltd2024

Turbulence and Heat exchange in the Near-Surface Boundary Layer over Patchy Snow

Michael Haugeneder

The atmospheric layer adjacent to the earth's surface is of crucial importance for weather models due to the exchange of energy between the surface and the atmosphere. This exchange is dependent on the various surface properties and influences the state of ...

EPFL2024

Identification and Mitigation of Degradation Mechanisms Induced by Heat and Light in NiOx-based Perovskite Solar Cells

Marion Solange Madeleine Dussouillez

Perovskite solar cells (PSCs) offer an attractive solution to increase the efficiency of PV panels via perovskite/silicon tandems thanks to their potential cost-effectiveness and high efficiency. In inverted PSC architecture (p-i-n), commonly used hole con ...

EPFL2024

Inter-discharge optimization for fast, reliable access to ASDEX Upgrade advanced tokamak scenario

Olivier Sauter, Federico Alberto Alfredo Felici, Simon Van Mulders, Cassandre Ekta Contré

Rapid inter-discharge simulation and optimization using the RAPTOR code have allowed the development of a reliable and reproducible early heating strategy for an advanced tokamak (AT) scenario on ASDEX Upgrade. Solving for electron heat and current diffusi ...

IOP Publishing Ltd2024

Heat transfer of uncoated and nanostructure coated commercially micro-enhanced refrigeration tubes under pool boiling conditions

John Richard Thome

The heat transfer performance of commercially produced micro-enhanced tubes with and without a nanocoating was investigated under pool boiling of saturated refrigerant. These multiscale enhancements were on the outside of 19 mm horizontal copper tubes heat ...

Pergamon-Elsevier Science Ltd2023

Multiscale enhancement of refrigerant falling film boiling by combining commercially enhanced tubes with nanostructures

John Richard Thome

Multiscale surface structures offer the opportunity to combine the heat transfer enhancement provided by microscale structures with the dryout benefits provided by some nanostructures, which is particularly attractive for falling film evaporators, who have ...

Pergamon-Elsevier Science Ltd2023

Beam radiation penetration in particle b e ds for heat transfer modeling of a centrifugal solar particle receiver

Evan Fair Johnson

This article describes a study of beam radiation striking particle beds of randomly packed, spherical par-ticles. The current study is focused on concentrating solar power receivers which use solid particles as a heat transfer medium, but results are appli ...

PERGAMON-ELSEVIER SCIENCE LTD2023

Improved Waste Heat Management and Energy Integration in an Aluminum Annealing Continuous Furnace Using a Machine Learning Approach

Mohammad Andayesh, François Maréchal, Daniel Alexander Florez Orrego

Annealing furnaces are critical for achieving the desired material properties in the production of high-quality aluminum products. In addition, energy efficiency has become more and more important in industrial processes due to increasing decarbonization r ...

2023

Experimental study of the hydrodynamic and thermal performances of ventilated wall structures

Dolaana Khovalyg, Mohammad Rahiminejad

The presence of a ventilated air gap behind the external cladding in a building envelope is known to have a tangible contribution to the overall performance of the wall assembly. In the present study, the hydrodynamic and thermal performances of ventilated ...

2023

Validation of human thermo-physiology models for personalized predictions of thermal responses

Dolaana Khovalyg, Mohamad Rida

Current thermal comfort models used in practice do not consider physiological and psychological differences of people. With this respect, human thermo-physiology models (HTPM) are useful tools to assess human thermal comfort at local and overall levels of ...

Curran Associates, Inc2023

Radiation-tolerant Multichannel Dew Point Temperature Monitoring System for High Energy Physics Applications

Amar Kapic

The next generation of high-energy physics (HEP) detectors will predominantly be silicon-based. As pixel sensor technology gains momentum and the number of channels surpasses one billion (for a volume of approximately 20 m3) to achieve the high resolution ...

EPFL2023

Advancing efficiency and reliability in thermal analysis of laser powder-bed fusion

Christian Leinenbach

In laser based powder-bed fusion of metals (PBF-LB/M), parts are fabricated by melting layers of powder using a high-intensity laser beam. During this process, the material is exposed to rapid cooling rates and intense thermal gradients, which are the unde ...

2023