Publications associées à Towards realization of an Energy Internet: Designing distributed energy systems using game-theoretic approach

Publications associées (27)

Soliton Generation in a Gallium Phosphide Photonic-Crystal Fabry-Perot Microresonator

Tobias Kippenberg, Johann Emmeram Riemensberger, Miles Henry Anderson, Nikolai Kuznetsov, Alisa Davydova, Alberto Nardi

Ring resonators have proven to be extremely successful for generation of temporal dissipative Kerr solitons, but their dispersion engineering is limited. We present a photonic-crystal Fabry-Perot resonator with record-high quality factors in gallium phosph ...

IEEE2023

Single-Band Raman Shift Detection for Spectroscopy-Less Optical Biosensors

Sandro Carrara, Ata Jedari Golparvar

The application of Raman scattering in biosensing diverges significantly from its previous usage in qualitative analysis, eliminating the necessity for spectroscopy in certain cases. Here, we push the frontiers of optical biosensing by integrating a custom ...

IEEE-INST ELECTRICAL ELECTRONICS ENGINEERS INC2023

Dynamic Hydrogel Design For Spatiotemporal Control Of Morphogenesis

Matthias Lütolf, Nicolas Antoine Vincent Broguiere, Antonius Chrisnandy

MARY ANN LIEBERT, INC2023

Current Status of PRP Manufacturing Requirements & European Regulatory Frameworks: Practical Tools for the Appropriate Implementation of PRP Therapies in Musculoskeletal Regenerative Medicine

Philippe Abdel Sayed

Providing accurate and up-to-date practical tools enabling oversight of platelet-rich plasma (PRP) legislation and of the appropriate standards to be implemented for its manufacture and use in Europe is a demanding task. This is due to rapid medico-technol ...

MDPI2023

Expansion Work Recovery of Hydrogen for a FC-Truck-Tentative Design of an Expansion Machine

Alfred Rufer

Hydrogen powered vehicles use high-pressure reservoirs from which the gas is transferred to the low-pressure fuel-cell via a classical pressure reduction valve. In these systems no expansion work is recovered and the question is addressed of the potential ...

MDPI2023

Influence of Different Sterilization Methods on the Surface Chemistry and Electrochemical Behavior of Biomedical Alloys

Stefano Mischler, Brigitte Jolles-Haeberli, Anna Neus Igual Muñoz

Sterilization is a prerequisite for biomedical devices before contacting the human body. It guarantees the lack of infection by eliminating microorganisms (i.e., bacteria, spores and fungi). It constitutes the last fabrication process of a biomedical devic ...

2023

Experimental investigations of a new highly ductile hold-down with adaptive stiffness for timber seismic bracing walls

Pierino Lestuzzi

An efficient implementation of the capacity design requires high ductility combined with a low overstrength of the critical regions. Conventional timber connections do not generally offer such ideal combination, resulting in modest behaviour and relatively ...

SPRINGER2023

Efficacy of temporal and spatial abstraction for training accurate machine learning models: A case study in smart thermostats

Rachid Guerraoui, Alexandre David Olivier Maurer

Smart thermostats are increasingly popular in homes and buildings as they improve occupant comfort, lower energy use in heating and cooling systems, and reduce utility bills by automatically adjusting room temperature according to measurements of their bui ...

ELSEVIER SCIENCE SA2023

Sub-kHz-Linewidth External-Cavity Laser (ECL) With Si3N4 Resonator Used as a Tunable Pump for a Kerr Frequency Comb

Tobias Kippenberg, Junqiu Liu

Combining optical gain in direct-bandgap III-V materials with tunable optical feedback offered by advanced photonic integrated circuits is key to chip-scale external-cavity lasers (ECL), offering wideband tunability along with low optical linewidths. Exter ...

IEEE Institute of Electrical and Electronics Engineers2023

A Virtual Simulation-Pilot Agent for Training of Air Traffic Controllers

Petr Motlicek, Juan Pablo Zuluaga Gomez

In this paper we propose a novel virtual simulation-pilot engine for speeding up air traffic controller (ATCo) training by integrating different state-of-the-art artificial intelligence (AI)-based tools. The virtual simulation-pilot engine receives spoken ...

MDPI2023

Amperometric Measurements by a Novel Aerosol Jet Printed Flexible Sensor for Wearable Applications

Sandro Carrara, Sarah Tonello

the last years, increasing interest has been addressed on wearable devices for the continuous monitoring of biochemical profiles of patients and athletes. Among various markers, lactate represents one of the most interesting to deepen the knowledge on fati ...

IEEE-INST ELECTRICAL ELECTRONICS ENGINEERS INC2023

Design of a Tap-Amplitude-Based Block Proportional Adaptive Filtering Algorithm

Ali H. Sayed

Proportional-type algorithms have attracted much attention because of their fast convergence ability for sparse system identification. To overcome the drawbacks of existing block proportional methods stemming from inadequate block partitioning, this articl ...

IEEE-INST ELECTRICAL ELECTRONICS ENGINEERS INC2023

Experimental investigation of two-dimensional Mode-II delamination in composite laminates

Thomas Keller, Anastasios Vassilopoulos, Congzhe Wang

The two-dimensional (2D) delamination growth in composite laminates under the Mode-II fracture condition was experimentally investigated using a novel set-up. Circular plate specimens with a centrally embedded pre-crack of two sizes were semi-clamped along ...

2023

Going Below 50% Clinker Factor in Limestone Calcined Clay Cements (LC3): A Comparison with Pozzolanic Cements from the South American Market

Karen Scrivener, Franco Alberto Zunino Sommariva

Limestone calcined clays are a promising technology as they offer similar performance to OPC from 7 days onwards, while enabling a reduction of the clinker content of 50%. In some regions of the world like South America, pozzolanic cements (i.e., blended c ...

SPRINGER INTERNATIONAL PUBLISHING AG2023

Embryo-uterine interaction coordinates mouse embryogenesis during implantation

Matthias Lütolf, Saba Rezakhani, Mikhail Nikolaev

Embryo implantation into the uterus marks a key transition in mammalian development. In mice, implantation is mediated by the trophoblast and is accompanied by a morphological transition from the blastocyst to the egg cylinder. However, the roles of tropho ...

WILEY2023

Evaluation of the role of superoxide radical as chain carrier for the formation of hydroxyl radical during ozonation

Urs von Gunten, Gang Yu

Superoxide radicals (O-2(center dot-)) have been suggested as an important chain carrier in the radical chain reaction that promotes ozone (O-3) decomposition to hydroxyl radicals ((OH)-O-center dot) during ozonation. However, due to the difficulty in meas ...

PERGAMON-ELSEVIER SCIENCE LTD2023

Dif-MAML: Decentralized Multi-Agent Meta-Learning

Ali H. Sayed, Stefan Vlaski, Mert Kayaalp

The objective of meta-learning is to exploit knowledge obtained from observed tasks to improve adaptation to unseen tasks. Meta-learners are able to generalize better when they are trained with a larger number of observed tasks and with a larger amount of ...

IEEE-INST ELECTRICAL ELECTRONICS ENGINEERS INC2022

Multichannel Smart Slit Assembly For Spectroscopy Based On Arrays Of Variable Optical Mems Attenuators

Niels Quack, Anton Lagosh

We present design, fabrication and experimental characterization of a multichannel Smart Slit Assembly for next generation spectrometers, based on an array of 40 variable optical attenuators employing MEMS shutters integrated with large core multimode rect ...

IEEE2022

Optimal Thrust Vector Control of an Electric Small-Scale Rocket Prototype

Albéric Antoine Marie Louis Joseph Dufaure de Lajarte, Colin Neil Jones, Petr Listov, Roland Schwan

Recent advances in Model Predictive Control (MPC) algorithms and methodologies, combined with the surge of computational power of available embedded platforms, allows the use of real-time optimization-based control of fast mechatronic systems. This paper p ...

IEEE2022

Influence of sustained loading on resistance and deformation capacity of reinforced concrete members in compression

Aurelio Muttoni, Miguel Fernández Ruiz, Xhemsi Malja

As acknowledged explicitly or implicitly in most of current design codes, a high level of sustained loading has a detrimental effect on the concrete compressive strength. However, its beneficial effect in terms of deformation capacity is neglected in most ...

ERNST & SOHN2022