Publications associées à Nanoionics Phenomena and Devices with Oxide Thin Films

Publications associées (36)

Effect of imidazole-based additives on the voltage of dye sensitized solar cells with Cu(II/I) redox mediators

Acetonitrile solutions of Cu(tmby)22+ exhibit aging-dependent changes of UV–Vis spectra, which were attributed to partial reduction to Cu(tmby)2+. This effect is boosted by the addition of imidazole bases, i.e., N-methyl-benzimidazole (NMB) or 5‑chloro-1-e ...

2025

Dielectric Properties of Aqueous Electrolytes at the Nanoscale

Maximilian Becker, Philip Robin Loche

Despite the ubiquity of aqueous electrolytes, the effect of salt on water organization remains controversial. We introduce a nonlocal and nonlinear field theory for the nanoscale polarization of ions and water and derive the electrolyte dielectric response ...

American Physical Society (APS)2025

Electrochemical devices and computer science: water/thermal management of proton exchange membrane fuel cells and electrolyzers in different scales

Hossein Pourrahmani

The current restrictions on the registration of combustion engines in different countries and the harmful impacts of fossil fuels on the environment and human health have motivated decision-makers to use batteries and/or fuel cells as alternatives for comb ...

EPFL2023

Spinel Protective Coatings for Solid Oxide Cell (SOC) Interconnects (ICs)

Samaneh Daviran

Abstract The degradation of metal interconnects (ICs) in Solid Oxide Cells (SOCs) primarily results from chromium (Cr) oxide scale growth on stainless-steel substrates, causing ohmic loss and air-side electrode poisoning by Cr. This thesis addresses these ...

EPFL2024

Membrane electrode assembly simulation of anion exchange membrane water electrolysis

Zoé Mury, Jan Van Herle, Suhas Nuggehalli Sampathkumar, Khaled Lawand

Anion exchange membrane water electrolysis (AEMWE) offers a green hydrogen production method that eliminates the need for platinum group metals (PGM) as electrocatalysts. This study employs a COMSOL (R) 6.0 model to simulate a 1x1 cm(2) Ni fibre - Raney (R ...

Elsevier2024

Experimental and first-principles insights into an enhanced performance of Ru-doped copper phosphate electrocatalyst during oxygen evolution reaction

Mohammad Khaja Nazeeruddin

The OER involves a four-electron transfer and is a kinetically sluggish reaction that requires additional potential to drive. To enhance the electrochemical performance of the above-mentioned applications, highly efficient, corrosion-resistant, earth-abund ...

2024

Reversible photo-electrochemical device for solar hydrogen and power generation

Sophia Haussener, Saurabh Yuvraj Tembhurne, Alexandre Dominique M. Cattry, Matthieu Jonin, Mahendra Patel

A reversible photo-electrochemical device operating under concentrated irradiation could offer a stand-alone solution for producing solar fuel (in photo-driven electrolysis mode) and power (in fuel cell mode). This strategy would present the advantage of h ...

2024

Optimizing Atomic Layer Deposition Processes with Nanowire-Assisted TEM Analysis

Ivo Utke, Johann Michler, Xavier Maeder

Atomic layer deposition (ALD) is one of the premier methods to synthesize ultra-thin materials on complex surfaces. The technique allows for precise control of the thickness down to single atomic layers, while at the same time providing uniform coverage ev ...

Wiley2024

Piezoelectric and elastic properties of Al0.60Sc0.40N thin films deposited on patterned metal electrodes

Federico Peretti, Luis Guillermo Villanueva Torrijo, Silvan Stettler, Marco Liffredo, Nan Xu

Sc-doped aluminum nitride (AlScN) allows for piezoelectric devices with large electromechanical coupling and the benefits increase with larger Sc doping in the film. However, with a larger Sc concentration, the process window narrows, and it is necessary t ...

2024

Towards Scalable Electronics: Synthetic 2D Materials for Large-Area 2D Circuit Integration

Zhenyu Wang

In the past decades, a significant increase of the transistor density on a chip has led to exponential growth in computational power driven by Moore's law. To overcome the bottleneck of traditional von-Neumann architecture in computational efficiency, effo ...

EPFL2024

Plasmoid drift and first wall heat deposition during ITER H-mode dual-SPIs in JOREK simulations

Mengdi Kong

The heat flux mitigation during the thermal quench (TQ) by the shattered pellet injection (SPI) is one of the major elements of disruption mitigation strategy for ITER. It's efficiency greatly depends on the SPI and the target plasma parameters, and is ult ...

IOP Publishing Ltd2024

Green hydrogen production using Shewanella oneidensis MR-1 bioanode and cuprous oxide-based photocathode

Michele Morgante

In recent years, many efforts have been made to find alternative renewable energy sources that can ideally replace the use of fossil fuels in all aspects. One of the new emerging energy technologies is the bioelectrochemical system, of which two types are ...

EPFL2024

Quantifying mass transport limitations in a microfluidic CO2 electrolyzer with a gas diffusion cathode

Sophia Haussener, Venu Gopal Agarwal

A gas diffusion electrode (GDE) based CO2 electrolyzer shows enhanced CO2 transport to the catalyst surface, significantly increasing current density compared to traditional planar immersed electrodes. A two-dimensional model for the cathode side of a micr ...

2024

Dynamic Behavior of Spatially Confined Sn Clusters and Its Application in Highly Efficient Sodium Storage with High Initial Coulombic Efficiency

Lei Zhang, Kumar Varoon Agrawal, Kangning Zhao

Advanced battery electrodes require a cautious design of microscale particles with built-in nanoscale features to exploit the advantages of both micro- and nano-particles relative to their performance attributes. Herein, the dynamic behavior of nanosized S ...

Wiley-V C H Verlag Gmbh2024

MEMS-based Tunable Metasurface for Reflective Display Applications

Dorian Giraud Herle

In an era where portable electronic devices are indispensable for a wide range of activities, the need for displays that provide both long-lasting battery life and excellent visibility in different lighting conditions is increasingly important. Emissive di ...

EPFL2024

Contrasting Views of the Electric Double Layer in Electrochemical CO2 Reduction: Continuum Models vs Molecular Dynamics

Sophia Haussener, Evan Fair Johnson

In the field of electrochemical CO2 reduction, both continuum models and molecular dynamics (MD) models have been used to understand the electric double layer (EDL). MD often focuses on the region within a few nm of the electrode, while continuum models ca ...

Amer Chemical Soc2024

Electrochemical sensors modified with iron oxide nanoparticles/ nanocomposites for voltammetric detection of Pb (II) in water: A review

Sandro Carrara

Permissible limits of Pb 2+ in drinking water are being reduced from 10 mu gL -1 to 5 mu gL -1 , which calls for rapid, and highly reliable detection techniques. Electrochemical sensors have garnered attention in detection of heavy metal ions in environmen ...

Cell Press2024

Influence of Ventilation on Formation and Growth of 1-20 nm Particles via Ozone-Human Chemistry

Dusan Licina, Shen Yang, Marouane Merizak, Meixia Zhang

Ozone reaction with human surfaces is an important source of ultrafine particles indoors. However, 1-20 nm particles generated from ozone-human chemistry, which mark the first step of particle formation and growth, remain understudied. Ventilation and indo ...

Amer Chemical Soc2024

Scanning Tunneling Microscopy for Molecules: Effects of Electron Propagation into Vacuum

Klaus Kern, Abhishek Grewal

Using scanning tunneling microscopy (STM), we experimentally and theoretically investigate isolated platinum phthalocyanine (PtPc) molecules adsorbed on an atomically thin NaCl(100) film vapor deposited on Au(111). We obtain good agreement between theory a ...

Amer Chemical Soc2024

Font Side Solutions for c-Si Solar Cells with High-Temperature Passivating Contacts

Ezgi Genç

In this work, we studied the potential of using thin films deposited by plasma-enhanced chemical vapor deposition (PECVD) for two main purposes: introducing an n-type passivating contact at the front of a TOPCon solar cell, or simplifying the fabrication o ...

EPFL2024