Impact of Microporous Layer Composition on the Water Content in the Membrane Electrode Assembly of Polymer Electrolyte Fuel Cells

Polymer electrolyte fuel cells are paramount for future emission-free mobility. One of the vital challenges for prospering commercialization of PEFCs is water management in the cells. A microporous layer (MPL) is typically positioned between the gas diffusion layer (GDL) and the catalyst layer (CL) to boost the cell performance and facilitate water management. In this study, three different MPLs were investigated, namely, carbon black-based MPLs with different PTFE binder contents (20 wt % PTFE as a base case and 40 wt % PTFE), as well as perforated MPLs with micron-sized pores coated on the same GDL-Substrate (Freudenberg H14). The water content in the membrane, catalyst layers (CL), and MPLs was explored using operando scanning small-and wide-angle X-ray scattering (S/WAXS). At T cell = 80 °C, relative humidity = 100%, p abs = 3 bar, the MPL with larger pores exhibits slightly higher performance than the base case, while a considerably lower cathode CL and MPL saturation levels were observed for the MPL. In contrast, the MPL with higher amounts of PTFE binder shows lower performance than the base case, with considerably higher cathode CL and MPL saturation levels. 3D representations of how the pores could be filled in the cathode CLs were obtained from operando SAXS profiles using representative structure modeling for the different materials and operating conditions.