Publications associées à Atomic-Layer-Deposited Transparent Electrodes for Silicon Heterojunction Solar Cells

Publications associées (33)

Structure determination by NMR Crystallography, from microcrystalline powders to amorphous molecular solids

Structure elucidation of amorphous materials and microcrystalline solids is one of the key challenges in chemistry today. While techniques such as single crystal diffraction and cryo-electron microscopy are generally not able to characterize such materials ...

AIP Publishing2025

A commissioning-oriented approach to data-driven modeling of buildings with heat pumps for predictive demand response

Colin Neil Jones, Manuel Pascal Koch

As the share of electricity generation from non-dispatchable sources like wind and photovoltaics grows, so does the need for demand response to stabilize the grid. Since the electricity consumption of heat pumps in buildings is both substantial and flexibl ...

Elsevier BV2025

The influence of Cr concentration on the phase composition and properties of a unidirectionally crystallized ternary system Cr-Fe-Si before and after annealing

Philippe Buffat

This paper describes the phase composition, morphological, chemical, and crystallographic prop- erties of silicide phases in Cr–Fe–Si alloy ingots obtained through directional solidification, both before and after annealing. The samples had a general formu ...

Pleiades Publishing Ltd2025

Font Side Solutions for c-Si Solar Cells with High-Temperature Passivating Contacts

Ezgi Genç

In this work, we studied the potential of using thin films deposited by plasma-enhanced chemical vapor deposition (PECVD) for two main purposes: introducing an n-type passivating contact at the front of a TOPCon solar cell, or simplifying the fabrication o ...

EPFL2024

Microstructural and electrical characterization of high temperature passivating contacts for silicon solar cells

Sofia Libraro

Recombination at metal/semiconductor interfaces represents the main limitation in mainstream c-Si solar cells, primarily based on the passivated emitter and rear cell (PERC) concept. Full-area passivating contacts based on SiOx/poly-Si stacks are a candida ...

EPFL2024

Shortwave Infrared-Sensitive, Narrowband Organic Upconversion Devices with a Gain

Wei-Hsu Hu

Sensing and imaging of light in the shortwave infrared (SWIR) range is increasingly used in various fields, including bio-imaging, remote sensing, and semiconductor process control. SWIR-sensitive organic photodetectors (OPDs) are promising because organic ...

EPFL2024

Stress tolerance of lightweight glass-free PV modules for vehicle integration

Kléber Nicolet-dit-Félix, Christophe Ballif, Matthieu Despeisse, Aïcha Hessler-Wyser, Jacques Levrat, Antonin Faes, Gianluca Cattaneo, Umang Bhupatrai Desai, Fahradin Mujovi

Electric vehicles (EVs) currently dominate the sales in the automotive market. A big leap in this market can be made by developing a photovoltaic product that can be integrated to an EV, as it can boost the driving range of the EV while reducing the chargi ...

Edp Sciences S A2024

A comprehensive physical model for the sensitivity of silicon heterojunction photovoltaic modules to water ingress

Christophe Ballif, Alessandro Francesco Aldo Virtuani, Luca Gnocchi, Olatz Arriaga Arruti

Silicon heterojunction (SHJ)-solar modules-when encapsulated with ethylene vinyl acetate (EVA)-are known to be extremely sensitive to water ingress. The reason for this is, however, not clear. Here, we explain the root causes of this degradation mechanism ...

Cell Press2024

Durable Perovskite Solar Cells with 24.5% Average Efficiency: The Role of Rigid Conjugated Core in Molecular Semiconductors

Michael Graetzel, Shaik Mohammed Zakeeruddin, Peng Wang, Felix Thomas Eickemeyer

Efficient and robust n-i-p perovskite solar cells necessitate superior organic hole-transport materials with both mechanical and electronic prowess. Deciphering the structure-property relationship of these materials is crucial for practical perovskite sola ...

Wiley-V C H Verlag Gmbh2024

Alleviating nanostructural phase impurities enhances the optoelectronic properties, device performance and stability of cesium-formamidinium metal-halide perovskites

Anaël Morgane Jaffrès, Christophe Ballif, Quentin Thomas Jeangros, Aïcha Hessler-Wyser, Christian Michael Wolff, Mostafa Rabie Shlaly Bahr Othman, Daniel Anthony Jacobs, Austin George Kuba

The technique of alloying FA+ with Cs+ is often used to promote structural stabilization of the desirable alpha-FAPbI3 phase in halide perovskite devices. However, the precise mechanisms by which these alloying approaches improve the optoelectronic quality ...

Royal Soc Chemistry2024

Drone‐Based Solar Cell Inspection With Autonomous Deep Learning

Mirko Kovac

Regular inspection and maintenance are crucial for ensuring the optimal performance of solar panels. However, conventional manual methods can be laborious, time consuming, and expensive, especially for large and inaccessible installations. Aerial inspectio ...

Wiley2024

Photo-doping of spiro-OMeTAD for highly stable and efficient perovskite solar cells

Michael Graetzel, Jacques-Edouard Moser, Etienne Christophe Socie, George Cameron Fish, Aaron Tomas Terpstra, Kai Zhu

A widely used component of high-efficiency perovskite solar cells (PSCs) is the molecular hole-transport material (HTM) spiro-OMeTAD. This organic solid needs to be p-doped to acquire sufficient hole conductivity. However, the conventional doping method us ...

2024

Supramolecular interactions using β-cyclodextrin in controlling perovskite solar cell performance

Parnian Ferdowsi, Kevin Sivula, Jun Ho Yum, Jiyoun Seo

In the context of perovskite solar cells (PSCs), enhancing device performance often involves adding a small excess of lead iodide (PbI2) to the precursor solution. However, the presence of unreacted PbI2 can lead to accelerated degradation compromising lon ...

Royal Society of Chemistry2024

Optimizing Atomic Layer Deposition Processes with Nanowire-Assisted TEM Analysis

Ivo Utke, Johann Michler, Xavier Maeder

Atomic layer deposition (ALD) is one of the premier methods to synthesize ultra-thin materials on complex surfaces. The technique allows for precise control of the thickness down to single atomic layers, while at the same time providing uniform coverage ev ...

Wiley2024

Encapsulation strategies for mechanical impact and damp heat reliability improvement of lightweight photovoltaic modules towards vehicle-integrated applications

Fabiana Lisco

Lightweight modules are essential for next-generation vehicle-integrated photovoltaic (VIPV) applications, such as solar-powered cars, allowing integration of solar cells beyond the roof, and on the hood, boot and body panels, and thereby extending the dri ...

Elsevier2024

Piezoelectric and elastic properties of Al0.60Sc0.40N thin films deposited on patterned metal electrodes

Federico Peretti, Luis Guillermo Villanueva Torrijo, Silvan Stettler, Marco Liffredo, Nan Xu

Sc-doped aluminum nitride (AlScN) allows for piezoelectric devices with large electromechanical coupling and the benefits increase with larger Sc doping in the film. However, with a larger Sc concentration, the process window narrows, and it is necessary t ...

2024

Computational Studies on the Stability of Organic-Inorganic Hybrid Halide Lead Perovskites

Mathias Dankl

Perovskite-based solar cells are currently the most rapidly advancing photovoltaic technology but concerns about their long-term stability are still impeding full-scale commercialization. This thesis provides computational insights into some of the stabili ...

EPFL2024

Axial-Equatorial Halide Ordering in Layered Hybrid Perovskites from Isotropic-Anisotropic 207Pb NMR

David Lyndon Emsley, Aditya Mishra, Michael Allan Hope, Manuel Cordova, Ümmügülsüm Günes

Bandgap-tuneable mixed-halide 3D perovskites are of interest for multi-junction solar cells, but suffer from photoinduced spatial halide segregation. Mixed-halide 2D perovskites are more resistant to halide segregation and are promising coatings for 3D per ...

Wiley-VCH Verlag GmbH2024

Enhanced performance of perovskite solar cell via up-conversion YLiF4:Yb, Er nanoparticles

Mounir Driss Mensi, Masaud Hassan S Almalki, Anwar Qasem M Alanazi

We report a simple and effective method for producing lanthanide ion-doped lithium-fluoride-based nanocrystals (YLiF4). We utilized those nanoparticles for up-conversion in fabricated perovskite solar cells. The obtained results shows that the up-conversio ...

Elsevier2024

Elimination of buried interfacial voids for efficient perovskite solar cells

Bin Ding, Xianfu Zhang

Establishing optimal interfacial contact is crucial for enhancing the efficiency of perovskite solar cells (PSCs). However, formation of voids at buried interface of perovskite films often hinders this critical objective. Our investigation reveals that the ...

Elsevier2024