Publication

Transposition of the mechanical behavior from model to prototype of Francis turbines

Publications associées (28)

Investigation of the Time Resolution Set Up Used to Compute the Full Load Vortex Rope in a Francis Turbine

François Avellan, Andres Müller, Cécile Münch-Alligné, Arthur Tristan Favrel

The flow in a Francis turbine at full load is characterised by the development of an axial vortex rope in the draft tube. The vortex rope often promotes cavitation if the turbine is operated at a sufficiently low Thoma number. Furthermore, the vortex rope ...

2021

Large-Eddy Simulation of Wind Turbine Flows: A New Evaluation of Actuator Disk Models

Fernando Porté Agel, Tristan Revaz

Large-eddy simulation (LES) with actuator models has become the state-of-the-art numerical tool to study the complex interaction between the atmospheric boundary layer (ABL) and wind turbines. In this paper, a new evaluation of actuator disk models (ADMs) ...

2021

Dynamic behaviour of a Francis turbine during voltage regulation in the electrical power system

François Avellan, Elena Vagnoni

Hydroelectric units can be operated in synchronous condenser mode to provide reactive power to the electrical power system (EPS) for voltage regulation. In this operating mode, the hydraulic turbine consumes active power and in case of hydroelectric units ...

2020

Swirl number based transposition of flow-induced mechanical stresses from reduced scale to full-size Francis turbine runners

François Avellan, Christian Landry, Joao Gomes Pereira Junior, Arthur Tristan Favrel, Keita Yamamoto

At part load conditions, Francis turbines are subject to the emergence of a hydrodynamic instability in their draft tube, referred to as precessing vortex rope. It induces pressure pulsations in the water passages at the precession frequency of the vortex, ...

2020

Computational parametric analysis of the design of cross-flow turbines under constraints

François Avellan, Sebastián Camilo Leguizamón Sarmiento

The cross-flow turbine is an attractive technology for small-scale hydropower generation thanks to its low capital cost and relatively high efficiency even under partial discharge operating conditions. It has been proposed that this kind of turbine can be ...

Pergamon-Elsevier Science Ltd2020

GPU-accelerated numerical analysis of jet interference in a six-jet Pelton turbine using Finite Volume Particle Method

François Avellan, Christian Vessaz, Ebrahim Jahanbakhsh, Sebastián Camilo Leguizamón Sarmiento, Siamak Alimirzazadeh, Audrey Paulette Solange Maertens, Takashi Kumashiro

The Pelton turbine is an impulse turbine typically installed for high head hydroelectric power plants. For a site with a rated head H and discharge Q, a higher specific speed turbine results in a more compact generating unit with reduced manufacturing cost ...

Pergamon-Elsevier Science Ltd2020

Open-Source Implementation and Validation of a 3D Inverse Design Method for Francis Turbine Runners

François Avellan, Sebastián Camilo Leguizamón Sarmiento

The hydraulic design of Francis turbines and pump-turbines is an expensive project-specific engineering effort that typically involves a direct iterative exploration of the design space. An inverse design method for turbomachinery has been previously intro ...

2020

Multi-objective optimization and exergoeconomic analysis of a continuous solar-driven system with PCM for power, cooling and freshwater production

Hossein Pourrahmani

In this article, three different modes of a novel integrated system would be evaluated by the application of high temperature Thermal Energy Storage (TES) to produce electricity, cooling, and freshwater. Freshwater is produced using the reverse osmosis (RO ...

Elsevier2020