Publication

Improvement of elevated temperature mechanical properties of Cu–Ni–Sn–Pb alloys

Publications associées (28)

Wideband integrated bioaerosol sensor (WIBS) excited, fluorescent, and hyper-fluorescent particle number concentrations and normalized size distributions (dN/dlogDp) measured in the Swiss container during MOSAiC 2019/2020

Julia Schmale, Ivo Fabio Beck, Margarida Teles Nogueira Rolo, Alireza Moallemi

These datasets contain the total particle number concentrations and normalized size distributions (dN/dlogDp) of excited, fluorescent, and hyper-fluorescent particles of sizes 0.5 to 20 μm (optical diameter). The normalized size distribution datasets are s ...

Zenodo2023

A Low-Temperature Annealing Method for Alloy Nanostructures and Metasurfaces: Unlocking a Novel Degree of Freedom

Christian Santschi, Olivier Martin, Debdatta Ray, Jeonghyeon Kim, Hsiang-Chu Wang

The material and exact shape of a nanostructure determine its optical response, which is especially strong for plasmonic metals. Unfortunately, only a few plasmonic metals are available, which limits the spectral range where these strong optical effects ca ...

Wiley-V C H Verlag Gmbh2022

Micro-addition of Fe in highly alloyed Cu-Ti alloys to improve both formability and strength

Cyril Cayron, Roland Logé, Baptiste Thomas Jean Rouxel

Cu-Be alloys provide excellent electrical and mechanical properties, but present serious health hazards during manufacturing. Among alternative alloys, the Cu-Ti system has the highest yield strength; however, Ti cannot be easily solutionized at concentrat ...

ELSEVIER SCI LTD2022

Machine learning for metallurgy IV: A neural network potential for Al-Cu-Mg and Al-Cu-Mg-Zn

William Curtin, Daniel John Gilles Marchand

Most metallurgical properties, e.g., dislocation propagation, precipitate formation, can only be fully understood atomistically but most phenomena and quantities of interest cannot be measured experimentally. Accurate simulation methods are essential but f ...

2022

Liquid metal infiltration of silicon based alloys into porous carbonaceous materials. Part II: Experimental verification of modelling approaches by infiltration of Si-Zr alloy into idealized microchannels

Ludger Weber, Giovanni Bianchi, Alberto Ortona, Manoj Kondibhau Naikade, Caroline Hain

In this work, the mechanisms leading to the pore closure in reactive melt infiltration (RMI) of carbon by pure silicon and a near eutectic Si-8 at-pct Zr alloy at 1500 and 1700 degrees C under vacuum were studied. Various geometrical configurations of micr ...

ELSEVIER SCI LTD2022

Neural Network Potentials for Age Hardening Aluminum Alloys

Daniel John Gilles Marchand

High-strength metal alloys achieve their performance via careful control of precipitates and solutes. The nucleation, growth, and kinetics of precipitation, and the resulting mechanical properties, are inherently atomic scale phenomena, particularly during ...

EPFL2022

The effect of high relative humidity on a network of water-sensitive particles (couscous) as revealed by in situ X-ray tomography

Gioacchino Viggiani, Edward Carlo Giorgio Andò

Water significantly influences the mechanical behaviour of all granular materials but none as much as hygroscopic amorphous particles. With sufficiently high water content, particles can swell, agglomerate and their mechanical properties can be reduced, ha ...

ROYAL SOC CHEMISTRY2022

Microscopic field theory for structure formation in systems of self-propelled particles with generic torques

Ignacio Pagonabarraga Mora, Elena Sesé Sansa

We derive a dynamical field theory for self-propelled particles subjected to generic torques and forces by explicitly coarse-graining their microscopic dynamics, described by a many-body Fokker-Planck equation. The model includes both intrinsic torques ind ...

AIP Publishing2022