Publication

Hydraulic contacts controlling water flow across porous grains

Publications associées (28)

From thin plates to Ahmed bodies: linear and weakly nonlinear stability of rectangular prisms

Edouard Boujo, Giuseppe Antonio Zampogna

We study the stability of laminar wakes past three-dimensional rectangular prisms. The width-to-height ratio is set to W/H = 1.2, while the length-to-height ratio 1/6 < L/H < 3 covers a wide range of geometries from thin plates to elongated Ahmed bodies. F ...

Cambridge University Press2023

Hydro-Mechanical Characterization of a Shale by Unusually High-Pressure Oedometric Tests

Alessio Ferrari, Eleonora Crisci

The note presents selected results of an experimental campaign conducted with the aim to investigate the hydro-mechanical behaviour of a shale recovered at a depth of about 900 m below the ground. High-pressure oedometric tests were performed to investigat ...

Wei Wu, Universität für Bodenkultur2023

Rock-Flow Cell Parameters Evaluation Using Ultrasound Doppler Velocimetry

Giovanni De Cesare, Javier Neves da Silva, Andre Luis Stakowian

This work presents a study of two-phase flow generated inside a rock-flow cell setup. It is characterized by a pipe section filled with fluid (oil in our studies) that is put into oscillation around its mass centre by an electric motor. This type of appara ...

2023

Seasonal variation in the xylem sap composition of six Australian trees and shrubs

Alice Jacqueline Frédérique Gauthey

In recent years, xylem sap composition has been shown to affect xylem hydraulics. However, information on how much xylem sap composition can vary across seasons and specifically under drought stress is still limited. We measured xylem sap chemical composit ...

Oxford Univ Press2023

Modeling and analysis of miniaturized magnetorheological valve for fluidic actuation

Sofia Lydia Ntella

Fluidic actuation enables movement in a wide range of mechanical systems, from simple laboratory devices to more complex industrial machinery. Fluids are used to generate motion of mechanical pieces. The term "fluids" encompasses two types of technologies: ...

EPFL2023

Effects of velocity-dependent apparent toughness on the pre- and post-shut-in growth of a hydraulic fracture

Dong Liu, Guanyi Lu

We investigate the growth of a plane-strain/radial hydraulic fracture in an infinite impermeable medium driven by a constant injection rate assuming that the apparent toughness scales with the decreasing fracture growth rate in a power-law relation. The vi ...

ELSEVIER SCI LTD2022

Fiber Buckling in Confined Viscous Flows: An Absolute Instability Described by the Linear Ginzburg-Landau Equation

François Gallaire, Jean Cappello

We explore the dynamics of a flexible fiber transported by a viscous flow in a Hele-Shaw cell of height comparable to the fiber height. We show that long fibers aligned with the flow experience a buckling instability. Competition between viscous and elasti ...

AMER PHYSICAL SOC2022

Fourier Collocation and Reduced Basis Methods for Fast Modeling of Compressible Flows

Jan Sickmann Hesthaven, Deep Ray

A projection-based reduced order model (ROM) based on the Fourier collocation method is proposed for compressible flows. The incorporation of localized artificial viscosity model and filtering is pursued to enhance the robustness and accuracy of the ROM fo ...

GLOBAL SCIENCE PRESS2022