Publications associées à Modeling Nucleation and Growth of Zinc Grains in Hot-Dip Galvanized Coatings

Artificial Hydrophilic Organic and Dendrite-Suppressed Inorganic Hybrid Solid Electrolyte Interface Layer for Highly Stable Zinc Anodes

Aqueous zinc-ion batteries (AZIBs) have gained significant attentions for their inherent safety and cost-effectiveness. However, challenges, such as dendrite growth and anodic corrosion at the Zn anode, hinder their commercial viability. In this paper, an ...

Amer Chemical Soc2024

Electrochemical Hydrophobic Tri-layer Interface Rendered Mechanically Graded Solid Electrolyte Interface for Stable Zinc Metal Anode

Lei Zhang, Kangning Zhao

The aqueous zinc-ion battery is promising as grid scale energy storage device, but hindered by the instable electrode/electrolyte interface. Herein, we report the lean-water ionic liquid electrolyte for aqueous zinc metal batteries. The lean-water ionic li ...

Wiley-VCH Verlag GmbH2024

Well-Defined Ti Surface Sites in Ziegler-Natta Pre-Catalysts from 47/49Ti Solid-State Nuclear Magnetic Resonance Spectroscopy

Pierrick Berruyer

Treatment of Ziegler-Natta (ZN) catalysts with BCl3 improves their activity by increasing the number of active sites. Here we show how Ti-47/49 solid-state nuclear magnetic resonance (NMR) spectroscopy enables us to understand the electronic structure of t ...

Amer Chemical Soc2024

Spinel Protective Coatings for Solid Oxide Cell (SOC) Interconnects (ICs)

Samaneh Daviran

Abstract The degradation of metal interconnects (ICs) in Solid Oxide Cells (SOCs) primarily results from chromium (Cr) oxide scale growth on stainless-steel substrates, causing ohmic loss and air-side electrode poisoning by Cr. This thesis addresses these ...

EPFL2024

A colloidal aqueous electrolyte modulated by oleic acid for durable zinc metal anode

Di Yang, Kangning Zhao, Xu Zhang

Continuous dendrites growth, as well as corrosion and side reactions of Zn metal anode seriously hinder the development of aqueous zinc ion batteries. To address these issues, oleic acid (OA) is dispersed into a 2 M ZnSO4 solution to form a novel colloidal ...

ELSEVIER SCIENCE SA2023

Simple shear extrusion versus equal channel angular pressing: A comparative study on the microstructure and mechanical properties of an Mg alloy

Cyril Cayron, Roland Logé, Aryan Rezaei Rad

Two severe plastic deformation (SPD) techniques of simple shear extrusion (SSE) and equal channel angular pressing (ECAP) were employed to process an extruded Mg -6Gd -3Y -1.5Ag (wt%) alloy at 553 K for 1, 2, 4 and 6 passes. The microstructural evolutions ...

KEAI PUBLISHING LTD2023

Origin of the enhanced pseudo-elasticity of additively manufactured Fe-17Mn-5Si-4Ni-10Cr-(V, C) shape memory alloy fabricated by laser powder bed fusion

Christian Leinenbach, Irene Ferretto

This study investigated the origin of the enhanced pseudo-elasticity of additively manufactured vanadium carbide-containing Fe-based shape memory alloys. The aged samples with two different starting microstructures, as-built and solution-treated, showed co ...

Elsevier Science Sa2023

Microstructure et usinabilité d'alliages de titane béta-métastable

Loïc Favre

Titanium has become in recent years an interesting material in many applications that require a combination of high mechanical properties and low density. It has the peculiarity of undergoing an allotropic transformation at 882°C. Below this temperature, ...

EPFL2023

Vacancy segregation and intrinsic coordination defects at (111) twist grain boundaries in diamond

Christian Brandl, Carolina Baruffi

High radiation damage resistance has become increasingly important for applications of functional materials in harsh environments. The high radiation damage resistance diamond cubic carbon is a unique material which is considered for radiation environments ...

Pergamon-Elsevier Science Ltd2023

Ion Selective and Water Resistant Cellulose Nanofiber/MXene Membrane Enabled Cycling Zn Anode at High Currents

Kangning Zhao

Aqueous rechargeable zinc ion batteries (ZIBs) are regarded as a promising candidates for next-generation energy storage devices but strongly hindered by the limited utilization of the zinc metal anode (below 5%) due to the active water/anion corrosion. He ...

WILEY-V C H VERLAG GMBH2023

In-vivo investigation of electrochemical behavior of Ti and CoCrMo alloy in human synovial fluids

Yueyue Bao

With the development of modern medical techniques, the application of orthopedic implants has been continually increasing in recent years. Passive materials, such as Ti and its alloys as well as CoCrMo alloys, are widely used in artificial joints due to th ...

EPFL2023

The influence of lattice misfit on screw and edge dislocation-controlled solid solution strengthening in Mo-Ti alloys

William Curtin, Carolina Baruffi, You Rao

Mo-Ti alloys form solid solutions over a wide range of compositions, with lattice misfit parameters increasing significantly with titanium content. This indicates a strong increase in the critical stress for edge dislocation motion. Here, we probe the tran ...

SPRINGERNATURE2023

A water-gating and zinc-sieving lignocellulose nanofiber separator for dendrite-free rechargeable aqueous zinc ion battery

Kangning Zhao, Xu Zhang, Zequan Li

The sustainable development of rechargeable aqueous zinc-ion batteries (RZIBs) is severely limited by the uncontrolled zinc dendritic growth and side reactions on the anode. Herein, a lignocellulose nanofiber (LCNF) separator from waste palm with dual-func ...

ELSEVIER SCIENCE SA2023

Rapid grain boundary diffusion in foraminifera tests biases paleotemperature records

Lukas Baumgartner, Anders Meibom, Jaroslaw Hubert Stolarski, Arthur Adams, Deyanira Graciela Cisneros Lazaro, Jinming Guo

The paleoseawater temperature record from the oxygen isotope compositions of fossil foraminifera tests may be biased by up to about 1 degrees C due to grain-boundary diffusion alone, according to isotope exchange experiments on foraminifera tests. The oxyg ...

2023

Ionic Liquid Gating of SrTiO3 Lamellas Fabricated with a Focused Ion Beam

Evgeny Mikheev, Amelia Emily-Kay Estry, Philip Johannes Walter Moll

In this work, we combine two previously incompatible techniques for defining electronic devices: shaping three-dimensional crystals by focused ion beam (FIB), and two-dimensional electrostatic accumulation of charge carriers. The principal challenge for th ...

AMER CHEMICAL SOC2022

Processability, microstructure and precipitation of a Zr-modified 2618 aluminium alloy fabricated by laser powder bed fusion

Christian Leinenbach, Xavier Maeder

Additive manufacturing offers the opportunity to produce complex geometries from novel alloys with improved properties. Adapting conventional alloys to the process-specific properties can facilitate rapid implementation of these materials in industrial pra ...

2022

Effect of Y2O3 dispersoids on microstructure and creep properties of Hastelloy X processed by laser powder-bed fusion

Christian Leinenbach

Laser powder bed fusion (LPBF) was used to consolidate powders of a Ni-Cr-Fe-Mo alloy (Hastelloy X) blended with 1 wt% Y2O3 nanometric powders. The nearly-dense, crack-free specimens, with and without oxide dispersion strengthening (ODS), exhibit high-aspe ...

ELSEVIER2022

Synergic Effect of Dendrite-Free and Zinc Gating in Lignin-Containing Cellulose Nanofibers-MXene Layer Enabling Long-Cycle-Life Zinc Metal Batteries

Kangning Zhao, Xu Zhang, Zequan Li

Uncontrollable zinc dendrite growth and parasitic reactions have greatly hindered the development of high energy and long life rechargeable aqueous zinc-ion batteries. Herein, the synergic effect of a bifunctional lignin-containing cellulose nanofiber (LCN ...

WILEY2022

Three-dimensional in situ imaging of single-grain growth in polycrystalline In2O3:Zr films

Quentin Thomas Jeangros, Michael Elias Stückelberger, Monica Morales Masis

Understanding grain morphology and kinetics of solid-phase crystallization is important for controlling the functional properties of polycrystalline materials. Here, in situ coherent X-ray diffraction imaging and transmission electron microscopy elucidate ...

SPRINGERNATURE2022

Influence of depositional fabric on mechanical properties of naturally deposited sands

Gioacchino Viggiani, Edward Carlo Giorgio Andò

Fabric characteristics and shear deformation behaviour were analysed in four intact small-scale samples, including two disturbed and two undisturbed samples of naturally deposited sand from a shoal in the San Francisco Bay. Triaxial compression tests were ...

ICE PUBLISHING2022