Publications associées à Progressive activation of degradation processes in solid oxide fuel cell stacks: Part II: Spatial distribution of the degradation

Publications associées (30)

Techno-economic evaluation of biogas-fed SOFC systems with novel biogas purification and carbon capture technologies

Gianluca Monticone, Jan Van Herle, Hangyu Yu

Small-scale biogas-fed solid oxide fuel cell (SOFC) systems, integrated with carbon capture storage (CCS) technologies, offer a sustainable solution for European farms’ heat and power demands with minimal carbon emissions. This study investigates different ...

Pergamon-Elsevier Science Ltd2024

Electrochemical devices and computer science: water/thermal management of proton exchange membrane fuel cells and electrolyzers in different scales

Hossein Pourrahmani

The current restrictions on the registration of combustion engines in different countries and the harmful impacts of fossil fuels on the environment and human health have motivated decision-makers to use batteries and/or fuel cells as alternatives for comb ...

EPFL2023

Reversible photo-electrochemical device for solar hydrogen and power generation

Sophia Haussener, Saurabh Yuvraj Tembhurne, Alexandre Dominique M. Cattry, Matthieu Jonin, Mahendra Patel

A reversible photo-electrochemical device operating under concentrated irradiation could offer a stand-alone solution for producing solar fuel (in photo-driven electrolysis mode) and power (in fuel cell mode). This strategy would present the advantage of h ...

2024

Design and assessment of an evaporating water-cooled methanation reactor for a SOE-based power-to-methane system

Philippe Aubin

The transition towards clean renewable energy sources, where wind and solar are prone to variation, requires adequate energy storage. Power-to-methane (PtM) systems can be part of the solution. Specifically, solid-oxide-electrolyser (SOE) based PtM systems ...

EPFL2024

Membrane electrode assembly simulation of anion exchange membrane water electrolysis

Zoé Mury, Jan Van Herle, Suhas Nuggehalli Sampathkumar, Khaled Lawand

Anion exchange membrane water electrolysis (AEMWE) offers a green hydrogen production method that eliminates the need for platinum group metals (PGM) as electrocatalysts. This study employs a COMSOL (R) 6.0 model to simulate a 1x1 cm(2) Ni fibre - Raney (R ...

Elsevier2024

Spinel Protective Coatings for Solid Oxide Cell (SOC) Interconnects (ICs)

Samaneh Daviran

Abstract The degradation of metal interconnects (ICs) in Solid Oxide Cells (SOCs) primarily results from chromium (Cr) oxide scale growth on stainless-steel substrates, causing ohmic loss and air-side electrode poisoning by Cr. This thesis addresses these ...

EPFL2024

Stability and degradation of (oxy)nitride photocatalysts for solar water splitting

Sophia Haussener, Franky Esteban Bedoya Lora

Advancing towards alternative technologies for the sustainable production of hydrogen is a necessity for the successful integration of this potentially green fuel in the future. Photocatalytic and photoelectrochemical water splitting are promising concepts ...

2024

Perspective Alkaline electrolyzers: Powering industries and overcoming fundamental challenges

Hubert Girault

For the sustainable development of the renewable hydrogen sector, alkaline electrolysis appears to be a technology of choice. Nevertheless, despite its long history that showed its reliability in the industrial field and despite the traditional belief from ...

Cell Press2024

Quantifying mass transport limitations in a microfluidic CO2 electrolyzer with a gas diffusion cathode

Sophia Haussener, Venu Gopal Agarwal

A gas diffusion electrode (GDE) based CO2 electrolyzer shows enhanced CO2 transport to the catalyst surface, significantly increasing current density compared to traditional planar immersed electrodes. A two-dimensional model for the cathode side of a micr ...

2024

Empowering turbocompressor design with AI: a unified approach to robustness and all-at-once optimization

Soheyl Massoudi

Achieving robustness in engineering design is crucial for systems such as gas-bearing supported turbocompressors used in heat pumps and fuel cells, where precision affects efficiency and stability. Traditional design methods often optimize for nominal cond ...

EPFL2024

Renewable energy integration and waste heat valorization in aluminum remelting for co-producing kerosene and methanol

François Maréchal, Daniel Alexander Florez Orrego, Meire Ellen Gorete Ribeiro Domingos

The aluminium sector relies on natural gas for the conversion of recycled scrap into new feedstock, which results in substantial atmospheric emissions. Hydric resources are also impacted, as they serve as heat sinks for the waste heat generated during the ...

Associazione Italiana Di Ingegneria Chimica2024

Phase-stable indium sulfide achieves an energy conversion efficiency of 14.3% for solar-assisted carbon dioxide reduction to formate

Michael Graetzel, Jingshan Luo, Jing Gao, Jun Li

Tremendous efforts have been made in developing highly selective catalysts for electrochemical CO 2 conversion to formate. However, the rapid deactivation resulting from structural reconstruction and phase transition poses considerable challenges to the sy ...

Cell Press2024

The thermodynamic and life-cycle assessments of a novel charging station for electric vehicles in dynamic and steady-state conditions

Jan Van Herle, Hossein Pourrahmani

The current study performs the thermodynamic and life-cycle assessments (LCA) of a novel charging station in two system designs. The goal is to design an efficient charging station for electric vehicles with high efficiencies and low environmental impacts ...

Nature Portfolio2023

Hybridisation Scenarios of Solid Oxide Fuel Cells, Batteries, and Internal Combustion Engines for Waterborne Transportation

François Maréchal, Daniel Alexander Florez Orrego, Eduardo Antonio Pina

The shipping industry was responsible for about 3% of global greenhouse gas (GHG) emissions in 2018. In this context, the International Maritime Organisation (IMO) has established stringent targets to reduce GHG emissions by at least 50% by 2050 compared t ...

Universidad de Las Palmas de Gran Canaria2023

Readiness evaluation of SOFC-MGT hybrid systems with carbon capture for distributed combined heat and power

Jan Van Herle, Jürg Alexander Schiffmann, Michele Gaffuri, Victoria Xu Hong He

The aggravation of climate change calls for the timely development and implementation of highly efficient, renewable, zero- or negative-emission energy solutions with high technological readiness and feasibility levels. Solid oxide fuel cells (SOFC) consti ...

Elsevier2023

Fast online diagnosis for solid oxide fuel cells: Optimisation of total harmonic distortion tool for real-system application and reactants starvation identification

Jan Van Herle, Hamza Moussaoui

This study investigates the potential application of total harmonic distortion (THD), as a fast online monitoring tool, to identify the early signs of failure modes in solid oxide fuel cells (SOFC). Indeed, the timely detection and identification of faults ...

ELSEVIER2023

Robust Piperidinium-Enriched Polystyrene Ionomers for Anion Exchange Membrane Fuel Cells and Water Electrolyzers

Xile Hu, Fang Song, Nanjun Chen

Durable and efficient anion exchange polyelectrolytes (AEPs) are crucial for the long-term operation of cost-effective anion exchange membrane fuel cells (AEMFCs) and water electrolyzers (AEMWEs). Here, we present a new class of ?-amine-piperidinium-functi ...

AMER CHEMICAL SOC2023

Decoupling the Contributions of Different Instability Mechanisms to the PEMFC Performance Decay of Non-noble Metal O2-Reduction Catalysts

Vasiliki Tileli, Robin Pierre Alain Girod

Non-noble metal catalysts (NNMCs) hold the potential to replace the expensive Pt-based materials currently used to speed up the oxygen reduction reaction (ORR) in proton exchange membrane fuel cell (PEMFC) cathodes, but they feature poor durability that in ...

AMER CHEMICAL SOC2023

Insights into Electrocatalyst Transformations Studied in Real Time with Electrochemical Liquid-Phase Transmission Electron Microscopy

Vasiliki Tileli, Tzu-Hsien Shen, Robin Pierre Alain Girod

The value of operando and in situ characterization methodologies for understanding electrochemical systems under operation can be inferred from the upsurge of studies that have reported mechanistic insights into electrocatalytic processes based on such mea ...

American Chemical Society2023

The design and development of anion exchange membranes for hydrogen fuel cells

Xingyu Wu

Hydrogen fuel cells are an essential component of hydrogen economy, which have been advocated as a major path towards the decarbonization of the energy sector. Within the two main types of low-temperature hydrogen fuel cells, anion-exchange membrane fuel c ...

EPFL2023