Simulation of atmospheric flows over complex terrain for wind power potential assessment

When assessing the economic viability of a wind farm, the estimation of the on-site wind power potential is perhaps the most important step. The most common way of evaluating the wind power potential of an area of interest consists of making on-site measurements for a period of one year. In order to take account of the inter-annual variation of wind speed, the one year of data are normally correlated with data recorded at a reference site where long-term data (typically > 10 years) are available. A correlation analysis is formulated for the concurrent data sets at the reference and prediction sites. This correlation is then used to transform the long-term wind speed at the reference site to the long-term wind speed that would have been expected at the prediction site had long-term measurements been made at this site. An alternative approach is also used, which consists of establishing site-to-site relationships using a numerical model to simulate meteorological situations which are typical for the area of interest. These relationships are then used to transpose the known long-term wind statistics of the reference site to the prediction site. Such an approach is applied in this work to the region of Chasseral & Mt-Crosin. The wind data available for a period of 16 years at Chasseral are transposed to the Mt-Crosin site where they are then compared to the data measured at the location of the installed wind farm. Over complex terrain, the linearised models traditionally used for wind power potential assessment fail to reproduce accurate wind fields. Therefore, to be applied to mountainous terrain such as that found in Switzerland, the approach relying on numerical simulation requires the development and validation of a numerical tool capable of simulating wind fields over complex topography. As the numerical model would have to deal with relatively steep slopes requiring a fine horizontal (50-100 m) and vertical resolution (∼5-10 m in the lowest levels), a fluid dynamics model was used which solves the complete set of Navier-Stokes equations with κ-ε turbulence closure. The standard version of the model used (CFX4) is modified in a novel way to extend its field of application so that atmospheric phenomena could be simulated which are typical of the meso-scale. The modified version solves the flow equations with the anelastic approximation (deep Boussinesq) and assuming a background rotation of the wind field (with the high altitude wind field following the geostrophic approximation). In the first part of this work, the numerical model is validated. The results obtained in this phase show that for meteorological situations for which the wind at the ground is coupled to the high altitude wind, the numerical model is able to satisfactorily reproduce: the flow in the surface layer, reproducing the effects associated with the ground roughness, roughness change, or heat flux through the ground; the flow in the Ekman layer together with the interaction bet