Publication

Alite-ye'elimite clinker: Hydration kinetics, products and microstructure

Publications associées (31)

Hydration and durability of fast hardening binders incorporating supplementary cementitious materials

The use of supplementary cementitious materials (SCMs) is widely considered the most promis-ing approach to reduce CO2 emissions relative to cement production. SCMs are not commonly present in binders used for special applications. On the other hand, due t ...

EPFL2022

Quantifying the Solution Structure of Metal Nanoclusters Using Small-Angle Neutron Scattering

Francesco Stellacci, Stefan Guldin, Zhi Luo, Ye Yang, Huayan Yang

Metal nanoclusters are a unique class of synthetic material, as their crystal structures can be resolved using X-ray diffraction, and their chemical formula can be precisely determinated from mass spectroscopy. However, a complete structure characterizatio ...

Wiley-VCH Verlag GmbH2022

Factors affecting the reactivity of slag at early and late ages

Mohsen Ben Haha, Karen Scrivener, Yosra Briki

This study investigates the difference between the reactivity of slag in NaOH solution (w/s = 100) and in cement paste (w/b = 0.4). The reactivity of slag is much higher in NaOH solution than in cement paste. When the NaOH solution is saturated with portla ...

Pergamon-Elsevier Science Ltd2021

In-line electronic and structural characterization of reactively sputtered Cu-Co-Mn black spinel oxides

Andreas Schueler, Anna Krammer, Maxime Lagier

Cu-Co-Mn spinel oxide thin films are deposited by reactive magnetron sputtering. The x-ray diffraction (XRD) spectrum suggests a nanocrystalline spinel film when sputtered at approximate to 465 degrees C. In-line scanning tunneling microscopy confirms nano ...

A V S AMER INST PHYSICS2021

Characterization of untransformed ferrite in 10Cr and 12Cr ODS steels

Roland Logé

Two new ferrito-martensitic oxide dispersion strengthened (ODS) steels reinforced with (Y, Ti, O) nanoparticles were elaborated using a high-energy attritor. The milled powder was consolidated by hot extrusion at 1050 degrees C. The two types of ODS steels ...

ELSEVIER SCI LTD2021

Microstructural Evolution Study of Fe-Mn-Al-C Steels Through Variable Thermomechanical Treatments

Roland Logé, Oscar Zambrano Zambrano

The microstructural evolution of the two austenitic alloys Fe-20Mn-3Al-0.7C wt pct and Fe-20Mn-6Al-0.7C wt pct when different thermal and thermomechanical treatments are performed has been studied. To this end, a generic industrial die of 100 ton capacity ...

SPRINGER2021

Strength-promoting mechanism of alkanolamines on limestone-calcined clay cement and the role of sulfate

Karen Scrivener, François Henri Avet, Wilasinee Hanpongpun, Xuerun Li, Hong Huang

This paper reports the strength-promoting mechanism of alkanolamines on limestone-calcined clay cement (LC3). The hydration kinetics, phase formation and microstructure of LC3 with triethanolamine (TEA) or triisopropanolamine (TIPA) were investigated. TEA ...

Pergamon-Elsevier Science Ltd2021

Hydration development and thermal performance of calcium sulphoaluminate cements containing microencapsulated phase change materials

Diana Londoño Zuluaga

Microencapsulated phase change materials (MPCM) incorporated in buildings walls can reduce indoor temperature fluctuations, conserving energy and enhancing thermal comfort. MPCM were incorporated in calcium sulphoaluminate cement (CSA) at high concentratio ...

Pergamon-Elsevier Science Ltd2020

Young's modulus and creep of calcium-silicate-hydrate compacts measured by microindentation

Karen Scrivener, Pietro Lura, Zhangli Hu

In this paper, compacts of synthetic calcium silicate hydrate (C-S-H) with 0.8-1.5 calcium-to-silicon ratio (Ca/Si) and 30-80% porosity were prepared by one-direction cold pressing. The Young's modulus and the creep of C-S-H compacts were measured by micro ...

Pergamon-Elsevier Science Ltd2020

Characterization of interfacial transition zone in concrete prepared with carbonated modeled recycled concrete aggregates

Karen Scrivener

Treatment by accelerated carbonation has been widely studied to enhance the quality of recycled concrete aggregates (RCA) and hence the performance of new concrete produced with the RCA. This is often ascribed to the densification of RCA. This study invest ...

Pergamon-Elsevier Science Ltd2020

Limestone calcined clay cements (LC3): raw material processing, sulfate balance and hydration kinetics

Franco Alberto Zunino Sommariva

Limestone calcined clay cements (LC3) are blended cements that combine clinker, limestone, calcined clay and gypsum. The availability of the materials required to produce LC3 and the good performance that it achieves, makes LC3 suitable as a sustainable re ...

EPFL2020