Publications associées à Flow boiling in horizontal flattened tubes: Part I – Two-phase frictional pressure drop results and model

Plasmoid drift and first wall heat deposition during ITER H-mode dual-SPIs in JOREK simulations

The heat flux mitigation during the thermal quench (TQ) by the shattered pellet injection (SPI) is one of the major elements of disruption mitigation strategy for ITER. It's efficiency greatly depends on the SPI and the target plasma parameters, and is ult ...

IOP Publishing Ltd2024

Computational fluid dynamics simulations of the heat transfer properties of graphene-based nanolubricants and application to hydrodynamic lubrication

Roberto Guarino

In this paper, we consider experimental data available for graphene-based nanolubricants to evaluate their convective heat transfer performance by means of computational fluid dynamics (CFD) simulations. Single-phase models with temperature-dependent prope ...

Aip Publishing2024

Gyrokinetic turbulence modeling of a high performance scenario in JT-60SA

Stephan Brunner, Stefano Coda, Aylwin Iantchenko

Local gyrokinetic simulations are used to model turbulent transport for the first time in a representative high-performance plasma discharge projected for the new JT-60SA tokamak. The discharge features a double-null separatrix, 41 MW of combined neutral b ...

IOP Publishing Ltd2024

Mean-field transport equations and energy theorem for plasma edge turbulent transport

Reinart Andreas J. Coosemans

This paper establishes a mean-field equation set and an energy theorem to provide a theoretical basis in view of the development of self-consistent, physics-based turbulent transport models for mean-field transport codes. A rigorous averaging procedure ide ...

Cambridge University Press2024

Turbulence and Heat exchange in the Near-Surface Boundary Layer over Patchy Snow

Michael Haugeneder

The atmospheric layer adjacent to the earth's surface is of crucial importance for weather models due to the exchange of energy between the surface and the atmosphere. This exchange is dependent on the various surface properties and influences the state of ...

EPFL2024

Design and assessment of an evaporating water-cooled methanation reactor for a SOE-based power-to-methane system

Philippe Aubin

The transition towards clean renewable energy sources, where wind and solar are prone to variation, requires adequate energy storage. Power-to-methane (PtM) systems can be part of the solution. Specifically, solid-oxide-electrolyser (SOE) based PtM systems ...

EPFL2024

Decomposition method to evaluate district heating/cooling network potential at urban scale

Luc Girardin, François Maréchal, Raphaël Briguet, Ana Catarina Gouveia Braz, Bingqian Liu

In this work, a tool to design district heating networks (DHN) is presented and applied to the city of Lausanne as a case study. The evaluation of the buildings’ heat/cooling demand is performed using a Geographic Information System (GIS) database, built f ...

Associazione Italiana Di Ingegneria Chimica2024

Thermal conductivity of Li 3 PS 4 solid electrolytes with ab initio accuracy

Michele Ceriotti, Federico Grasselli

The vast amount of computational studies on electrical conduction in solid-state electrolytes is not mirrored by comparable efforts addressing thermal conduction, which has been scarcely investigated despite its relevance to thermal management and (over)he ...

Amer Physical Soc2024

Heat transfer of uncoated and nanostructure coated commercially micro-enhanced refrigeration tubes under pool boiling conditions

John Richard Thome

The heat transfer performance of commercially produced micro-enhanced tubes with and without a nanocoating was investigated under pool boiling of saturated refrigerant. These multiscale enhancements were on the outside of 19 mm horizontal copper tubes heat ...

Pergamon-Elsevier Science Ltd2023

Multiscale enhancement of refrigerant falling film boiling by combining commercially enhanced tubes with nanostructures

John Richard Thome

Multiscale surface structures offer the opportunity to combine the heat transfer enhancement provided by microscale structures with the dryout benefits provided by some nanostructures, which is particularly attractive for falling film evaporators, who have ...

Pergamon-Elsevier Science Ltd2023

Experimental study of the hydrodynamic and thermal performances of ventilated wall structures

Mohammad Rahiminejad, Dolaana Khovalyg

The presence of a ventilated air gap behind the external cladding in a building envelope is known to have a tangible contribution to the overall performance of the wall assembly. In the present study, the hydrodynamic and thermal performances of ventilated ...

2023

Extension of GeN-Foam to departure from nucleate boiling prediction and validation against the OECD/NRC PSBT benchmark

Alessandro Scolaro, Carlo Fiorina, Hao Qin, Yuhang Niu

The prediction of departure from nucleate boiling (DNB) has always been a crucial aspect of thermal-hydraulic codes for the analysis of Light Water Reactors. In this paper, GeN-Foam, a multi-physics code developed based on OpenFOAM, has been enhanced to in ...

Elsevier Science Sa2023

Small-scale turbopumps for waste heat recovery applications based on an organic Rankine cycle: a study from pre-design to experimental validation

Sajjad Zakeralhoseini

The organic Rankine cycle (ORC) system is among the technologies applied to exploit waste heat in vehicles. Since common organic fluids have lower latent heat than water, higher mass flow rates are required to convert the same waste heat, considerably incr ...

EPFL2023

Improved Waste Heat Management and Energy Integration in an Aluminum Annealing Continuous Furnace Using a Machine Learning Approach

François Maréchal, Manuele Gatti, Daniel Alexander Florez Orrego, Réginald Germanier, Mohammad Andayesh

Annealing furnaces are critical for achieving the desired material properties in the production of high-quality aluminum products. In addition, energy efficiency has become more and more important in industrial processes due to increasing decarbonization r ...

2023

Beam radiation penetration in particle b e ds for heat transfer modeling of a centrifugal solar particle receiver

Serdar Hiçdurmaz, Evan Fair Johnson

This article describes a study of beam radiation striking particle beds of randomly packed, spherical par-ticles. The current study is focused on concentrating solar power receivers which use solid particles as a heat transfer medium, but results are appli ...

PERGAMON-ELSEVIER SCIENCE LTD2023

Radiation-tolerant Multichannel Dew Point Temperature Monitoring System for High Energy Physics Applications

Amar Kapic

The next generation of high-energy physics (HEP) detectors will predominantly be silicon-based. As pixel sensor technology gains momentum and the number of channels surpasses one billion (for a volume of approximately 20 m3) to achieve the high resolution ...

EPFL2023

The influence of the gas on the dynamics of cavitation bubbles

Davide Bernardo Preso

Cavitation bubbles, extensively investigated in fluid mechanics, present enduring challenges in hydraulic machinery, while holding considerable potential for practical applications in biomedicine and sonochemistry. Despite more than a century of research, ...

EPFL2023

Measurement and modelling of dynamic fluid saturation in carbon reinforcements

Véronique Michaud, Baris Çaglar, Helena Luisa Teixido Pedarros, Guillaume Clément Broggi

We propose a methodology to monitor the progressive saturation of a non-translucent unidirectional carbon fabric stack through its thickness by means of X-ray radiography and extract the dynamic saturation curves using image analysis. Four constant flow ra ...

2023

Mitochondrial matrix protein LETMD1 maintains thermogenic capacity of brown adipose tissue in male mice

Johan Auwerx, Maroun Bou Sleiman, Jun Yong Kim, Xiaoxu Li

Brown adipose tissue (BAT) has abundant mitochondria with the unique capability of generating heat via uncoupled respiration. Here, Park et al. identify LETMD1 as a mitochondrial matrix protein enriched in brown adipose tissue (BAT) and reveal a crucial ro ...

Nature Portfolio2023

Extension of GeN-Foam to modeling of boiling water and validation against the OECD/NRC PSBT benchmark

Stefan Radman, Carlo Fiorina, Ran Zhang, Hao Qin

The OpenFOAM-based GeN-Foam solver has recently been extended to allow simulating water boiling based on a porous-medium approach. This paper describes such extension and preliminarily validates it based on the OECD/NRC PSBT benchmark. Three benchmark exer ...

ELSEVIER SCIENCE SA2023