Plunging Circular Jets: Experimental Characterization of Dynamic Pressures Near the Stagnation Zone

À propos
Confidentialité
Mentions légales

Graph Chatbot

Publications associées (27)

Fault's hydraulic diffusivity enhancement during injection induced fault reactivation: application of pore pressure diffusion inversions to laboratory injection experiments

François Xavier Thibault Passelègue

In situ observations of fluid induced fault slip reactivation, as well as the analysis of induced seismicity have demonstrated the complexity of fluid-fault interactions under geological conditions. If fluid flow commonly reactivates faults in the form of ...

OXFORD UNIV PRESS2020

Swirl number based transposition of flow-induced mechanical stresses from reduced scale to full-size Francis turbine runners

François Avellan, Christian Landry, Joao Gomes Pereira Junior, Arthur Tristan Favrel, Keita Yamamoto

At part load conditions, Francis turbines are subject to the emergence of a hydrodynamic instability in their draft tube, referred to as precessing vortex rope. It induces pressure pulsations in the water passages at the precession frequency of the vortex, ...

2020

Mechanical and hydraulic transport properties of transverse-isotropic Gneiss deformed under deep reservoir stress and pressure conditions

Marie Estelle Solange Violay, Mateo Alejandro Acosta

In central Europe, many geo-energy reservoirs have revealed to be hosted in transverse isotropic crystalline rock, where the rock's mechanical and hydraulic transport properties are poorly constrained. Here, we performed triaxial experiments on Cresciano G ...

2020

Bottom pressure characteristics in a stilling basin downstream of a stepped spillway for two different chute slopes

Anton Schleiss, José Pedro Gamito de Saldanha Calado Matos, Michael Pfister, Ivan Stojnic

In the last decades numerous stepped spillways were built, mostly on the downstream face of roller compacted concrete (RCC) dams. Stilling basins are often used as an energy dissipater. Although the hydraulics of stepped chutes was extensively investigated ...

The University of Queensland2020

Mechanical behaviour of fluid lubricated faults during earthquake nucleation and propagation

Chiara Cornelio

The need for new forms of energy, and in particular the need for renewable and clean ones, led to develompment of Enanched Geothermal Systems, where the well designed stimulation of a geothermal reservoir is the key parameter for the safe development of th ...

EPFL2020

Evaluation of a Dynamic Transfer Matrix for a Hydraulic Turbine

François Avellan, Andres Müller, Keita Yamamoto

It is well known that hydraulic machines experience various types of flow instabilities causing a negative influence on the system under off-design operations. The transfer matrix method correlating the flow properties in upstream and downstream of hydraul ...

2020

Scale limitations of gas bearing supported turbocompressors for vapor compression cycles

Jürg Alexander Schiffmann

An analysis of single-stage centrifugal compressors supported on dynamic, gas lubricated bearings for driving vapor compression cycles suggests that the maximum feasible compressor power is limited, primarily by the bearing load capacity, in the range from ...

2020

Page 2 sur 2