Publications associées à Tunable MEMS capacitors using vertical carbon nanotube arrays grown on metal lines

Publications associées (31)

Optimizing Atomic Layer Deposition Processes with Nanowire-Assisted TEM Analysis

Atomic layer deposition (ALD) is one of the premier methods to synthesize ultra-thin materials on complex surfaces. The technique allows for precise control of the thickness down to single atomic layers, while at the same time providing uniform coverage ev ...

Wiley2024

Electrodeposition of polyaniline on reduced graphene oxide/cotton yarn with tunable electrochemical performance for flexible textile supercapacitors

Dou Du

Graphene/cotton fibers show significant promise in wearable energy storage due to their low cost, porous structure, and exceptional integration ability into wearable systems. However, the eco-unfriendly reductants and standalone electric double-layer capac ...

Elsevier Sci Ltd2024

Piezoelectric and elastic properties of Al0.60Sc0.40N thin films deposited on patterned metal electrodes

Federico Peretti, Luis Guillermo Villanueva Torrijo, Silvan Stettler, Marco Liffredo, Nan Xu

Sc-doped aluminum nitride (AlScN) allows for piezoelectric devices with large electromechanical coupling and the benefits increase with larger Sc doping in the film. However, with a larger Sc concentration, the process window narrows, and it is necessary t ...

2024

Influence of Ventilation on Formation and Growth of 1-20 nm Particles via Ozone-Human Chemistry

Dusan Licina, Shen Yang, Marouane Merizak, Meixia Zhang

Ozone reaction with human surfaces is an important source of ultrafine particles indoors. However, 1-20 nm particles generated from ozone-human chemistry, which mark the first step of particle formation and growth, remain understudied. Ventilation and indo ...

Amer Chemical Soc2024

Towards Scalable Electronics: Synthetic 2D Materials for Large-Area 2D Circuit Integration

Zhenyu Wang

In the past decades, a significant increase of the transistor density on a chip has led to exponential growth in computational power driven by Moore's law. To overcome the bottleneck of traditional von-Neumann architecture in computational efficiency, effo ...

EPFL2024

Scanning Tunneling Microscopy for Molecules: Effects of Electron Propagation into Vacuum

Klaus Kern, Abhishek Grewal

Using scanning tunneling microscopy (STM), we experimentally and theoretically investigate isolated platinum phthalocyanine (PtPc) molecules adsorbed on an atomically thin NaCl(100) film vapor deposited on Au(111). We obtain good agreement between theory a ...

Amer Chemical Soc2024

Synthesis of metal oxide-overcoated carbon materials by liquid phase ALD and their applications in catalysis

Farzaneh Talebkeikhah

Coating nano particles and other substrates for efficiency enhancement, protection and obtaining new atomic structures is a widespread research topic in catalysis and material synthesis. Thus far, different approaches of coating, ranging from simplest to s ...

EPFL2023

Plasma-Assisted Hybrid Vapour Deposition Technology for Thin Film Fabrication

Caroline Hain

Continuous development of thin film deposition technologies is essential for the fabrication of films that meet the specific requirements of their target applications and working conditions. Therefore, it is necessary to increase the number of accessible a ...

EPFL2023

Control of intermetallics in the interface in directed energy deposition of titanium on stainless steel 316L

Di Cui

Application of a single metal or alloy is often restricted by its properties from optimal combination of performance and cost. Therefore, there is a vast need of joining dissimilar metals for various applications in biomedical, aerospace, automobile and ma ...

EPFL2023

III-V Nitride Semiconductors Deposited At Low Temperature For Photovoltaic Applications

Jonathan Emanuel Thomet

This thesis reports on the study and use of low temperature processes for the deposition of indium gallium nitride (InGaN) thin films in order to alleviate some of the present drawbacks of its monolitic deposition on silicon for photovoltaic applications. ...

EPFL2023

Limits between surface and inner clogging of riverbed by fine sediment

Giovanni De Cesare, Romain Maxime Dubuis, Romain Dubuis

The deposition of fine sediment on top of the riverbed affects the reproduction of spawning fishes and some species of benthos. The clogging of the substrate resulting from this deposition is a well-known issue in rivers affected by anthropogenic activity ...

2023

Investigation of thermoelectric nanomaterials

David Thomas Osenberg

Thermoelectric conversion remains an active research field in light of its potential to enhance energy efficiency by waste heat recovery in a noise and wear-free manner. Nanostructuring is responsible for most of the recently reported improvements of the ...

EPFL2023

500 MHz high resolution proximity sensors with fully integrated digital counter

Giovanni Boero, Nergiz Sahin Solmaz, Reza Farsi

We report on the design and characterization of two inductive proximity sensors based on LC oscillators operating at 500 MHz. The distance from the target is obtained by measuring the oscillation frequency variation. Both sensors contain an off-chip LC res ...

ELSEVIER SCI LTD2023

Full Solution Process of a Near-Infrared Light-Emitting Electrochemical Cell Based on Novel Emissive Ruthenium Complexes of 1,10-Phenanthroline-Derived Ligands and a Eutectic Alloy as the Top Electrode

Mohammad Khaja Nazeeruddin

Near-infrared luminescent materials have recently received considerable attention for a large number of applications, including in solid-state lighting, as bioimaging agents, as photovoltaic cells, and in the telecommunication industry. By adding diverse e ...

AMER CHEMICAL SOC2023

Methylamine Post-Deposition Treatments of Vapor-Deposited Perovskite Thin Films

Austin George Kuba

While the development of methylammonium lead iodide (MAPbI(3)) perovskite for photovoltaics has grown rapidly, the growth of high-quality material from vapor processes continues to be difficult due to challenges including crystallinity control. Methylamine ...

IEEE2023

CVD of MoS2 single layer flakes using Na2MoO4 - impact of oxygen and temperature-time-profile

Christian Wäckerlin

Two-dimensional (2D) materials are of great interest in many fields due to their astonishing properties at an atomic level thickness. Many fundamentally different methods to synthesize 2D materials, such as exfoliation or chemical vapor deposition (CVD), h ...

Royal Soc Chemistry2023

Vapor Deposition of Perovskite Solar Cells

Quentin Jean-Marie Armand Guesnay

Thanks to the continuous improvement of crystalline silicon (c-Si) solar cells, largely dominating the market, photovoltaic electricity is nowadays the cheapest source of energy on the market. Yet, solar energy is far from being completely harvested, as t ...

EPFL2023

Atomic doping & coating for Electrocatalysis & Li-ion batteries

Albert Claude Jean-Pierre Daubry

Molybdenum atomic-doping on bio-waste derived nitrogen-doped conductive carbon electrocatalyst was synthesized and investigated for the dinitrogen reduction to ammonia in alkaline media. The assessment of the catalytic activity was found to be non-trivial ...

EPFL2022

Electrical Spectroscopy of Defect States in Synthetic 2D Materials

Yanfei Zhao

Two-dimensional (2D) materials such as graphene and transition metal dichalcogenide (TMDC) are considered as one of the most promising material platforms for future electronic devices, due to their ultra-thin thickness and fascinating electrical and optica ...

EPFL2022

Development of stencil lithography for stretchable interconnects

Yi-Chiang Sun

The growing needs for human healthcare have driven the development of wearable devices for monitoring the health status of an individual. Polymers represent a promising platform for such devices due to their ability to form an intimate contact between soft ...

EPFL2022