Publications associées à Multilevel Modular DC/DC Converter for Regenerative Braking Using Supercapacitors

Ripple Voltage and Loss Reduction of Single-Phase ISOP SST by Eliminating the Second Harmonic Current in LLC Converters

Drazen Dujic, Tianyu Wei, Andrea Cervone

In two-stage solid-state transformers with input-series output-parallel structure, the LLC converter operating at a fixed switching frequency is a common choice for the isolated DC/DC conversion stage because it can provide a high efficiency and a fixed vo ...

2024

Active Voltage Balancing with Seamless Integration into Dual Gate Driver for Series Connection of SiC MOSFETs

Drazen Dujic

The versatility of half-bridge configuration of silicon carbide (SiC) metal-oxide-semiconductor field-effect transistor (MOSFET) power module contributes to its widespread adoption, highlighting the popularity and significance of its corresponding dual gat ...

2024

Modeling and optimization of PCB coils for inductive power transfer systems

Xiaotong Du

The auxiliary power supply for medium voltage converters requires high insulation capability between the source and the load. Inductive power transfer technology, with an air gap between the primary and secondary coil, offers such high insulation capabilit ...

EPFL2024

Performance Comparison of Cables With Partial Transposition

Pierluigi Bruzzone, Kamil Sedlák, Chiara Frittitta, Federica Demattè

The need of full transposition of the current carrying elements (strands) in large cables is frequently retained as top design criterion for conductors operating in pulsed mode. However, when the transposition error, i.e., the inductance difference among t ...

IEEE Institute of Electrical and Electronics Engineers2024

Phase Shift Angle Segmentation Modulation for Soft-Switching Medium-Voltage DAB Converter With Series-Connected SiC MOSFETs

Heng Fang, Rui Lu, Chengmin Li

The medium-voltage (MV) dual active bridge (DAB) converter with series-connected SiC (S-SiC) MOSFETs is a promising solution for high-power-density isolated dc/dc converter. To improve the voltage sharing and reliability of S-SiC, relatively large snubber ...

Ieee-Inst Electrical Electronics Engineers Inc2024

Stability Analysis of Input-Series/Output-Parallel Solid-State Transformers Equipped with Second-Order Harmonic Active Power Filters

Drazen Dujic, Tianyu Wei, Andrea Cervone

Solid-State Transformers with Input-Series/Output-Parallel configuration offer a convenient solution for AC/DC conversion due to their scalability and modularity. In this configuration, each module experiences a second-order harmonic ripple caused by local ...

2024

An Ultralow-Power Triaxial MEMS Accelerometer With High-Voltage Biasing and Electrostatic Mismatch Compensation

Yimai Peng, Li Xu, Kyojin Choo

This article presents a triaxial micro electromechani-cal system (MEMS) capacitive accelerometer using a high-voltage biasing technique to achieve high resolution with ultralow power. The accelerometer system generates a differential pair of high voltages ...

Ieee-Inst Electrical Electronics Engineers Inc2024

Active Power Decoupling for Single-Phase Input-Series-Output-Parallel Solid-State Transformers

Drazen Dujic, Tianyu Wei, Andrea Cervone

Solid-state transformers with input-series outputparallel structures are being considered for a variety of applications requiring MVAC to LVDC conversion. Due to the singlephase AC/DC conversion at the input side, all floating cells of the solid-state tran ...

2024

A Dual-Channel Gate Driver Design with Active Voltage Balancing Circuit for Series Connection of SiC MOSFETs

Drazen Dujic

Dual-channel gate driver is commonly utilized in the industry for accommodating the widespread use of half-bridge power modules. As wide-bandgap devices become increasingly prevalent due to their superior switching characteristics compared with conventiona ...

2024

Power Aware Placement of On-Chip Voltage Regulators

Rassul Bairamkulov

In traditional power delivery networks, the on-chip supply voltage is provided by board-level converters. Due to the significant distance between the converter and the load, variations in the load current are not effectively managed, producing a significan ...

Ieee-Inst Electrical Electronics Engineers Inc2024

Stability Analysis of Second-Order Harmonic Active Filters for Input-Series/Output- Parallel Solid State Transformers

Drazen Dujic, Tianyu Wei, Andrea Cervone

Solid-State Transformers with Input-Series/Output- Parallel configuration offer a convenient solution for AC/DC power conversion, thanks to their modularity, scalability and flexibility. However, as known, they are affected by a second-order harmonic rippl ...

2024

SPAD Developed in 55 nm Bipolar-CMOS-DMOS Technology Achieving Near 90% Peak PDP

Claudio Bruschini, Edoardo Charbon, Francesco Gramuglia, Myung Jae Lee, Ekin Kizilkan, Pouyan Keshavarzian, Won Yong Ha

We present a single-photon avalanche diode (SPAD) developed in 55 nm bipolar-CMOS-DMOS (BCD) technology, which achieves high photon detection probability (PDP) while its breakdown voltage is lower than 20 V. To enhance the PDP performance, the SPAD junctio ...

Ieee-Inst Electrical Electronics Engineers Inc2024

DC Power Distribution Networks with Direct Current Transformers

Renan Pillon Barcelos

The shift towards DC power distribution networks, enabled by power electronics technologies, is changing the nature of electrical power systems. Nowadays, DC power distribution networks can effectively support the high penetration of distributed energy res ...

EPFL2024

Study of flexible operating conditions in variable-speed hydraulic turbines : advanced models and experimental validation

Martin Seydoux

The global imperative to transition from fossil fuel-based energy sources to renewable alternatives has become increasingly urgent in the pursuit of sustainable and renewable power generation. This paradigm shift necessitates innovative approaches to manag ...

EPFL2024

Polarization-enhanced GaN Schottky barrier diodes: Ultra-thin InGaN for high breakdown voltage and low Ron

Elison de Nazareth Matioli, Alessandro Floriduz, Zheng Hao

In this work, we present a concept that leverages the strong piezoelectric polarization field in InGaN, which counteracts the external electric field at reverse bias. We show that despite the smaller InGaN band-gap and lower critical electric field, its st ...

2024

A Two-Wired High Input Impedance and High CMRR Active Electrode Insensitive to Component Mismatch

Alexandre Schmid, Mehdi Saberi

This article proposes a new two-wired amplifying active electrode (AE), presenting a high input impedance and a high common-mode rejection ratio (CMRR). In the proposed structure, the input impedance and the CMRR of the system are considerably increased by ...

Ieee-Inst Electrical Electronics Engineers Inc2024

Tension-tension fatigue behavior of basalt composite hybrid joints

Thomas Keller, Lulu Liu, Xin Wang

The tension–tension fatigue behavior of pseudo-ductile hybrid bonded-bolted double lap basalt composite joints, composed of pseudo-ductile adhesives and adherends with multi-directional fiber architecture, was experimentally investigated. The fatigue damag ...

2024

Hybrid Simulator for Capturing Dynamics of Synthetic Populations

Michel Bierlaire, Marija Kukic

This paper presents a novel hybrid framework for generating and updating a synthetic population. We call it hybrid because it combines model-based and data-driven approaches. Existing generators produce a snapshot of synthetic data that becomes outdated ov ...

IEEE2024

Analytical Computation of the Sensitivity Coefficients in Hybrid AC/DC Networks

Mario Paolone, Willem Lambrichts

In this paper, we present a model for the analytical computation of the power flow sensitivity coefficients (SCs) for hybrid AC/DC networks. The SCs are defined as the partial derivates of the nodal voltages with respect to the active and reactive power in ...

2024

General and Unified Model of the Power Flow Problem in Multiterminal AC/DC Networks

Mario Paolone, Willem Lambrichts

This paper proposes a generic and unified model of the power flow (PF) problem for multiterminal hybrid AC/DC networks. The proposed model is an extension of the standard AC-PF. The DC network is treated as an AC one and, in addition to the Slack, PV and P ...

IEEE Institute of Electrical and Electronics Engineers2024